Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Interference of Multiple Strip Footings on Sand Using Small Scale Model Tests

By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to (i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data, however, indicates much greater effect of interference especially for larger spacing among footings.     

饱和软黏土动力学特性循环扭剪试验研究

以饱和软黏土的循环扭剪试验研究为基础,阐明不固结不排水条件下饱和软黏土的动力学特性。在循环扭剪和循环三轴两种不同试验应力状态下,通过研究不同围压和不同静、动应力组合下饱和软黏土的应力等效破坏关系和应变等效破坏关系,提出在循环荷载作用下饱和软黏土的循环破坏同样遵循Mises屈服准则,且在Mises屈服准则下,饱和软黏土的循环强度趋于不变量。循环破坏的过程可以等效为一种拟静力弹塑性循环蠕变,建立了饱和软黏土循环累积变形随静荷载、循环荷载以及循环破坏振次之间的关系式。上述结论分别从应力和变形两个方面阐述饱和软黏土的动力学特性,与试验应力状态和围压无关,可以推广到一般应力状态下。     

Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.     

Low-frequency damping of a moored semisubmersible obtained from simulated extinction tests and mean wave drift forces

Low-frequency damping of a moored semisubmersible drilling platform was obtained from numerical extinction tests simulated in still water and in regular waves and from mean wave drift forces calculated at zero forward speed. The influence of drag forces was represented by the modified Morison equation. The platform as used for the 18th ITTC Comparative Mooring Study was analyzed in irregular beam waves. The computed time series of sway as well as the corresponding sway response spectrum compared favourably with model test measurements, demonstrating that this procedure to determine low-frequency damping can be effective.     

装载GPCTD传感器的海翼水下滑翔机观测数据实时质量控制

Profiles observed by Sea-Wing underwater gliders are widely applied in scientific research. However, the quality control(QC) of these data has received little attention. The mismatch between the temperature probe and conductivity cell response times generates erroneous salinities, especially across a strong thermocline. A sensor drift may occur owing to biofouling and biocide leakage into the conductivity cell when a glider has operated for several months. It is therefore critical to design a mature real-time QC procedure and develop a toolbox for the QC of Sea-Wing glider data. On the basis of temperature and salinity profiles observed by several Sea-Wing gliders each installed with a Sea-Bird Glider Payload CTD sensor, a real-time QC method including a thermal lag correction, Argo-equivalent real-time QC tests, and a simple post-processing procedure is proposed. The method can also be adopted for Petrel gliders.     

环胶州湾公路海上段汽车尾气的环境影响

对类比路段进行连续模拟试验,进行现场调查,给出汽车尾气主要污染物的排污强度,预测了汽车尾气中CO、C_nH_m和NO_x的扩散范围。     

On the fairing of resistance test data: A software-based approach

A fairing method is presented for giving a good representation of ship model resistance test data, which in general tend to exhibit a scattered trend and need to be smoothed appropriately. One component of the test data originates from the frictional resistance and can be formulated smoothly. The second component is the wave resistance which exhibits a specific harmonic character with peaks and troughs. In this method, this component is modelled using suitable harmonic cosine terms for obtaining the best representation of the corresponding resistance data. The performance of the method is then tested on two example cases, using the characteristic parameters of the sample data as input during the smoothing process.     

Wave reflection from partially perforated-wall caisson breakwater

In 1995, Suh and Park developed a numerical model that computes the reflection of regular waves from a fully perforated-wall caisson breakwater. This paper describes how to apply this model to a partially perforated-wall caisson and irregular waves. To examine the performance of the model, existing experimental data are used for regular waves, while a laboratory experiment is conducted in this study for irregular waves. The numerical model based on a linear wave theory tends to over-predict the reflection coefficient of regular waves as the wave nonlinearity increases, but such an over-prediction is not observed in the case of irregular waves. For both regular and irregular waves, the numerical model slightly over- and under-predicts the reflection coefficients at larger and smaller values, respectively, because the model neglects the evanescent waves near the breakwater.