Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Ultrahigh pressure macro diamonds from Copeton (New South Wales, Australia), based on Raman spectroscopy of inclusions

Mining of Cenozoic alluvial deposits at Copeton and Bingara (Eastern Australia) has produced two million macrodiamonds (0.25 ct median size). Raman spectroscopy is used to identify included minerals within uncut Copeton diamonds, with sealed chamber remnant pressures of 31.7 to 35.6 kbar for coesite, 13.6 and 22.7 kbar for clinopyroxene, and 7.6 kbar for grossular garnet. Assuming elastic behaviour, these values generate inclusion entrapment PT loci which intersect, restricting diamond formation conditions: from 250 °C, 43 kbar to 800 °C, 52 kbar. Larger than error (± 100 °C and ± 4 kbar), this range shows a systematic variation in inclusion composition with diamond zoning and N properties. Published research shows 1) Copeton and Bingara diamonds are unique, and 2) modern alluvium in the Bingara district carries mantle-formed garnet, captured by post-tectonic alkali basalt from an extensive diamondiferous ultrahigh pressure (UHP) terrane that stalled at depth because it is dominated by mafic eclogite. The combined Raman and geological results indicate two sets of subduction UHP diamond formation conditions/protolith are required, firstly cooler oceanic slab and secondly including higher temperature continental crust. The Copeton and Bingara stones are UHP macrodiamonds, and Carboniferous ⁴⁰Ar/³⁹Ar age dates on clinopyroxene inclusions should be interpreted as ages of crystallisation, representing the termination of subduction. The characteristic features of ruptured inclusions and etched percussion marks on Copeton and Bingara diamond indicate volcanic delivery to the earth's surface. Alluvial deposits elsewhere in Eastern Australia may carry similar diamond along with diamond of different origin.     

近190ka BP以来菲律宾海黑潮源区的碳酸盐旋回及其控制因素

对取自西菲律宾海黑潮源区的Ph05-5和WF3岩芯进行了CaCO3和钙质超微化石研究.在利用氧同位素曲线对比和AMS14C数据进行地层划分的基础上,结合钙质超微化石的碳酸盐溶解指数和初级生产力指标,分析了晚第四纪黑潮源区碳酸盐旋回特征及其控制因素.约190ka BP以来CaCO3含量整体上都表现为冰期高、间冰期低的"太平洋型"旋回特征,但菲律宾以东海区在末次冰期(MIS 4到MIS 2期)内部又显示出间冰段含量高、冰段含量低的"大西洋型"旋回特征.碳酸盐旋回的控制因素在黑潮源区内部也有明显的差异,菲律宾以东海区以碳酸盐溶解作用为主,初级生产力起次要作用;而台湾东南部海区的主要因素则是初级生产力变化引起的钙质生物输入量的波动.菲律宾以东海区末次冰期内部表现出的"大西洋型"旋回特征则是溶解作用和初级生产力共同影响的结果.     

黄河三角洲沿岸及邻近海区细粒沉积物中的碳酸盐

本文用X-射线衍射法直接计算了来自黄河三角洲沿岸及邻近海区80个沉积样的细粒组分(<2μm)中的碳酸盐含量。计算结果与全样的容量法分析结果基本一致。研究结果表明,本区细粒沉积物中碳酸盐含量变化受沉积物来源、海区水动力作用、海底地貌特征和碳酸盐的地球化学行为等因素所影响。     

Formation of ‘Beach Rock’ at Siesta Key, Florida and its influence on barrier island development

Seaward-dipping strata of carbonate-cemented shell debris located along the coast of Siesta Key on the Gulf Coast of the Florida peninsula have long been interpreted to be beachrock equivalent in age to the Pleistocene Anastasia Formation (Stage 5e) of the east coast of Florida. Detailed examination of thin sections along with radiometric dating and isotopic analyses demonstrates clearly that this is a Holocene deposit that is not beachrock but was lithified in a meteoric environment. Whole rock dates, dates from shells only, and from cement only demonstrate that these beach deposits were in place by at least 1800 yr BP and might have been there as long ago as 4300 yr BP. This means that some type of barrier island was in place at that time. Previous investigations have depicted Siesta Key as having a maximum age of 3000 yr with these deposits being located about 2 km landward of the beach deposits. This suggests that the beach deposits might have been the site of the original position of Siesta Key. These data also indicate that sea level must have been near its present position at the time that these foreshore beach deposits were deposited; sometime between 1800 and 4300 yr ago. This scenario indicates that sea level along this coastal reach probably reached its present level at least about 2000 yr ago.     

