AREAL DIFFERENTIATION AND CONSTRUCTION OF OASIS AGRICULTURAL ECOSYSTEM IN THE SHIYANG RIVER BASIN

On the basis of the study on areal differentiation of the natural environment of oasis agriculture ecosystems in the Shiyang River Basin, this paper comparatively analyzes the natural productivities, water economic benefits, production efficiency, ecological stabilities and developmental conditions of the Wuwei Oasis agricultural ecosystem in the middle reaches of the river basin and the Minqin Oasis agricultural ecosystem in the lower reaches. Under a same management level and investment of . material and energy, primary productiveness and economic benefits of the former are higher than those of the latter. Construction directions of Wuwei and Minqin oases should be different in order to alleviate the water- use contradiction between the middle and lower reaches. The construction objective of Wuwei Oasis should be efficient irrigated farming production system and Minqin Oasis should become a mixed forestry-pastoral-farming ecosystem taking ecological protection as its major function.     

Experimental constraints on the effects of pressure and H2O on the fractional crystallization of high-Mg island arc basalt

H₂O-undersaturated melting experiments of synthesized basalt (SiO₂ = 50.7 wt.%, MgO = 8.3 wt.%, Mg# = 60) were conducted at fO₂ corresponding to NNO+1 and NNO−1 to clarify the effects of pressure (2–7 kbar) and H₂O on fractional crystallization in island arcs. H₂O content was ranged from nominally anhydrous to 4.4 wt.%. Differentiation trends, namely the liquid lines of descent, change sensitively according to pressure-H₂O relations. Tholeiitic differentiation trends are reproduced with H₂O ≤ ∼2 wt.% in primary magma. With such quantities of H₂O, fractional crystallization is controlled by olivine + plagioclase at 2 kbar. Increasing the pressure from 2 to ≥4 kbar induces early crystallization of orthopyroxene instead of olivine and therefore SiO₂ enrichment in the residual melts is suppressed. Increasing H₂O (≥ ∼2 wt.% in primary magma) stabilizes clinopyroxene relative to orthopyroxene and/or magnetite. Although the phase relations and proportions strongly depend on fO₂ and H₂O content, differentiation trends are always calc-alkaline.     

Global Correlations of Ocean Ridge Basalt Chemistry with Axial Depth: a New Perspective

The petrological parameters Na₈ and Fe₈, which are Na₂O andFeO contents in mid-ocean ridge basalt (MORB) melts correctedfor fractionation effects to MgO = 8 wt%, have been widely usedas indicators of the extent and pressure of mantle melting beneathocean ridges. We find that these parameters are unreliable.Fe₈ is used to compute the mantle solidus depth (P_o) and temperature(T_o), and it is the values and range of Fe₈ that have led tothe notion that mantle potential temperature variation of T_P= 250 K is required to explain the global ocean ridge systematics.This interpreted T_P = 250 K range applies to ocean ridges awayfrom ‘hotspots’. We find no convincing evidencethat calculated values for P_o, T_o, and T_P using Fe₈ have anysignificance. We correct for fractionation effect to Mg^# = 0·72,which reveals mostly signals of mantle processes because meltswith Mg^# = 0·72 are in equilibrium with mantle olivineof Fo_89·6 (vs evolved olivine of Fo_{88·1–79·6}in equilibrium with melts of Fe₈). To reveal first-order MORBchemical systematics as a function of ridge axial depth, weaverage out possible effects of spreading rate variation, local-scalemantle source heterogeneity, melting region geometry variation,and dynamic topography on regional and segment scales by usingactual sample depths, regardless of geographical location, withineach of 22 ridge depth intervals of 250 m on a global scale.These depth-interval averages give Fe₇₂ = 7·5–8·5,which would give T_P = 41 K (vs 250 K based on Fe₈) beneathglobal ocean ridges. The lack of Fe₇₂–Si₇₂ and Si₇₂–ridgedepth correlations provides no evidence that MORB melts preservepressure signatures as a function of ridge axial depth. We thusfind no convincing evidence for T_P > 50 K beneath globalocean ridges. The averages have also revealed significantcorrelations of MORB chemistry (e.g. Ti₇₂, Al₇₂, Fe₇₂,Mg₇₂, Ca₇₂, Na₇₂ and Ca₇₂/Al₇₂) with ridge axial depth. Thechemistry–depth correlation points to an intrinsic linkbetween the two. That is, the 5 km global ridge axial reliefand MORB chemistry both result from a common cause: subsolidusmantle compositional variation (vs T_P), which determines themineralogy, lithology and density variations that (1) isostaticallycompensate the 5 km ocean ridge relief and (2) determine thefirst-order MORB compositional variation on a global scale.A progressively more enriched (or less depleted) fertileperidotite source (i.e. high Al₂O₃ and Na₂O, and low CaO/Al₂O₃)beneath deep ridges ensures a greater amount of modal garnet(high Al₂O₃) and higher jadeite/diopside ratios in clinopyroxene(high Na₂O and Al₂O₃, and lower CaO), making a denser mantle,and thus deeper ridges. The dense fertile mantle beneath deepridges retards the rate and restricts the amplitude of the upwelling,reduces the rate and extent of decompression melting, givesway to conductive cooling to a deep level, forces melting tostop at such a deep level, leads to a short melting column,and thus produces less melt and probably a thin magmatic crustrelative to the less dense (more refractory) fertile mantlebeneath shallow ridges. Compositions of primitive MORB meltsresult from the combination of two different, but geneticallyrelated processes: (1) mantle source inheritance and (2) meltingprocess enhancement. The subsolidus mantle compositional variationneeded to explain MORB chemistry and ridge axial depth variationrequires a deep isostatic compensation depth, probably in thetransition zone. Therefore, although ocean ridges are of shalloworigin, their working is largely controlled by deep processesas well as the effect of plate spreading rate variation at shallowlevels. KEY WORDS: mid-ocean ridges; mantle melting; magma differentiation; petrogenesis; MORB chemistry variation; ridge depth variation; global correlations; mantle compositional variation; mantle source density variation; mantle potential temperature variation; isostatic compensation     

