小直径组合桩的波浪力实验分析

本文给出小直径孤立桩、两个桩和2×2个桩的波浪作用力实验结果。在波浪水槽中以0°,45°,90°三个波浪方向测量了各桩所受的纵向力和横向力,文中讨论了组合桩之间的干扰效应,给出了干扰系数随KC数和桩距的变化。     

Fast static correction methods for high-frequency multichannel marine seismic reflection data: A high-resolution seismic study of channel-levee systems on the Bengal Fan

Very high-frequency marine multichannel seismic reflection data generated by small-volume air- or waterguns allow detailed, high-resolution studies of sedimentary structures of the order of one to few metres wavelength. The high-frequency content, however, requires (1) a very exact knowledge of the source and receiver positions, and (2) the development of data processing methods which take this exact geometry into account. Static corrections are crucial for the quality of very high-frequency stacked data because static shifts caused by variations of the source and streamer depths are of the order of half to one dominant wavelength, so that they can lead to destructive interference during stacking of CDP sorted traces. As common surface-consistent residual static correction methods developed for land seismic data require fixed shot and receiver locations two simple and fast techniques have been developed for marine seismic data with moving sources and receivers to correct such static shifts. The first method – called CDP static correction method – is based on a simultaneous recording of Parasound sediment echosounder and multichannel seismic reflection data. It compares the depth information derived from the first arrivals of both data sets to calculate static correction time shifts for each seismic channel relative to the Parasound water depths. The second method – called average static correction method – utilises the fact that the streamer depth is mainly controlled by bird units, which keep the streamer in a predefined depth at certain increments but do not prevent the streamer from being slightly buoyant in-between. In case of calm weather conditions these streamer bendings mainly contribute to the overall static time shifts, whereas depth variations of the source are negligible. Hence, mean static correction time shifts are calculated for each channel by averaging the depth values determined at each geophone group position for several subsequent shots. Application of both methods to data of a high-resolution seismic survey of channel-levee systems on the Bengal Fan shows that the quality of the stacked section can be improved significantly compared to stacking results achieved without preceding static corrections. The optimised records show sedimentary features in great detail, that are not visible without static corrections. Limitations only result from the sea floor topography. The CDP static correction method generally provides more coherent reflections than the average static correction method but can only be applied in areas with rather flat sea floor, where no diffraction hyperbolae occur. In contrast, the average static correction method can also be used in regions with rough morphology, but the coherency of reflections is slightly reduced compared to the results of the CDP static correction method.     

悬浮沙激光散斑图像处理的研究

本文以统计模式识别为基础，阐述了图像处理在悬浮沙粒粒径流量中的实际应用，提出了用图像层析来确定放大系数的方法，提出了测量的准确度。     

杭州湾海域水体悬沙粒度统计分析

利用2000年9月在杭州湾进行的原型水文泥沙测验所获取的648个悬沙粒度样品,进行了样品粒度统计分析,结果表明:在杭州湾测验区域,粒径为4.00～20.20μm的悬沙出现频率最高;悬沙的中值粒径值自东向西迅速增大;北岸海域悬沙的中值粒径值大于南岸海域悬沙的中值粒径值。     

Growth and reproduction of the bivalve Spisula subtruncata (da Costa) in Dutch coastal waters

The bivalve Spisula subtruncata is usually abundant in shallow coastal waters along the Dutch coast. However, its biomass has been decreasing since 1995. In order to assess whether reproductive failure may be the cause of the observed decline over the last decades, the energy investment in reproduction of a population of S. subtruncata from central Dutch coastal waters was studied. The population studied consisted of individuals of up to four years old. Shell length reached maximum values of around 32 mm and individual total body, somatic and gonadal ash-free dry mass reached maximum values of about 278 mg AFDM, 252 mg AFDM and 76 mg AFDM, respectively. A clear seasonal cycle in somatic and gonadal mass was observed. Somatic and gonadal mass indices increased in early spring and reached maximum values during summer, followed by a decrease to minimum values at the beginning of the following year. Spawning was in June–July and settlement of spat seems to have occurred in July–August. Mean oocyte diameter was 57.43 ± 0.03 μm, corresponding to a volume of 98972 μm³. These results suggested that reproductive failure was not the cause of the current population decline. Most likely, unsuccessful settlement of spat and/or severe predation during the first months of life were responsible for the observed patterns.     

非等截面桩超声波成孔质量检测

分析了非等截面超声波成孔质量检测的几个主要影响因素,给出了相应得改进措施。用工程实例说明超声波反射技术是一种保证非等截面桩成孔质量和成桩质量必不可少的检测方法。     

襄樊汉江四桥大口径灌注桩成孔施工实践

介绍了使用泥浆护壁气举反循环回转钻进工艺进行襄樊汉江四桥大口径嵌岩桩的施工实践。施工中采用下置双护简隔离卵石层，合理选用钻头类型(卵砾石层采用五翼合金刮刀钻头，基岩采用球齿滚刀钻头)和钻进参数(混合器沉没深度，尾管长度，孔内空气流量与压力)，摸索与总结出一套复杂地层成孔施工经验。     

地震静校正全局最优化问题的求解

针对地震静校正存在的非线性和多参数性等问题，本文提出了一种全局优化的剩余静校正方法.在模型更新规则上，把模拟退火方法和均匀优化设计方法结合在一起，使模型的更新更为合理，从而加快了搜寻全局最优解的速度.同时提出了模型的不同分量的温度参数和退火过程的选取方式，把温度参数的选取与地震剖面的能量联系起来，使温度参数的选取具有自适应的特点.该方法克服了常规模拟退火方法所具有的寻优空间不均匀以及退火参数需通过多次试验选取的缺陷.通过实际地震资料的计算证明，本文提出的方法对地震静校正问题合理而有效.     

GPS精密定位中的海潮位移改正

根据海洋负荷潮理论，利用NAO99b全球海潮模型，计算了中国部分IGS站的海潮位移改正，并将海潮位移改正应用到GPS数据处理当中。在GAMIT软件的解算过程中，分别按加入和不加入海潮位移改正，对GPS基线分量和测站坐标分别进行了计算和比较分析。结果表明，海潮位移改正无论是对GPS基线分量还是对测站坐标，都有一定的影响。     

温州世贸中心大厦超深大直径钻孔灌注桩施工技术

介绍了超深大直径钻孔灌注桩在温州世贸中心大厦桩基工程中的应用情况，对其施工中出现的主要问题进行了分析和处理，并提出了解决措施。