The Bear Brook Watershed in Maine: Multi-decadal whole-watershed experimental acidification

The Bear Brook Watershed in Maine (BBWM) is a long-term research site established to study the response of forest ecosystem function to environmental disturbances of chronic acidic deposition and ecosystem nitrogen enrichment. Starting in 1989, the West Bear (treated) watershed received bimonthly applications of ammonium sulfate [(NH₄)₂SO₄] fertilizer from above the canopy, whereas East Bear (reference) received ambient deposition. The treatments were stopped in 2016, marking the beginning of the recovery phase. Research at the site has focused on soils, streams, and vegetation. Here, we describe data collected over three decades at the BBWM—input and stream output nutrient fluxes, quantitative soil pits and soil chemistry, and soil temperature and moisture.     

Modelling the effect of changing precipitation inputs on deep soil water utilization

Forests in the Southeastern United States are predicted to experience future changes in seasonal patterns of precipitation inputs as well as more variable precipitation events. These climate change‐induced alterations could increase drought and lower soil water availability. Drought could alter rooting patterns and increase the importance of deep roots that access subsurface water resources. To address plant response to drought in both deep rooting and soil water utilization as well as soil drainage, we utilize a throughfall reduction experiment in a loblolly pine plantation of the Southeastern United States to calibrate and validate a hydrological model. The model was accurately calibrated against field measured soil moisture data under ambient rainfall and validated using 30% throughfall reduction data. Using this model, we then tested these scenarios: (a) evenly reduced precipitation; (b) less precipitation in summer, more in winter; (c) same total amount of precipitation with less frequent but heavier storms; and (d) shallower rooting depth under the above 3 scenarios. When less precipitation was received, drainage decreased proportionally much faster than evapotranspiration implying plants will acquire water first to the detriment of drainage. When precipitation was reduced by more than 30%, plants relied on stored soil water to satisfy evapotranspiration suggesting 30% may be a threshold that if sustained over the long term would deplete plant available soil water. Under the third scenario, evapotranspiration and drainage decreased, whereas surface run‐off increased. Changes in root biomass measured before and 4 years after the throughfall reduction experiment were not detected among treatments. Model simulations, however, indicated gains in evapotranspiration with deeper roots under evenly reduced precipitation and seasonal precipitation redistribution scenarios but not when precipitation frequency was adjusted. Deep soil and deep rooting can provide an important buffer capacity when precipitation alone cannot satisfy the evapotranspirational demand of forests. How this buffering capacity will persist in the face of changing precipitation inputs, however, will depend less on seasonal redistribution than on the magnitude of reductions and changes in rainfall frequency.     

Evaluating soil water routing approaches in watershed-scale,ecohydrologic modelling

Soil water dynamics are central in linking and regulating natural cycles in ecohydrology, however, mathematical representation of soil water processes in models is challenging given the complexity of these interactions. To assess the impacts of soil water simulation approaches on various model outputs, the Soil and Water Assessment Tool was modified to accommodate an alternative soil water percolation method and tested at two geographically and climatically distinct, instrumented watersheds in the United States. Soil water was evaluated at the site scale via measured observations, and hydrologic and biophysical outputs were analysed at the watershed scale. Results demonstrated an improved Kling–Gupta Efficiency of up to 0.3 and a reduction in percent bias from 5 to 25% at the site scale, when soil water percolation was changed from a threshold, bucket-based approach to an alternative approach based on variable hydraulic conductivity. The primary difference between the approaches was attributed to the ability to simulate soil water content above field capacity for successive days; however, regardless of the approach, a lack of site-specific characterization of soil properties by the soils database at the site scale was found to severely limit the analysis. Differences in approach led to a regime shift in percolation from a few, high magnitude events to frequent, low magnitude events. At the watershed scale, the variable hydraulic conductivity-based approach reduced average annual percolation by 20–50 mm, directly impacting the water balance and subsequently biophysical predictions. For instance, annual denitrification increased by 14–24 kg/ha for the new approach. Overall, the study demonstrates the need for continued efforts to enhance soil water model representation for improving biophysical process simulations.     

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.     