南海带鱼遗传变异及其分类的研究

带鱼是我国海洋鱼类中最重要的经济鱼类,过去进行了大量的研究,多认为中国近海的带鱼为一个种,而不同的学者分别认为存在3,4和5个种群。从1976年开始,我们试图主要用生化方法并结合形态学资料研究带鱼的分类。1983和1988年报道了我们通过带鱼肌浆蛋白和形态学部分资料的研究认为中国近海带     

山东近海牙鲆(Paralichthys olivaceus)自然和养殖群体10个微卫星基因座位的遗传多态性分析

采用微卫星遗传标记技术对山东近海牙鲆自然群体和养殖群体的遗传多样性进行了研究。实验所用牙鲆于2003年5月分别采自山东近海和青岛胶南养鱼场，各20尾，取全血或肌肉组织，以酚-仿抽提方法提取基因组DNA，利用筛选获得的10对微卫星引物进行PCR扩增，反应产物经8％非变性聚丙烯酰胺凝胶电泳分离、EB显色，用ImageMasterl D Elite(Version 3．01)软件分析电泳结果，并计算了相应的遗传学参数。结果表明，在自然和养殖群体中，10个基因座位的等位基因平均数(α)分别为6．7和6．1，每个基因座位有效等位基因数(αe)分别为1．8—6．8和2．5—6．7，群体平均杂合度(H)分别为0．8120和0．7310；两个群体间的遗传相似性系数、遗传距离和基因分化系数为0．8558、0．1557和0．0558；自然群体内每个座位上的多态信息含量(PIC)为0．59—0．84、个体识别率(DP)为0．54—0．86、非父排除率(PPE)为0．41—0．72，其累积个体识别率和非父排除率均达到0．9999，表明所选座位属中高识别力的遗传标记，可以将它们应用于今后牙鲆雌核发育群体的遗传变异分析以及进一步的遗传育种的研究中。     

中华乌塘鳢的群体生物学研究 Ⅱ.生化遗传变异

用同工酶谱法发现中华乌塘鳢Bostrichthy sinensis四个群体的遗传变异水平很低,在所检测的30个基因座位中,多态座位比例只有0—10％,平均杂合度仅为0.2—0.5％,物种的平均杂合度为0.33±0.10％。四个群体共享常见的等位基因。虽然其中三个群体拥有特有的等位基因,但其基因频率都未超过5％。四个群体的Nei氏遗传距只有1.68—12.13×10~(-5)。据分析,近交可能是遗传变异水平低和形态特征分化差的主要原因。种苗生产上应注意广泛采集不同地理群体的鱼作亲鱼,以丰富养殖群体的基因库。     