南沙群岛海区晚第四纪碳酸盐沉积

本文研究了五个柱状沉积物的碳酸盐沉积。根据沉积物的陆源碎屑和生物骨屑ＣａＣＯ３沉积作用的特点，把本区沉积物分为五种沉积类；碳酸盐生物组成的门类较多，以有孔虫为主，其次为珊瑚，腹足类等；碳酸盐矿物以低镁方解石为主，还有高镁方解石和文石；与沉积物中ＣａＣＯ３有关的化学元素１０多种。这些元素和稀土元素的含量，比值等，是区分礁相，礁体过渡带和非礁相的标志。所有这些碳酸盐沉积作用的特点表明，区内存在着五种沉     

深层搅拌法在超软弱港口地基上的工程应用

某港口堆场地基上部5．0m系吹填而成，地表下18m范围均属软土，经真空预压初级加固后地基承载力仅在80—90kPa，局部区域上部淤泥土层土性指标较差，含水量大于50％，地基承载力不足60kPa。为了使地基达到230kPa的承载要求，设计采用深层搅拌法加固超软弱地基。通过现场成桩工艺试验和检测表明，桩身水泥土强度在90d龄期时大于1．80MPa，单桩承载力标准值大于150kN，以φ600桩径、桩长13．5m、置换率为0．308和φ500桩径、桩长13．5m、置换率为0．267两种方案布置的复合地基承载力标准值均超过了230kPa的设计要求。试验结果表明，深层搅拌法在港口超软弱地基土应用只要施工工艺适当，完全可以使地基承载力提高2—3．5倍以土，从而节省大量的工程投资。     

Carbon and oxygen isotopic composition of car- bonate cements of different phases in terrigenous siliciclastic reservoirs and significance for their origin： A case study from sandstones of the Triassic Yanchang Formation, southwestern Ordos Basin, China

Early carbonate cements in the Yanchang Formation sandstones are composed mainly of calcite with relatively heavier carbon isotope （their δ^18O values range from -0.3‰- -0.1‰） and lighter oxygen isotope （their δ^18O values range from -22.1‰- -19.5‰）. Generally, they are closely related to the direct precipitation of oversaturated calcium carbonate from alkaline lake water. This kind of cementation plays an important role in enhancing the anti-compaction ability of sandstones, preserving intragranular volume and providing the mass basis for later disso- lution caused by acidic fluid flow to produce secondary porosity. Ferriferous calcites are characterized by relatively light carbon isotope with δ^13C values ranging from -8.02‰ to -3.23‰, and lighter oxygen isotope with δ^18O values ranging from -22.9‰ to -19.7‰, which is obviously related to the decarboxylation of organic matter during the late period of early diagenesis to the early period of late diagenesis. As the mid-late diagenetic products, ferriferous cal- cites in the study area are considered as the characteristic authigenic minerals for indicating large-scaled hydrocarbon influx and migration within the clastic reservoir. The late ankerite is relatively heavy in carbon isotope with δ^13C values ranging from -1.92‰ to -0.84‰, and shows a wide range of variations in oxygen isotopic composition, with δ^18O values ranging from -20.5‰ to -12.6‰. They are believed to have nothing to do with decarboxylation, but the previously formed marine carbonate rock fragments may serve as the chief carbon source for their precipitation, and the alkaline diagenetic environment at the mid-late stage would promote this process.     

Evaluation of distributed recharge in an upland semi-arid karst system: the West Bank Mountain Aquifer,Middle East

Assessment of recharge in a structurally complex upland karst limestone aquifer situated in a semi-arid environment is difficult. Resort to surrogate indicators such as measurement of spring outflow and borehole discharge, is a common alternative, and attempts to apply conventional soil moisture deficit analysis may not adequately account for the intermittent spate conditions that arise in such environments. A modelling approach has been made using the West Bank Mountain Aquifer system in the Middle East as a trial. The model uses object oriented software which allows various objects to be switched on and off. Each of the main recharge processes identified in the West Bank is incorporated. The model allows either conventional soil moisture deficit analysis calculations or wetting threshold calculations to be made as appropriate, and accommodates both direct recharge and secondary recharge. Daily time steps enable recharge and runoff routing to be calculated for each node. Model runs have enabled a series of simulations for each of the three aquifer basins in the West Bank and for the whole of the West Bank. These provide recharge estimates comparable to those prepared by earlier workers by conventional means. The model is adaptable and has been successfully used in other environments.     

Estimation of hydraulic permeability considering the micro morphology of rocks of the borehole YAXCOPOIL-1 (Impact crater Chicxulub,Mexico)

Internal surface, formation factor, Nuclear Magnetic Resonance (NMR)-T2 relaxation times and pore radius distributions were measured on representative core samples for the estimation of hydraulic permeability. Permeability is estimated using various versions of the classic Kozeny–Carman-equation (K–C) and a further development of K–C, the fractal PaRiS-model, taking into account the internal surface. In addition to grain and pore size distribution, directly connected to permeability, internal surface reflects the internal structure (“micro morphology”). Lithologies could be grouped with respect to differences in internal surface. Most melt rich impact breccia lithologies exhibit large internal surfaces, while Tertiary post-impact sediments and Cretaceous lithologies in displaced megablocks display smaller internal surfaces. Investigations with scanning electron microscopy confirm the correlation between internal surface and micro morphology. In addition to different versions of K–C, estimations by means of NMR, pore radius distributions and some gas permeability measurements serve for cross-checking and calibration. In general, the different estimations from the independent methods and the measurements are in satisfactory accordance. For Tertiary limestones and Suevites bulk with very high porosities (up to 35%) permeabilites between 10⁻¹⁴ and 10⁻¹⁶ m² are found, whereas in lower Suevite, Cretaceous anhydrites and dolomites, bulk permeabilites are between 10⁻¹⁵ and 10⁻²³ m².