Revisiting the existence of an effective stress for wet granular soils with micromechanics

A possible effective stress variable for wet granular materials is numerically investigated based on an adapted discrete element method (DEM) model for an ideal three‐phase system. The DEM simulations consider granular materials made of nearly monodisperse spherical particles, in the pendular regime with the pore fluid mixture consisting of distinct water menisci bridging particle pairs. The contact force‐related stress contribution to the total stresses is isolated and tested as the effective stress candidate for dense or loose systems. It is first recalled that this contact stress tensor is indeed an adequate effective stress that describes stress limit states of wet samples with the same Mohr‐Coulomb criterion associated with their dry counterparts. As for constitutive relationships, it is demonstrated that the contact stress tensor used in conjunction with dry constitutive relations does describe the strains of wet samples during an initial strain regime but not beyond. Outside this so‐called quasi‐static strain regime, whose extent is much greater for dense than loose materials, dramatic changes in the contact network prevent macroscale contact stress‐strain relationships to apply in the same manner to dry and unsaturated conditions. The presented numerical results also reveal unexpected constitutive bifurcations for the loose material, related to stick‐slip macrobehavior.     

The Upper Devonian Kellwasser event recorded in a regressive sequence from inner shelf to lagoonal pond,Catalan Coastal Ranges,Spain

This study, conducted in the Catalan Coastal Ranges, north‐east Spain, describes the Upper Devonian Kellwasser event in a shallowing‐upward sequence of black shales, siltstones and quartz arenites. This sequence was deposited in a progradational and regressive coastal system where the sedimentary environment evolved from the inner shelf to a lagoonal pond located landward of the shoreline. Three anomalous succeeding steps have been identified by geochemical analysis. The first one, detected on the inner shelf, was characterized by oxygen depletion and high organic productivity. The second, detected in the nearshore, was caused by hydrothermal activity occurring under normal oxic conditions. The third and most intense step was identified in the muds of the lagoonal pond and has been linked to strong anoxic conditions, elevated clastic input derived from changes in the weathering regime at the source area and moderate hydrothermal activity. The Kellwasser event is thus defined in the study area as stepwise and multi‐causal. This is the first time that the Kellwasser event has been identified in a sedimentary environment behind the shoreline. It is also the first time that it has been reported in the Catalan Coastal Ranges.     

基于噪声谱比法的内蒙古西部地区台站场地响应研究

利用内蒙古西部12个台站的地脉动噪声数据，采用噪声谱比法研究台站的场地响应情况。分析表明，台站场地响应按曲线形态可分为3类，且可能受地形地貌、局部构造和台基状况等条件影响。对比分析噪声谱比法与Moya方法的场地响应结果发现，场地响应曲线形态基本一致，只有极少数台站存在明显差异。结果表明，内蒙古西部区域大部分台站的台基状况总体较好，场地响应曲线较为平坦，无明显频率放大点。     

黑龙江哈尔滨白渔泡国家湿地公园沼泽、林地和农田土壤物理、化学和生物性质差异

为了揭示黑龙江哈尔滨白渔泡国家湿地公园沼泽、林地和农田土壤物理、化学和生物性质的差异,于2018年7月25日~8月2日,在湿地公园内,在天然芦苇(Phragmites australis)沼泽、林地、旱田和水田中设置采样地,采集不同深度(0~10 cm、10~20 cm和20~30 cm)的土壤样品,测定土壤样品的物理、化学和生物指标。研究结果表明,白渔泡国家湿地公园不同采样地土壤指标存在差异;与天然芦苇沼泽土壤相比,其它采样地土壤的含水量明显偏低,土壤全氮、全磷、碱解氮和有机质含量都明显偏小,水田土壤速效磷含量偏大;天然芦苇沼泽土壤脲酶、硝酸还原酶、纤维素酶、蛋白酶和β-葡萄糖苷酶活性都高于林地和农田土壤,水田0~10 cm和10~20 cm深度土壤的硝酸还原酶活性显著高于旱田和林地;与天然芦苇沼泽土壤相比,旱田土壤小于0.25 mm的小团聚体含量偏大,而其它采样地土壤的各粒级团聚体的比例变化较小,水田土壤团聚体平均重量直径比天然芦苇沼泽和旱田土壤低。     

一种有发展前景的隧道及井巷超前预报技术——电磁导弹探测技术

对于隧道和煤矿井巷的安全掘进 ,超前预报显得特别重要。但由于掌子面前的特殊环境限制及多种干扰的严重影响 ,给隧道及井巷超前预报技术的研究带来许多困难。在瞬变电磁理论的基础上 ,引入新的电磁传播理论———电磁导弹技术 ,作为对该技术的初步探索 ,文章论证了该技术在隧道超前预报中应用的可能性 ,并提出了研究的主要内容和发展方向以及可能取得的新的技术突破和技术支撑