Molecular identification of bloom-forming species Phaeocystis globosa (Pryninesiophyta) and its dispersal based on rDNA ITS sequence analysis

The colony-forming Phaeocystis species are causative agents of dense bloom occurrences in coastal waters worldwide. It is difficult to separate them because of the different morphologies associated with their colonial stages. In this study we applied molecular approaches to analyze the genetic variation of Phaeocystis globosa and Phaeocystis pouchetii from several geographic regions, and to assist in tracing the dispersal of bloom-forming Phaeocystis species in coastal waters of China. The sequences of the internal transcribed spacers (ITS1 and ITS2) of rDNA and the 5.8S ribosomal RNA gene of Phaeocystis strains were determined. Sequence comparison shows that P.globosa was the most divergent to P. pouchetii, exhibiting sequence divergence higher than 0.08. However, lower genetic divergences existed between strains of P.globosa. The sequence comparison of the Phaeocystis rDNA ITS clearly shows that the species isolated from the southeast coast of China is identified as P.globosa rather than P. cf. pouchetii or other species. Furthermore, the significance of rDNA variation in distinct global populations of P.globosa suggested it might have had sufficient time to accumulate detectable mutations at the rDNA locus, supporting the hypothesis of ancient dispersal of P.globosa to many areas, meaning that P.globosa blooms in the coastal waters of China are endemic rather than a newly introduced species or a foreign source. Finally, based on the high divergent region of rDNA ITS, a pair of species-specific primers for P.globosa were designed, they could be useful to detect the presence of this species in mixed plankton assemblages or flagellate stages that are recognized with diffculties by means of conventional microscopy.     

Geoacoustic Inversion via Genetic Algorithm and Its Application to Manganese Sediment Identification

An acoustic inversion method using a wide-band signal and two near field receivers is proposed and applied to multiple layered seabed models including a manganese sediment. The inversion problem can be formulated into a probabilistic model comprised of signals, a forward model, and additive noise. The forward model simulates wide-band signals, such as chirp signals, and is chosen to be the source-waveletconvolution plane wave modeling method. The wavelet matching technique, using weighted least-squares fitting, estimates the sediment sound-speed and thickness on which determination of the possible numerical ranges for a priori uniform distribution is based. The genetic algorithm is applied to a global optimization problem to find a maximum a posteriori solution for determined a priori search space. Here the object function is defined by an L 2 norm of the difference between measured and modeled signals. Not only the marginal pdf but also its statistics are calculated by numerical evaluation of integrals using the samples selected during importance sampling process of the genetic algorithm.     

Mooring optimization of floating platforms using a genetic algorithm

This paper presents a new procedure for the optimization of the mooring design of floating platforms, in which an automatic design sequence is also established. Regarding the optimization philosophy, the following aspects are dealt with:

• The optimization of the platform heading and its mooring pattern, taking into account the environmental force spreading;

• optimum line length or line tension for each mooring line, associated to the optimization of the mooring line materials and sizes.

Basically, the main goal of this paper is to introduce a new method, which will provide the quickest way to find the best mooring system, defined here as that which minimizes platform responses.A genetic algorithm (GA) is applied in this contribution, and this paper describes exactly the procedure of developing a GA code directed toward the solution of mooring design optimization problems. In order to prove the efficiency and the vast potential of the proposed algorithm as a design tool, sample moorings are analyzed for different environmental conditions and the final results, including the time required to run them, are presented.     

弧后盆地的形成与演化探讨：以东亚陆缘区为例

通过对弧后盆地大地构造体制的讨论，作者认为基属活化作用的产物根据地质，地球物理，地球化学等资料的分析，作者提出结论认为，由于东亚岛弧系岩石圈的均衡作用及海沟外侧冷却大洋岩石圈块体的下沉拖曳牵引等作用，使软流圈在岛弧系下方发生分异，这种分异作用带动东亚陆缘向东扩张，从而产生弧后的张开。