Porphyroblast inclusion-trail orientation data: eppure non son girate*!

Extensive examination of large numbers of spatially orientated thin sections of orientated samples from orogens of all ages around the world has demonstrated that porphyroblasts do not rotate relative to geographical coordinates during highly non-coaxial ductile deformation of the matrix subsequent to their growth. This has been demonstrated for all tectonic environments so far investigated. The work also has provided new insights and data on metamorphic, structural and tectonic processes including: (1) the intimate control of deformation partitioning on metamorphic reactions; (2) solutions to the lack of correlation between lineations that indicate the direction of movement within thrusts and shear zones, and relative plate motion; and (3) a possible technique for determining the direction of relative plate motion that caused orogenesis in ancient orogens.     

2001-2002年上海天文台卫星激光测距观测报告

介绍了 2 0 0 1- 2 0 0 2年上海天文台卫星激光测距观测概况和亚厘米级精度的测距实验     

全站仪交汇法在高速公路路面沉降监测中的应用

文章介绍了全站仪交会法沉降监测,方便简洁地解决了测量人员不能进入的高速公路等特殊位置的测量问题,并通过对该方法的精度分析,论证了其可行性和有效性,对以后类似的测量工作提供经验和依据。     

单中继星单低轨卫星的联合定轨精度分析

针对由单中继星和单低轨卫星组成的联合定轨系统,给出了系统内不同轨道卫星摄动项的选取方案和卫星间的可见性判别模型。在模拟出含有白噪声的四程测距观测数据文件的基础上,研究了测距精度和采样弧段对联合定轨中高、低轨卫星定轨精度的影响。得出如下结论:联合定轨更有利于对低轨卫星的轨道改进;同样的采样时间条件下,测距噪声越小定轨精度越高,并且采样时间越短它的影响越明显;同样的测距噪声条件下,所用资料的采样时间越长精度越高,但当测距精度很高时,TDRS达到最好定轨精度所需的采样时间相应有所缩短。并在定出轨道后进行了轨道预报,分析了轨道预报的趋势及精度。     

前方交会及光电高程导线在桥梁圆形立柱监理中的应用

根据对前方交会及光电高程导线的精度分析,对用前方交会及光电高程导线复核圆形立柱进行了探讨,并给出了工程实例验证.     

Parameters affecting maximum fluid transport in large aperture fractures

We present results of laboratory experiments to study the behavior of liquids moving in unsaturated wide-aperture fractures. A 5-mm-thick glass plate cut with a 1.7-mm aperture was used as a fractured rock analog to study behavior of film and capillary droplet flow modes. Flow rates ranged between 0.6 and 6.0 ml/min. Variability in the ambient barometric pressure, resulting from weather conditions, seemed to play a role in the natural selection of flow mode. For droplet mode, constant input conditions resulted in highly variable transport properties within the fracture. The advancing meniscus exhibited a dynamic contact angle that was a function of the droplet speed and much larger than the static contact angle. Flow rate was reduced due to the larger contact angle. Analytical expressions for droplet velocity and flow capacity are presented as a function of the dynamic rather than the static contact angle.     

空间点相对关系的精密检测

工业检测的精度一般要求很高，常规的检测手段难以达到。本文对空间点相对关系的精密检测方法和精度进行分析，实践表明该方法行之有效。     

GPS广播星历参数拟合算法

介绍了GPS广播星历参数的最小二乘估计方法。推导了相应的计算公式。计算结果表明。文中给出的公式是正确的，其拟合精度以用户距离误差(URE)示时，对预报轨道的损失小于1cm。     

导航卫星自主定轨的算法研究及模拟结果

讨论了利用卫星-卫星间的距离观测值建立导航卫星系统自主定轨的数学方法，并用GPS星座模拟星间观测值，采用滤波算法计算卫星的状态参数。模拟结果表明，在空间测距精度一定的情况下，自主定轨精度能高于GPS广播星历，因而能较精确地维持卫星系统的坐标框架。     

Retrieval of effective leaf area index (LAIe) and leaf area density (LAD) profile at individual tree level using high density multi-return airborne LiDAR

As an important canopy structure indicator, leaf area index (LAI) proved to be of considerable implications for forest ecosystem and ecological studies, and efficient techniques for accurate LAI acquisitions have long been highlighted. Airborne light detection and ranging (LiDAR), often termed as airborne laser scanning (ALS), once was extensively investigated for this task but showed limited performance due to its low sampling density. Now, ALS systems exhibit more competing capacities such as high density and multi-return sampling, and hence, people began to ask the questions like—“can ALS now work better on the task of LAI prediction?” As a re-examination, this study investigated the feasibility of LAI retrievals at the individual tree level based on high density and multi-return ALS, by directly considering the vertical distributions of laser points lying within each tree crown instead of by proposing feature variables such as quantiles involving laser point distribution modes at the plot level. The examination was operated in the case of four tree species (i.e. Picea abies, Pinus sylvestris, Populus tremula and Quercus robur) in a mixed forest, with their LAI-related reference data collected by using static terrestrial laser scanning (TLS). In light of the differences between ALS- and TLS-based LAI characterizations, the methods of voxelization of 3D scattered laser points, effective LAI (LAIe) that does not distinguish branches from canopies and unified cumulative LAI (ucLAI) that is often used to characterize the vertical profiles of crown leaf area densities (LADs) was used; then, the relationships between the ALS- and TLS-derived LAIes were determined, and so did ucLAIs. Tests indicated that the tree-level LAIes for the four tree species can be estimated based on the used airborne LiDAR (R² = 0.07, 0.26, 0.43 and 0.21, respectively) and their ucLAIs can also be derived. Overall, this study has validated the usage of the contemporary high density multi-return airborne LiDARs for LAIe and LAD profile retrievals at the individual tree level, and the contribution are of high potential for advancing forest ecosystem modeling and ecological understanding.