Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Particulate organic matter in the coastal and estuarine waters of Goa and its relationship with phytoplankton production

In the coastal and estuarine waters of Goa, particulate organic carbon (POC) varied from 0.52 to 2.51 mg l^?1 and from 0.28 to 5.24 mg l^?1 and particulate phosphorus (PP) varied from 0.71 to 5.18 μg l^?1 and from 0.78 to 20.34 μg l^?1, respectively. The mean values of chlorophyll and primary productivity were 1.94 mg m^?3 and 938.1 mg C m^?2 day^?1 in the coastal waters and 4.3 mg m^?3 and 636.5 mg C m^?1 day^?1 in the estuarine waters, respectively.$\text{POC}\text{chl}$ ratios were low in June and October even when POC values were quite high. The POC in surface waters was linearly correlated with the chlorophyll content. Also PP increased when chlorophyll and primary productivity remained high. The results suggest that the phytoplankton was sharply increasing and contributed to POC and PP content. The percentage of detritus calculated from the intercept values of chlorophyll on POC varied from 46 to 76% depending on season. Results indicate that the major portion of POC and PP during postmonsoon (October–January) is derived from phytoplankton production while the allochthonous matter predominate during monsoon (June–September).     

Contribution of storms to groundwater recharge in the semi‐arid region of Karnataka,India

This paper describes the application of environmental isotopes and injected tracer techniques in estimating the contribution of storms as well as annual precipitation to groundwater recharge and its circulation, in the semi‐arid region of Bagepalli, Kolar district, Karnataka. Environmental isotopes ²H, ¹⁸O and ³H were used to study the effect of storms on the hydrological system, and an isotope balance was used to compute the contribution of a storm component to the groundwater. Some of the groundwater samples collected during the post‐storm periods were highly depleted in stable isotope content with higher deuterium excess relative to groundwater from the pre‐storm periods. Significant variation in deuterium excess in groundwater from the same area, collected in two different periods, indicates the different origin of air masses. The estimated recharge component of a storm event of 600 mm to the groundwater was found to be in the range of 117–165 mm. There was no significant variation in environmental tritium content of post‐storm and pre‐storm groundwater, indicating the fast circulation of groundwater in the system. After completion of the environmental isotope work, an injected radiotracer ³H technique was applied to estimate the direct recharge of total precipitation to the groundwater. The estimated recharge to the groundwater is 33 mm of the 550 mm annual precipitation during 1992. Copyright © 2003 John Wiley & Sons, Ltd.     

The solubility of iron sulphides in synthetic and natural waters at ambient temperature

A critical evaluation of literature values for the solubility products, K _sp ^NBS = [Fe²⁺][HS^–] Fe²⁺ HS^– (H _NBS ⁺ )^–1, of various iron sulphide phases results in consensus values for the pKs of 2.95 ± 0.1 for amorphous ferrous sulphide, 3.6 ± 0.2 for mackinawite, 4.4 ± 0.1 for greigite, 5.1 ± 0.1 for pyrrhotite, 5.25 ± 0.2 for troilite and 16.4 ± 1.2 for pyrite.Where the analogous ion activity products have been measured in anoxic freshwaters in which there is evidence for the presence of solid phase FeS, the values lie within the range of 2.6–3.22, indicating that amorphous iron sulphide is the controlling phase. The single value for a groundwater of 2.65 (2.98 considering carbonate complexation) agrees. In seawater four values range between 3.85 to 4.2, indicating that mackinawite or greigite may be the controlling phase. The single low value of 2.94 is in a situation where particularly high fluxes of Fe (II) and S (–II) may result in the preferential precipitation of amorphous iron sulphide. Formation of framboidal pyrite in these sulphidic environments may occur in micro-niches and does not appear to influence bulk concentrations. Calculations show that the formation of Fe₂S₂ species probably accounts for very little of the iron or sulphide in most natural waters. Previously reported stability constants for the formation of Fe (HS)₂ and (Fe (HS)₃)^– are shown to be suspect, and these species are also thought to be negligible in natural waters. In completely anoxic pore waters polysulphides also have a negligible effect on speciation, but in tidal sediments they may reach appreciable concentrations and lead to the direct formation of pyrite. Concentrations of iron and sulphide in pore waters can be controlled by the more soluble iron sulphide phase. The change in the IAP with depth within the sediment may reflect ageing of the solid phase or a greater flux of Fe (II) and S (–II) nearer the sediment surface. This possible kinetic influence on the value of IAPs has implications for their use in geochemical studies involving phase formation.     

