差分法周跳探测与修复方法改进

在目前常用的周跳探测与修复方法基础上 ,提出了首先将观测资料按照观测历元不连续分成若干小弧段 ,然后利用差分法进行周跳探测 ,根据差分后周跳放大的特性判断周跳和野值 ,并确定其位置利用宽带组合和电离层组合的方法解算周跳大小。通过实例验证了其有效性。     

Microboudin structures of piemontite along the Sambagawa metamorphic belt, Japan: implications for lateral variation of differential stress during regional metamorphism

Evidence is presented of a lateral variation in differential stress during metamorphism along a regional metamorphic belt on the basis of the proportion of microboudinaged piemontite grains (p) in a quartz matrix in metacherts. It is proposed that p is a practical indicator of relative differential stress. Analysis of 123 metacherts from the 800 km long Sambagawa metamorphic belt, Japan, reveals that p‐values range from < 0.01 to 0.7 in this region. Most samples from Wakayama in the mid‐belt area have p‐values of 0.4–0.6, whereas those from western Shikoku have p‐values of < 0.1. This difference cannot be explained by variations in metamorphic temperature, and is instead attributed to a regional, lateral variation in differential stress during metamorphism.     

Crustal and upper mantle structures of the brazilian coast

The Rayleigh wave phase and group velocities in the period range of 24–39 sec, obtained from two earthquakes which occurred in northeastern brazil and which were recorded by the Brazilian seismological station RDJ (Rio de Janeiro), have been used to study crustal and upper mantle structures of the Brazilian coastal region. Three crustal and upper mantle models have been tried out to explain crustal and upper mantle structures of the region. The upper crust has not been resolved, due basically to the narrow period range of the phase and group velocities data. The phase velocity inversions have exhibited good resolutions for both lower crust and upper mantle, with shear wave velocities characteristic of these regions. The group velocity data inversions for these models have showed good results only for the lower crust. The shear wave velocities of the lower crust (3.86 and 3.89 km/sec), obtained with phase velocity inversions, are similar to that (=3.89 km/sec) found byHwang (1985) to the eastern South American region, while group velocity inversions have presented shear velocity (=3.75 km/sec) similar to that (=3.78 km/sec) found byLazcano (1972) to the Brazilian shield. It was not possible to define sharply the crust-mantle transition, but an analysis of the phase and group velocity inversions results has indicated that the total thickness of the crust should be between 30 and 39 km. The crustal and upper mantle model, obtained with phase velocity inversion, can be used as a preliminary model for the Brazilian coast.     

A geological and geotechnical investigation of the settlement area of Zümrüt Building (Konya, Turkey) which caused 92 fatalities due to its collapse

This study examines the local geological conditions and soil structure as possible causes of the collapse of the Zümrüt Building 2 February 2004. This catastrophe resulted in 92 fatalities and 35 injuries. This study also examines other views which claim weak soil structure, elastic and consolidation settlement of soil and excessive groundwater extraction as well as subsidence resulting from the underground silt erosion as possible factors. Zümrüt Building was constructed on normally consolidated, low plasticity clay. The underground water table was 30 m in depth. The internal friction angle of soil was 8°–30°, its cohesion was between 34 and 127 kN/m² and standard penetration test numbers varied between 11 and 50. The underground water level beneath Zümrüt Building had risen 4.5 m since its construction. Therefore the claim that subsidence resulting from the decrease of underground water level contributed to the collapse is incorrect. Secondly the settlement, resulting from the filling up of the pores created by the silt receding with the underground water, was 4.4 mm in total, and attributing this as the primary cause of the collapse is also incorrect. Soil properties, in situ and laboratory test results showed that the existing and/or expected settlement and the differential ground settlement in the Zümrüt building vicinity had the potential to cause structural damage. The tensile stresses caused by differential settlements recorded here are thought to be an indicator, but not the main cause contributing to the collapse of the building. The Zümrüt Building collapse was due to several compounding mistakes during the construction phase. These were geotechnical and other project faults and the use of low quality construction materials. The resulting catastrophe caused 92 fatalities, 35 injuries and a material loss of approximately US$7 million.     

基于群桩基础沉降估算确定压缩层厚度的探讨

在现行规范中,由于桩基沉降估算模式的不同,压缩层厚度的确定方法也不完全相同。对这些方法进行归纳、总结,并通过具体的工程实例,对由不同估算模式确定的压缩层厚度及沉降估算结果进行探讨与分析,认为对于工程场地地质资料掌握较为翔实的情况下,压缩层厚度可采用变形比法确定,否则,宜根据应力比法确定。     

预防油页岩地层钻进中压差卡钻的措施

分析了油页岩地层钻进中压差卡钻发生的原因,提出了预防压差卡钻的途径及处理方法,并通过工程实例来强调预防为主的重要性。     

增氧机自动控制电路

介绍作者自行设计、研制的控制增氧机运行时间的自动控制电路及其原理．该电路采用ＣＭＯＳ集成芯片，结构简单、工作可靠，价格低，业经试验证实：各项性能指标均符合要求．     

Fluid flow equations governing primary oil migration as a separate phase

A mathematical model of primary oil migration as a separate phase out of compacting shales is presented. During burial and oil generation, source rock porosity decreases and oil saturation increases until residual oil saturation is reached. At this stage oil is expelled out by capillary and excess fluid pressure gradients. The model is a system of differential equations which relate changes in oil and water saturation in time to water and oil flow out of the source rock during burial. An additional set of equations for periods of erosion of overburden are also provided. The equations can be numerically solved by finite difference method. If oil and water flow is to be simulated during oil generation, then at each time step, changes by oil generation in oil and water saturations and porosity must be calculated. The solution procedure is briefly outlined.     

Recruitment patterns of Serpula vermicularis L. (Polychaeta, Serpulidae) in Loch Creran, Scotland

This study aimed to contribute to conservation management of reefs of Serpula vermicularis by increasing understanding of the factors influencing larval settlement. The study was carried out in Loch Creran, which supports the most extensive known development of S. vermicularis reefs in the world. Settlement plates were deployed to examine the influence of season, depth, reef density, substrate type and orientation. Monthly deployment of plates revealed settlement of S. vermicularis to occur predominantly from mid-June to mid-October, peaking in late August to early September. Settlement of Pomatoceros spp. peaked much earlier, in late May to early June. Deployment of plates at different depths revealed a marked reduction in S. vermicularis settlement intensity between 6 and 12 m. As this corresponds with the deeper limit of the peripheral fringe of serpulid reefs in the loch, it is suggested that this limit is imposed by a depth-correlated settlement response, rather than reduction in available substrata. Comparisons of various substrata showed a preference by S. vermicularis larvae for a slate over a scallop substrate and no evidence of enhanced recruitment to occupied or unoccupied tubes of S. vermicularis, suggesting that gregarious attraction is unlikely to be a factor causing reef formation. Settlement onto the upper side of a horizontal scallop substrate was found to be insignificant in comparison with the underside or a vertically orientated scallop. Evidence for the role of light in controlling the depth and substrate-orientation preferences of S. vermicularis larvae is discussed. Based on the results of this study, recommendations are made regarding remediation of areas suffering reef damage.