Topography as a major factor in the development of arcuate thrust belts: insights from sandbox experiments

We have used sandbox experiments to investigate and to illustrate the effects of topography upon the development of arcuate thrust belts. In experiments where a sand pack shortened and thickened in front of an advancing rectilinear piston, the geometry of the developing thrust wedge was highly sensitive to variations in surface topography. In the absence of erosion and sedimentation, the surface slope tended to become uniform, as predicted by the theory of critical taper. Under these conditions, the wedge propagated by sequential accretion of new thrust slices. In contrast, where erosion or sedimentation caused the topographic profile to become irregular, thrusts developed out of sequence. For example, erosion throughout a hinterland caused underlying thrusts to remain active and inhibited the development of new thrusts in the foreland. Where initial topography was irregular in plan view, accreting thrusts tended to be arcuate. They were convex towards the foreland, around an initially high area; concave towards the foreland, around an initially low area. Initial plateaux tended to behave rigidly, while arcuate thrust slices accreted to them. Thrust motions were radial with respect to each plateau. Within transfer zones to each side, fault blocks rotated about vertical axes and thrust motions were oblique-slip. At late stages of deformation, the surface slope of the thrust wedge tended towards a uniform value. Initial mountains of conical shape (representing volcanoes) also escaped deformation, except at depth, where they detached. Arcuate thrust slices accreted to front and back. Where a developing thrust wedge was subject to local incision, accreting thrust slices dipped towards surrounding areas of high topography, forming Vs across valleys.Arcuate structural patterns are to be found around the three highest plateaux on Earth (Tibet, Pamirs and Altiplano) and around the Tromen volcanic ridge in the Neuquén Basin of northern Patagonia. We infer that these areas behaved in quasi-rigid fashion, protected as they were by their high topography.     

感热加热对华北及其周边对流活动的影响

利用2006～2017年风云气象卫星资料和气象再分析资料,对华北及周边5～8月对流活动和地面感热加热进行统计分析。分析表明,华北及周边白天平均感热加热和地形关系密切,内蒙古中部和东南部、华北北部和华北西部山区感热加热较强,最强感热加热出现在5月和6月,7月和8月明显减弱。和感热加热强度相对应,对流活动频率较高的月份同样出现在5月和6月,其中5月以弱对流为主,6月华北中北部强对流最活跃,另外,环渤海区域6～7月强对流相对频繁。5～8月日平均感热加热和对流频率趋势呈现一致的减弱对应关系。上午,感热加热引起河北西部和北部对流层低层出现辐合气流,700 hPa以下出现不同程度的增温,上升气流可达对流层中层,东侧的平原地区出现补偿下沉运动,升温和上升运动触发对流,在有利条件下发展东移。不同月份和区域对流频率日变化呈现明显差异,6月对流频率日变化显著,8月最弱,山区对流频率日变化显著,东部渤海及周边对流频率日变化较小。对流频率的月平均分布和日变化均表现出和地形相关的感热加热差异的特征。     

西北地区一次沙尘暴过程的诊断分析及地形影响的模拟试验

以实况资料作初始场,利用改进的MM4中尺度模式对西北地区2001年4月8~9日强沙尘暴天气过程的位势涡度、涡度、垂直速度、螺旋度等热、动力物理量的水平和垂直分布特征进行了分析,发现各物理量场在沙尘暴发展的不同时期有着很好的配置,物理量量值及其分布特征的变化与沙尘暴天气的形成、发展、消弱的不同时期有着很好的对应。通过改变秦岭及河西走廊地形进行数值模拟试验,发现秦岭地形对此次沙尘暴天气系统影响很弱,而河西走廊地形对沙尘暴天气系统影响较大,河西走廊狭窄的地形为沙尘暴形成提供了有利的地理环境。     

Statistical characterization of frost zones: Case of tea freeze damage in the Kenyan highlands

