沉积钙质白云石带状面缺陷的择优取向

作者用透射电子显微镜研究了沉积钙质白云石中的带状面缺陷。在衍衬象中面缺陷呈现出特有的条纹衬度,并具有一定的择优取向,它们沿着｛018｝面排列。面缺陷也可分叉,分枝部分平等于｛2－／10｝面。根据白云石面缺陷的取向,本文提出了鞍状白云石宏观弯曲面和微观面缺陷的取向关系。     

日本鳗鲡白仔鳗耳石中心部分的电镜扫描观察

对在１９９０年４月取自长江口的白仔鳗耳石进行扫描电镜观察,发现了耳石中心核及其外周的深暗凹槽生长轮之间存在着数个生长轮。     

激光扫描共聚焦显微镜在海洋动物发育生物学上的应用

激光扫描共聚焦显微镜具有成像清晰、获得三维图像、进行多标记观察等优势。本文扼要介绍了激光扫描共聚焦显微镜的原理和特点,着重阐述了激光扫描共聚焦显微镜在海洋动物配子发生;受精过程中细胞内Ca~(2 )变化、肌动蛋白转移和蛋白激酶变化;胚胎和幼体发育的三维成像等研究领域中的应用。并对LSCM在DNA含量、RNA含量等领域的定量、定性前景进行展望。     

大亚湾水域两种拟菱形藻的形态学鉴定及毒素分析

对2005年分离自广东大亚湾的两种潜在产毒拟菱形藻进行了形态学观察和毒性分析.通过透射电子显微镜(TEM)观察确认藻种为细弱拟菱形藻(Pseudo-nitzschia cuspidata)和多纹拟菱形藻(P.multistriata).采用高效液相色谱法(HPLC)对这两种藻的常规培养样进行软骨藻酸毒素检测,结果均未检测到软骨藻酸.鉴于以上两种拟菱形藻存在着潜在产毒特性,不同培养条件的诱导实验尚需继续.     

虾夷扇贝人工诱导雌核发育精子遗传失活及紫外线照射对精子形态结构影响的研究

在1698μWcm-2s^-1的紫外线照射强度下，虾夷扇贝雌核单倍体的最佳诱导时间为60s。从早期胚胎存活率可以观察到Hertwig效应的存在。随着照射时间增加，受精率明显下降，而受精卵在到达D形幼虫期之前便停止发育。扫描电镜显示，随着紫外线照射强度的增加。精子顶体和鞭毛结构趋向于受到更大程度的破坏，直到完全失去顶体和鞭毛。并指出这可能是造成受精率降低的主要原因。     

Evaluation of three waterborne polymers as stabilizers for sandy soil

This study reports on waterborne polymer emulsion systems that were used for structural modification of sandy soils. The first emulsion used was a styrene-acrylic, copolymer emulsion; the second and third were vinyl-acrylic, copolymer-based emulsions. Specimens were prepared by adding different polymer emulsions to the sand and water in prescribed amounts. The performance of the different emulsion systems as sand stabilizers was estimated through measurement of the hydraulic conductivity and compressive strength. Measurements of hydraulic conductivity were conducted in a flexible membrane test apparatus. The hydraulic conductivity for the three emulsions decreased at different rates, with an increase in polymer content up to 3 wt. (i.e., % by weight). Additional increase of polymer content did not introduce significant decrease in hydraulic conductivity, and, at 5 wt.%, the three emulsions had essentially the same effect. Measurements made on dry cylindrical specimens disclosed remarkable enhancement in the mechanical behavior of the system. The compressive strength and modulus of elasticity of the examined emulsions increased with a higher concentration of polymer. Scanning electron microscope (SEM) revealed that the reduction in the permeability and the improved mechanical properties can be attributed to three dominant structural changes: the development of interconnecting ties between the sand particles, the development of adhesion between neighboring sand particles in contact, and the covering of the sand particles with a thin polymer film.     

吐哈盆地及二连盆地侏罗系煤微类脂组分的共聚焦激光扫描显微镜（CLSM）研究及油气意义

吐哈盆地产出有比较丰富的侏罗系煤成油气田，本文用共聚焦激光扫描显微镜和热解分析等手段研究了煤中类脂组及微类脂组的类型、含量、分布与煤成烃性能和产出的关系。观察分析结果表明：在一般煤岩组分观测中主要含煤的西山窑组和八道湾组煤层类脂组含量很少超过１０％，但是一些煤样的热解分析中Ｓ＿１可高达５－２３ｍｇ／ｇ，Ｓ＿２可达１５０─２００ｍｇ／ｇ，ＨＩ（烃／有机碳）可高达１５０─３５０ｍｇ／ｇ生烃、含烃性能较好。进一步用共聚焦激光显微镜观测结果表明：本区一些薄层状、条带状煤层的基质镜质体和叶结构镜质体中微类脂组含量比较丰富，微区定量统计含量在３％─１８％左右。这种富含微类脂组的基质镜质体和结构镜质体在煤成油气中有重要意义，而且由于多数微类脂体在煤中常成点线状、似层状、充填状、网络状分布，可能有利于煤成油气的运移和聚集。     

黄土微结构图像处理的方法

本介绍了对黄土微结构电镜图像进行图像处理的常用方法。这些方法可以去除图像噪声，提高图像的对比度，使得图像便于进行人工解译或借助软件的图像分析。     

广东茂名高岭土煅烧实验研究

对茂名高岭土进行煅烧，结合X-射线衍射、扫描电子显微镜分析，得到了茂名高岭土在不同温度点煅烧的性能参数，并确定出其非晶化转变的温度是550℃。同时对煅烧过程中的煅烧温度、恒温时间等影响因素进行探讨，结果表明，在茂名高岭土的煅烧过程中，适当延长恒温时间可降低非晶化转变的温度，缩短恒温时间，则非晶化转变温度升高。     

Microcrack networks in granite affected by a fault zone: Visualization by confocal laser scanning microscopy

Microcracks in the Cretaceous Ryoke-type granite in Japan were investigated by using deep drilling core samples collected in the Mizunami Underground Research Project of the Japan Nuclear Cycle Development Institute (JNC). The granite body suffered brittle deformation associated with Tertiary thrust movement. Based on core-scale and microscopic deformation features, the drill core from a depth of 300 to 700 m is divided into four domains, i.e. (A) undeformed granite, (B) granite intruded by cataclastic seams, (C) fractured granite in the fault damage zone, and (D) foliated cataclasite at the fault center. To characterize microcrack geometries in each domain, we employed the impregnation method using a low-viscous acrylic resin doped with fluorescent agents and captured the microcrack images by confocal laser scanning microscopy (CLSM). The CLSM image in the fault damage zone revealed anisotropic development of microcrack networks related to the fault movement. Both CLSM observation and porosity measurements reveal a drastic increase of micro-pores in the foliated cataclasite, possibly caused by fragmentation, and granulation and crack sealing in the fault zone.