基于噪声谱比法的内蒙古西部地区台站场地响应研究

利用内蒙古西部12个台站的地脉动噪声数据，采用噪声谱比法研究台站的场地响应情况。分析表明，台站场地响应按曲线形态可分为3类，且可能受地形地貌、局部构造和台基状况等条件影响。对比分析噪声谱比法与Moya方法的场地响应结果发现，场地响应曲线形态基本一致，只有极少数台站存在明显差异。结果表明，内蒙古西部区域大部分台站的台基状况总体较好，场地响应曲线较为平坦，无明显频率放大点。     

The response of an elastic half‐space under a momentary shear line impulse

The response of an ideal elastic half‐space to a line‐concentrated impulsive vector shear force applied momentarily is obtained by an analytical–numerical computational method based on the theory of characteristics in conjunction with kinematical relations derived across surfaces of strong discontinuities. The shear force is concentrated along an infinite line, drawn on the surface of the half‐space, while being normal to that line as well as to the axis of symmetry of the half‐space. An exact loading model is introduced and built into the computational method for this shear force. With this model, a compatibility exists among the prescribed applied force, the geometric decay of the shear stress component at the precursor shear wave, and the boundary conditions of the half‐space; in this sense, the source configuration is exact. For the transient boundary‐value problem described above, a wave characteristics formulation is presented, where its differential equations are extended to allow for strong discontinuities which occur in the material motion of the half‐space. A numerical integration of these extended differential equations is then carried out in a three‐dimensional spatiotemporal wavegrid formed by the Cartesian bicharacteristic curves of the wave characteristics formulation. This work is devoted to the construction of the computational method and to the concepts involved therein, whereas the interpretation of the resultant transient deformation of the half‐space is presented in a subsequent paper. Copyright © 2003 John Wiley & Sons, Ltd.     

The characteristics of Asian dust events in Northeast Asia during the springtime from 1993 to 2004

The characteristics of Asian dust events that occurred in Northeast Asia during the springtime from 1993 to 2004 are investigated using 3-hourly SYNOP reports (World Meteorological Organization). Occurrences of blowing sand and dust storm are low in 1997 and 1999, but have increased rapidly since 2000. The maximum occurrence was recorded in 2002. Wind velocity of 6.5 m s^− 1 as a threshold wind velocity is not so exactly consistent with the occurrence of blowing sand. However, wind velocity of 14 m s^− 1 as a strong wind causing dust storm had similar tendency to those of dust storm and Dust Storm Index.Source regions of Asian dust are divided into three regions (A: dry arid, B: semi-arid, and C: cultivated), based upon the occurrence of blowing sand and dust storm. Eight meteorological stations are selected in three regions, which have frequent occurrences of blowing sand. Source regions of Asian dust that affect the Korean peninsula are gradually extending eastward. Positive anomalies of NDVI occurred in 1994, 1995, and 1998 when temperature was high and precipitation was heavy. However, the frequent occurrence of the dust phenomena is not always consistent with lots of vegetation, high temperature, and much precipitation in this study.     

Virtual Huanghe River System： Framework and Technology

1 Introduction Huanghe (Yellow) River basin is located in 32°–42°N, 96°–119°E. The area of the catchment is more than 752,000km2. The river is 5464km long with a drop in elevation of 4830m. Among the whole area, the moun- tainous and stone area accounts for 29%, loess and hills area 46%, sandy area 11% and plain area 14%, respec- tively. Different natural landscapes exist in this area. The Huanghe River flows through the Loess Plateau, where the soil is eroded seriously (Wang, 2002;…     

Effect of spatial variation characteristics on contouring of design storm depth

The ordinary kriging method, a geostatistical interpolation technique, was applied for developing contour maps of design storm depth in northern Taiwan using intensity–duration–frequency (IDF) data. Results of variogram modelling on design storm depths indicate that the design storms can be categorized into two distinct storm types: (i) storms of short duration and high spatial variation and (ii) storms of long duration and less spatial variation. For storms of the first category, the influence range of rainfall depth decreases when the recurrence interval increases, owing to the increasing degree of their spatial independence. However, for storms of the second category, the influence range of rainfall depth does not change significantly and has an average of approximately 72 km. For very extreme events, such as events of short duration and long recurrence interval, we do not recommend usage of the established design storm contours, because most of the interstation distances exceed the influence ranges. Our study concludes that the influence range of the design storm depth is dependent on the design duration and recurrence interval and is a key factor in developing design storm contours. Copyright © 2003 John Wiley & Sons, Ltd.     