Frequent frost occurrences in the Kenyan highlands have had devastating effects on agricultural productivity. With inadequate management systems to mitigate the impacts, farmers have often had to bear the burden of losses resulting from frost damage. While agriculture in Kenya remains dependent on weather and climate, the agricultural economy of Kenya continues to suffer, underscoring the need for building local knowledge as basis for development of early warning systems. The current paper attempts to delineate frost zones by statistically characterizing them based on known risk factors related to topography (elevation, convexity, aspect, upslope flow length) and Land Surface Temperature (LST) derived from Moderate Resolution Imaging Spectroradiometer (MODIS). Through binary logistic regression, a logistic regression model was developed utilizing observation data (frost occurrence and non-occurrence) as a binary dependent variable to estimate the probability of frost occurrence. Assuming a 0.5 probability cut-off threshold between frost occurrence and non-occurrence, an overall accuracy of 81% with area under Receiver Operating Characteristics (ROC) Curve of 0.88 was obtained. No evidence of lack of model fit was detected. This model outperforms the currently operational model that utilizes MODIS LST alone to detect frost zones in the Kenyan tea plantations. It provides an improved method for effective delineation of frost zones by incorporating local topographic characteristics.     

Seismic geomorphology,architecture and genesis of Miocene shelf sand ridges in the Pearl River Mouth Basin,northern South China Sea

Multiple stages of large-scale shelf sand ridges, including the shoreface-attached and the offshore types, have developed in the Miocene successions on the mid-shelf region of the Pear River Mouth Basin, northern South China Sea. Utilizing a high-quality 3D seismic data set, accompanying 2D seismic profiles and well logs, the morphology, architecture and genesis of these shelf sand ridges have been systematically investigated in this study. The ridges are of very large scale, with the largest one having a maximum height of 64 m, a width of more than 20 km and a length of 37 km within the 3D survey area. Being mound-shaped, they also display obvious asymmetry character, with the ridge crest preferentially located on the SE side. Three main internal components, including the ridge front, central ridge and the ridge tail, have been recognized through careful anatomy analysis of the two most well-imaged ridges, each displaying distinct expressions on seismic amplitudes and geometries. In the plan view, most of the shelf sand ridges are generally NE–SW oriented and widening to the SW direction. Scouring features can also be clearly observed along the SW direction, including scour depressions and linear sandy remnants. On well logs, the shelf sand ridges are represented by an overall coarsening-upward pattern. Intervals with blocky sandstones are preferentially present on higher locations due to a differential winnowing process controlled by shelf topography.Plenty of evidence indicates that these ridges were primarily formed by the reworking of forced regressive or lowstand deltaic deposits under a persistent southwesterly flowing current during the subsequent transgression. This very current is a composite one, which is speculated to consist of winter oceanic current, SCSBK (South China Sea Branch of Kuroshio) intrusion onto the shelf and internal waves propagating from the Luzon Strait. Tidal currents might have contributed to the SE growth of the ridge. In response to the reglaciation of Antarctic ice-sheet and the closure of Pacific-Indian ocean seaway in the middle Miocene, the intensification of the North Pacific western boundary current was considered to have potential links to the initiation of the shelf sand ridges at ∼12 Ma. The development of shelf ridges was terminated and replaced by rapid deltaic progradation at ∼5.5 Ma.     

山区年、月平均温度推算方法的研究

本文提出了山区年、月平均温度空间分布的推算方法,并提供了相应的小地形温度订正值。该方法在福建省沙溪流域山区实际应用的结果表明,能有效地揭示山区年、月平均温度空间分布的宏观与微观变化,效果满意,精度较高。     

