海洋湍流的测量及相关分析

对海洋湍流速度脉动的一维概率密度作了测量，并把测量结果与高 斯分布进行了比较。比较的结果表明，一个接近于高斯分布而另一个却差别较 大。计算到直至五阶湍流相关函数并与网格湍流进行了比较，结果都表明小时 间间隔中测量结果与网格湍流的结果近似一致，而大时间间隔中却相差很大。 以上结论说明了较长的测量时间的必要性。     

龙口平均海平面变化原因的研究

本文通过对实测海平面高度的对比，发现龙口平均海平面从１９９１年起有明显的升高趋势。作者猜测此乃龙口在码头扩建后有系统下沉所致。     

海洋遥感四维测量应用

机载成象光谱仪遥感海洋是在轨星载海洋传感器定标校验的一种方法。本文研究了海洋航空遥感的四维测量方法，以及实现卫星、飞行遥感和船舶同步测量的重要意义。     

Inertial and hydrodynamic inertial loads on floating units

The analysis of the dynamic behavior of floating units usually employs a coordinate system with origin in the unit's center of gravity, which significantly simplifies the global mass matrix. Hydrodynamic coefficients are then computed considering the same coordinate system. However, to analyze other conditions of mass distribution and maintain the simplicity of a global mass matrix, it is necessary to determine again the hydrodynamic coefficients, thereby reducing the efficiency of the entire process. Another important point is that the geometries frequently used in floating units are such that the cross-terms of an added mass are relatively unimportant when compared with the main terms, and it is, therefore, common to use only some of them to analyze the unit's dynamic behavior. Recently, however, in the search for production systems suitable for water depths greater than 3000 m, other geometries have been considered in technical and economic feasibility studies. It is possible that for these new geometries all terms of the added mass matrix must be included in the analysis. This paper presents the full development used to determine the complete global mass matrix, the inertial and hydrodynamic inertial loads that make use of the added mass matrices considering any coordinate system and the six degrees of freedom, including all cross-terms.     

测量监理在轨道交通工程施工工法的应用

结合广州轨道交通工程的施工监理实际,论述轨道交通工程施工中不同工法的测量监理的因应措施,提出了测量监理工程师如何搞好本职工作、确保工程质量方法,总结了一套有效的轨道交通施工工法测量监理的宝贵经验。     

A comparative error analysis of manual versus automated methods of data acquisition for algebraic strain estimation

This paper presents a statistical analysis of the algebraic strain estimation algorithm of Shimamoto and Ikeda [Shimamoto, T., Ikeda, Y., 1976. A simple algebraic method for strain estimation from deformed eillipsoidal objects: 1. Basic theory. Tectonophysics 36, 315–337]. It is argued that the error in their strain estimation procedure can be quantified using an expected discrepancy measure. An analysis of this measure demonstrates that the error is inversely proportional to the number of clasts used. The paper also examines the role of measurement error, in particular that incurred under (i) a moment based and (ii) manual data acquisition methods. Detailed analysis of these two acquisition methods shows that in both cases, the effect of measurement error on the expected discrepancy is small relative to the effect of the sample size (number of objects). Given their relative speed advantage, this result favours the use of automated measurement methods even if they incur more measurement error on individual objects. Validation of these results is carried out by means of a simulation study, as well as by reference to studies appearing in previous literature. The results are also applied to obtain an upper bound on the error of strain estimation for various studies published in the literature on strain analysis.     

预应力张拉引起的环吊轨道变形测量数据精度统计方法

运用测量数据精度统计方法，分析某核电站一号核岛核反应堆厂房环吊轨道的测量数据，从测量学角度提出预应力张拉引起环吊轨道变形的结论。这种以测量理论研究建设工程中实际问题的方法，可供借鉴。     

Multi-reference evaluation of uncertainty in earth orientation parameter measurements

Uncertainties in polar motion and length-of-day measurements are evaluated empirically using several data series from the space-geodetic techniques of the global positioning system (GPS), satellite laser ranging (SLR), and very long baseline interferometry (VLBI) during 1997–2002. In the evaluation procedure employed here, known as the three-corner hat (TCH) technique, the signal common to each series is eliminated by forming pair-wise differences between the series, thus requiring no assumed values for the “truth” signal. From the variances of the differenced series, the uncertainty of each series can be recovered when reasonable assumptions are made about the correlations between the series. In order to form the pair-wise differences, the series data must be given at the same epoch. All measurement data sets studied here were sampled at noon (UTC); except for the VLBI series, whose data are interpolated to noon and whose UT1 values are also numerically differentiated to obtain LOD. The numerical error introduced to the VLBI values by the interpolation and differentiation is shown to be comparable in magnitude to the values determined by the TCH method for the uncertainties of the VLBI series. The TCH estimates for the VLBI series are corrupted by such numerical errors mostly as a result of the relatively large data intervals. Of the remaining data sets studied here, it is found that the IGS Final combined series has the smallest polar motion and length-of-day uncertainties.     

Wind and Wave Data Analysis for the Aegean Sea - Preliminary Results

In this paper, a statistical analysis on wind and wave buoy measurements and wind and wave model forecasts obtained during a two-year period (1999-2001) is presented with reference to four characteristic near-shore sites of the Aegean Sea. The measurements are a main product of the "POSEIDON" system aiming at the monitoring and forecasting of the state of the Greek seas, operated by the National Centre for Marine Research (NCMR). Although the two-year period is rather short for a thorough analysis of the local wind and wave climate, yet the obtained results, presented herein for the first time, reveal some interesting features of the corresponding wave and wind characteristics. Comparisons between the measurements and the forecast results are also performed at the locations under consideration. It is found that (i) wind speeds obtained from the POSEIDON weather forecasting system are, in general, in agreement with the measurements, except for high wind speeds which are systematically underestimated, (ii) the WAM model can successfully follow the monthly and over year trend of the evolution of wind and wave characteristics, but face significant problems for efficient sea-state forecasting. Finally, the overall pattern of the wind/wave climate for the entire Aegean Sea as obtained from the models is presented by means of the spatial distribution of the mean annual wind and sea-state intensity.     

Structure Functions In A Wall-Turbulent Shear Flow

Wavelet and quadrant analyses were applied to turbulent velocity data in order to investigate the transition from the anisotropy of energy-containing eddies to the isotropy of the inertial subrange scales. The quadrant analysis of the wavelet coefficients of longitudinal and vertical velocity components allows the evaluation of the velocity structure functions and the momentum cospectrum as a function of the separation distance and of the quadrants. In an isotropic condition the contribution both of ejections and sweeps (even quadrants), and both of reflections and deflections (odd quadrants), has to be equal. The analysis has shown that in neutrally stratified conditions the transition to isotropy occurs in a frequency range (0.2 < r/z < 3) usually referred to as internal to the inertial subrange (r is separation distance, z is height). In the transition region, as in the isotropic region, the velocity structure functions still agree with the 1941 and 1962 Kolmogorov theories; but on the other hand the structure functions of the even and odd quadrants are fitted by power laws of different slopes in the transition region. The proposed analysis allows the investigation within the transition region of the different dynamical structure in the energy transfer from the energy-containing scales to the isotropic scales.