Damage identification method using harmonic excitation force considering both modelling and measurement errors

A method of structural damage identification using harmonic excitation force is presented. It considers the effects of both measurement and modelling errors in the baseline finite element model. Damage that accompanies changes in structural parameters can be estimated for a damaged structure from the change between measured vibration responses and ones calculated from the analytical model of the intact structure. In practice, modelling errors exist in the analytical model due to material and geometric uncertainties and a reduction in the degrees of freedom as well as measurement errors, making identification difficult. To surmount these problems, bootstrap hypothesis testing, which enables statistical judgment without information about these errors, was introduced. The method was validated by numerical simulation using a three‐dimensional frame structure and real vibration data for a three‐storey steel frame structure. Copyright © 2005 John Wiley & Sons, Ltd.     

A high resolution,multiproxy Late‐glacial record of climate change and intrasystem responses in northwest England

A lacustrine carbonate sequence from Hawes Water, Lancashire, UK, has been studied using stable isotopic, lithological, pollen and mineral magnetic analysis. The data reveal four abrupt climatic oscillations in the Late‐glacial Interstadial leading up to the onset of the Loch Lomond Stadial. The data also point to climatic warming relatively early within the stadial, ca. 12 500 GRIP yr, prior to the onset of the Holocene. The oxygen isotope record is taken as a signature of climate forcing against which the response of the lake‐system can be monitored. By adopting this approach it is revealed that the response of the biological system to the rapid climatic oscillations is non‐linear and primarily a function of the antecedent conditions. A significant end‐Devensian isotopic excursion (A) is matched by only minor changes in the cold‐adapted floras and faunas. During the warmer interstadial, the response of the biological ecosystem (events B–D) is clearly influenced by thresholds: major changes in the catchment vegetation associated with relatively minor oscillations in the isotopic signature. The stratigraphical patterns reveal significant lag effects between the onset of climate deterioration and resulting changes in vegetation. Copyright © 2002 John Wiley & Sons, Ltd.     

Influence of soft clays on the response spectra for structures in eastern Canada

The 1990 edition of the National Building Code of Canada (Associate Committee of the National Building Code, National Research Council, Ottawa, 1990) makes a clear distinction between eastern and western Canada in terms of seismic acceleration and velocity zones. While it is well established that ground motions can be amplified significantly through loose clay deposits, no results are available that take into consideration the typical high frequency content of ground motions in eastern Canada. This paper develops ground amplification curves for clays having depths between 10 and 70 m excited by typical eastern Canadian ground motions scaled to two different values of peak horizontal accelerations. Simplified free-field spectral design curves, which could be used by structural designers, are proposed. The curves show that maximum spectral accelerations occur for structural periods between 0.2 and 0.5 s. In addition, soil depth does not appear to be an important parameter controlling the response of typical clay deposits in eastern Canada.     

Contribution of storms to groundwater recharge in the semi‐arid region of Karnataka,India

This paper describes the application of environmental isotopes and injected tracer techniques in estimating the contribution of storms as well as annual precipitation to groundwater recharge and its circulation, in the semi‐arid region of Bagepalli, Kolar district, Karnataka. Environmental isotopes ²H, ¹⁸O and ³H were used to study the effect of storms on the hydrological system, and an isotope balance was used to compute the contribution of a storm component to the groundwater. Some of the groundwater samples collected during the post‐storm periods were highly depleted in stable isotope content with higher deuterium excess relative to groundwater from the pre‐storm periods. Significant variation in deuterium excess in groundwater from the same area, collected in two different periods, indicates the different origin of air masses. The estimated recharge component of a storm event of 600 mm to the groundwater was found to be in the range of 117–165 mm. There was no significant variation in environmental tritium content of post‐storm and pre‐storm groundwater, indicating the fast circulation of groundwater in the system. After completion of the environmental isotope work, an injected radiotracer ³H technique was applied to estimate the direct recharge of total precipitation to the groundwater. The estimated recharge to the groundwater is 33 mm of the 550 mm annual precipitation during 1992. Copyright © 2003 John Wiley & Sons, Ltd.     

Design of stable drainage networks in upland forestry plantations

Erosion of man-made, forestry drainage channels occurs when the plough cuts through the surface peat layer into the underlying erodible mineral soil. A procedure is developed, based on hydraulic considerations, which will allow the drainage engineer to design stable drainage networks in upland forestry plantations. An example design chart is given for an erodible sandy loam type soil.