LZY1—1型光电浊度仪

本文介绍了LZY_(1-1)型光电浊度仪的设计原理,标定方法及使用结果,该仪器用经典法校准后,能快速测量大批量样品的悬浮物含量。     

吉林台爆破料应力应变关系的三轴试验研究

通过室内大型三轴实验，研究了吉林台水库爆破料在不同级配下的应力应变关系，得到了在一定击实功下爆破料的最大干密度随细料含量变化的规律，分析了爆破料在不同级配和不同围压下应力与应变的变化规律、轴向应变与体积应变的关系及抗剪强度变化特性．从微观的角度说明了变化规律产生的原因，得出爆破料的抗剪强度随级配的变化而变化的规律．     

Structure sismique du socle paléozoı̈que du bassin des Doukkala,Môle côtier,Maroc occidental. Indication en faveur de l'existence d'une phase éo-varisqueSeismic structure of the Doukkala basin,Palaeozoic basement,western Morocco: a hint for an Eovariscan fold-and-thrust belt

Seismic profiles and well data from the Doukkala basin unravel the structure of the Palaeozoic basement and suggest that this coastal zone of western Morocco was affected by a compressive phase during the Frasnian. This resulted in the formation of upright, plurikilometric folds associated with reverse faults (North Doukkala), and of asymmetrical folds associated with mostly west verging ramps (South Doukkala). Folding involved all pre-Upper Frasnian formations and caused partial or total hiatus of Upper Frasnian–Strunian strata. This event can be correlated with the orogenic phase reported from more internal domains of the Morocco Hercynian belt, where it is referred to as the ‘Bretonne’ or ‘Eovariscan’ phase. To cite this article: H. Echarfaoui et al., C. R. Geoscience 334 (2002) 13–20     

图像处理技术在地质灾害监测中的应用

三维激光微位移监测技术是一种对地质灾害进行长期监测的新方法。该技术用激光作为光源，用CCD摄像器作为镜头，通过图象采集卡把视频信号采入计算机中，用与该仪器配套的专门软件对采集到的光斑图像进行处理，计算出光斑的三维中心坐标值，把该值和原点坐标值进行比较，就可以算出灾害体滑动的距离。该系统可以对灾害体进行长期、非接触监测，监测时间、监测频率可以任意设定。文章概括介绍该监测的原理，各个组成部分，重点介绍软件部分，即采集的视频信号进入计算机后的图像处理过程和数据库结构。该监测系统已在三块地区试运行了3个月，效果较好。     

Seismic data compression based on integer wavelet transform

Introduction With the development of the seismological observation technique and deep-going of seismicdata application fields, especially the digitization of data in earthquake station networks, theimprovement of the precision, the data quantity increases as geometric order, which bringdifficulty to saving and transfering these data. To keep all information, seismic data, like medicalimages, should be compressed without error in many applications. In generally, traditionalcompression meth…     

基于GIS的远程移动视频监控系统

针对实际应用,从系统架构、应用解析、实现方法等方面介绍了将GIS技术应用于远程移动视频监控系统的解决方案。提出的视频与GIS数据集成方法是一个新的技术尝试,具有应用价值。     

石灰改良高液限土强度特性的函数模型研究

针对广西荔玉高速路基沿线产生的大量高液限土弃方问题,采用生石灰对高液限土进行改良处理。选取弃土场的高液限土,分别配制不同初始含水率、不同石灰掺量的试样进行侧限压缩试验和快剪试验,采用基本初等数学函数模型拟合不同饱和状态、不同初始含水率下石灰掺量对试件压缩特性和抗剪强度影响。结果表明：(1)高液限土的压缩系数随石灰掺量增加呈指数形式减小;(2)不同饱和状态试件的黏聚力和内摩擦角随石灰掺量增加呈二次函数形式变化;(3)高液限土具有水敏性,饱和素土试件最大抗剪强度对应的含水率较击实试验最大干密度对应的含水率高3%～6%;(4)当初始含水率不高于26.73%时,建议石灰掺量不低于6%,否则改良高液限土的石灰掺量不低于8%,可在满足经济性的前提下达到较好的改良效果。     

叶蛇纹岩脆性-半脆性破裂研究

利用Paterson气体介质高温高压流变仪对纯叶蛇纹岩在100~400MPa围压、25~700℃温度和10-5~1.5×10-6s-1应变速率下进行了三轴压缩变形实验。实验结果表明叶蛇纹石在低压条件下表现为脆性破裂,高压或脱水条件下表现为半脆性破裂。随着温度的增加,叶蛇纹石的强度显示逐渐降低的趋势;尤其在脱水条件下,温度的增加可导致叶蛇纹石强度大幅度地降低,而且此时预热时间对强度的影响比未发生脱水时更加显著。结合前人的研究并对比发现,围压在室温下的增加导致叶蛇纹岩强度增加;但在高温下围压的增加导致试样强度整体上降低,这很可能是试样内聚力的局部损失与韧性增强引起的。围压和温度的升高,以及断层面上流体的增加很可能会增加破裂面的韧性,从而减小摩擦系数。此外,叶蛇纹石并非以往人们所认为的那样具有极低的强度,其强度要比低温蛇纹石(如利蛇纹石和纤蛇纹石)的大得多,即便在高温(大约600℃)下差应力大于约600MPa和中-低温(≤400℃)下差应力大于约1000MPa时仍没有表现出明显屈服的迹象。在脱水条件下,蛇纹岩并没有发生脱水致脆,相反脱水使得试样的断裂行为变得更加温和些。因此,俯冲带蛇纹岩脱水更可能诱发其周围更加脆性的岩石发生地震而不是脱水的蛇纹岩本身发生地震。     

Compression limit state of HVAC submarine cables

An industry accepted standard does not currently exist for determination of compression limits in a subsea cable. This has resulted in most manufacturers specifying that subsea cables are not permitted to be axially loaded in compression.Additionally industry guidance does not exist regarding the consequences of inducing compression forces within subsea cables and the resulting effect on cable integrity. Industry recommended practice and guidance also does not have any information regarding experimental test arrangements to determine allowable compression levels within a subsea cable. This lack of modelling/testing guidance along with manufacturer recommendations of zero compressive loads within subsea cables results in overly conservative and restrictive design parameters for subsea cable installation and use.Due to the complex interaction within a subsea cable structure, such as contact interaction and friction between cable strands, theoretical modelling has been unable to provide reliable stress predictions and therefore an experimental testing regime is required if compression limits within the cable are to be appropriately determined. This paper describes combined axial and bending test arrangements that can be used as a guideline for determination of allowable compression limits for subsea cables.