Reduced complexity strategies for modelling urban floodplain inundation

Significant advances in flood inundation modelling have been made in the last decade through the use of a new generation of 2D hydraulic numerical models. These offer the potential to predict the local pattern and timing of flood depth and velocity, enabling informed flood risk zoning and improved emergency planning. With the availability of high resolution DEMs derived from airborne lidar, these models can theoretically now be routinely parameterized to represent considerable topographic complexity, even in urban areas where the potential exists to represent flows at the scale of individual buildings. Currently, however, computational constraints on conventional finite element and volume codes typically require model discretization at scales well below those achievable with lidar and are thus unable to make optimal use of this emerging data stream.In this paper we review two strategies that attempt to address this mismatch between model and data resolution in an effort to improve urban flood forecasts. The first of these strives for a solution by simplifying the mathematical formulation of the numerical model by using a computationally efficient 2D raster storage cell approach coupled to a 1D channel model. This parsimonious model structure enables simulations over large model domains offering the opportunity to employ a topographic discretization strategy which explicitly represents the built environment. The second approach seeks to further reduce the computational overhead of this raster method by employing a subgrid parameterization to represent the effect of buildings and micro-relief on flow pathways and floodplain storage. This multi-scale methodology enables highly efficient model applications at coarse spatial resolutions while retaining information about the complex geometry of the built environment.These two strategies are evaluated through numerical experiments designed to reconstruct a flood in the small town of Linton in southern England, which occurred in response to a 1 in 250 year rainfall event in October 2001. Results from both approaches are encouraging, with the spatial pattern of inundation and flood wave propagation matching observations well. Both show significant advantages over a coarse resolution model without subgrid parameterisation, particularly in terms of their ability to reproduce both hydrograph and inundation depth measurements simultaneously, without need for recalibration. The subgrid parameterization is shown to achieve this without contributing significant computational complexity and reduces model run-times by an order of magnitude.     

Evaluation of seismic ground motion induced by topographic irregularity

Results of an extensive numerical study on the 2D scattering of seismic waves by local topography are presented. The investigation has been conducted using the direct boundary element method. Several types of topography (slopes, canyons and ridges) are considered. The influences of some key parameters, such as exciting frequency and geometry of the irregular feature, on surface ground motion are studied in detail. It is found that local topographic conditions play an important role in the modification of seismic ground motion at the irregular feature itself and its neighbourhood. The present results can be considered to be useful from the viewpoint of earthquake engineering and seismology.     

Topographic monitoring of a middle estuary mudflat, Humber estuary, UK – Anthropogenic impacts and natural variation

Annual topographic surveys were carried out at the Saltend mudflat (Humber estuary, UK) between 1998 and 2006. These surveys formed part of an ongoing monitoring programme to examine the potential effects on the mudflat topography of the construction and operation of a waste water treatment works (WwTW) development by Yorkshire Water. Of particular concern was the potential disruption to the sedimentological regime within the special protection area (SPA) and candidate special area of conservation (cSAC) which could affect the invertebrate communities and ornithological functioning of the site. In addition to the development of the WwTW located to the extreme north-west of the site, a port extension removing 10 ha of the Saltend intertidal mudflat (outside the SPA but immediately south east of the WwTW) also occurred between 1999 and 2006. Minimal change was noted across the site following the construction and operation of the WwTW between 1998 and 2000. However, the construction of the bund in closer proximity to the SPA and cSAC masked any potential impact the WwTW could have had across the site after 2000. Profiles and contour mapping indicate that significant mudflat accretion occurred in the immediate area of the bund, with a general increase recorded across the western section of the site since 2000. In contrast the alternations to channel planform and subsequent rapid accretion of the mudflat to the east of the jetty, being a significant distance from the developments, are attributed to natural cyclical changes.     

Some Insights into Topographic,Elastic and Self-gravitation Interaction in Modelling Ground Deformation and Gravity Changes in Active Volcanic Areas

Surface displacements and gravity changes due to volcanic sources are influenced by medium properties. We investigate topographic, elastic and self-gravitation interaction in order to outline the major factors that are significant in data modelling. While elastic-gravitational models can provide a suitable approximation to problems of volcanic loading in areas where topographic relief is negligible, for prominent volcanoes the rough topography could affect deformation and gravity changes to a greater extent than self-gravitation. This fact requires the selection, depending on local relief, of a suitable model for use in the interpretation of surface precursors of volcanic activity. We use the three-dimensional Indirect Boundary Element Method to examine the effects of topography on deformation and gravity changes in models of magma chamber inflation/deflation. Topography has a significant effect on predicted surface deformation and gravity changes. Both the magnitude and pattern of the geodetic signals are significantly different compared to half-space solutions. Thus, failure to account for topographic effects in areas of prominent relief can bias the estimate of volcanic source parameters, since the magnitude and pattern of deformation and gravity changes depend on such effects.