Trichodesmium erythraeum (Ehrenberg) bloom along the southwest coast of India (Arabian Sea) and its impact on trace metal concentrations in seawater

The incidence of a large scale Trichodesmium erythraeum bloom along the southwest coast of India (Arabian Sea) observed in May 2005 is reported. Around 4802 filaments of T. erythraeum ml⁻¹ seawater was observed and a colony consisted of 3.6 × 10⁵ cells. The bloom was predominant off Suratkal (12° 59′N and 74° 31′E) with a depth of about 47 m, covering an area of 7 km in length and 2 km width. The concentrations of Zinc, Cadmium, Lead, Copper, Nickel and Cobalt were determined in samples collected from the bloom and non-bloom sites using stripping voltammetry. The observed hydrographical and meteorological parameters were found to be favorable for the bloom. The concentrations of Zinc, Cadmium and Nickel were found to be higher at bloom stations, while the concentrations of Lead, Copper and Cobalt were found to be very low at bloom stations. Elevated concentrations of Cadmium and Cobalt were observed at Valappad mainly due to the decomposition of detrital material produced in the bloom. Statistically significant differences (P > 0.01) in metal concentrations between the bloom and non-bloom stations were not observed except for Copper. Metals such as Lead, Copper and Cobalt were removed from the seawater at all places where bloom was observed. Cadmium was found to be slowly released during the decaying process of the bloom.     

The Deep-Water Peyssonnelia Beds from the Balearic Islands (Western Mediterranean)

Abstract. Peyssonnelia bed distribution on continental shelf bottoms of the Balearic Islands (Western Mediterranean) ranges from 40 to 90 m depth. Different species of Peyssonnelia dominate these bottoms and, according to multivariate techniques, two main assemblages have been distinguished: the Peyssonnelia rosa-marina beds and the Peyssonnelia sp. beds, together with some transition samples between Peyssonnelia and maërl beds. Erect red algae are always abundant. Although average yearly irradiance reaching these beds is only 6.4-0.3% of subsurface irradiance, the species richness averages 45 species per sample (1600 cm²) and mean biomass is 2835 g dw. m^-2. The high carbonate content of the living algae of these bottoms suggests that they are important contributors to the production of sediments in the Balearic continental shelf.     

The dynamic behaviour of a river-dominated tidal inlet, River Murray, Australia

Australia's largest river, the River Murray, discharges to the southern ocean through a coastal lagoon and river-dominated tidal inlet. Increased water extractions upstream for irrigation have led to significantly reduced flows at the mouth and, as a result, the area is undergoing rapid change, particularly with regard to the rate at which sediment is being transported into the lagoon. Based on detailed and accurate bathymetric surveys it has been possible to estimate that the rate of lagoon in-filling is of the order of 100,000 m³ per year for the period June 2000 to May 2003, although the actual rate shows significant year to year variability. Dredging of the lagoon commenced in 2000 in an attempt to reverse the trend.In an effort to understand the behaviour of the inlet a one-dimensional numerical model of the inlet has been developed. The model extends the original of van de Kreeke by including a dynamic inlet throat area based on predicted river flows and a sediment transport module to predict the resulting net sediment transport. Comparisons with water level data collected on both the ocean and lagoon sides of the mouth have shown that the model is able to predict the attenuation and lag of the tidal signal reasonably well. The sediment transport model was based on predicted sediment concentrations in the surf zone and was found to predict the rate of sediment in-filling to an acceptable level of accuracy. It is envisaged that the model will be a useful management tool, especially since it is possible to manipulate river discharges to the mouth.     

Comparison of two three-dimensional hydrodynamic modeling systems for coastal tidal motion

A comparison of two three-dimensional numerical modeling systems for tidal elevations and velocities in the coastal waters is presented. The two modeling systems are: (1) the Princeton Ocean Model (POM) and (2) the MIKE 3 flow model. The model performance results for Singapore's coastal waters show that the predicted tidal elevations from the two hydrodynamic modeling systems are almost identical and are in very good agreement with field measurement data. The simulated tidal current velocities match well with field measurement data at the selected stations, but it seems that the POM provides the slightly better simulation, compared to the MIKE 3 flow model. The depth profiles of the velocities obtained from the two modeling systems may be greatly different at some time, due to the vertical diffusion coefficient calculated from different turbulent sub-models in the two modeling systems. The POM generally predicts larger peak tidal velocities. The maximum speed differences for the model results from the two modeling systems occur in the top and differ from time to time and from location to location, reaching up to 20%.