内蒙古正蓝旗羊蹄子山-磨石山钛矿区硅质岩地球化学特征及沉积环境意义

文章通过详细的野外地质调查和系统的岩石化学、稀土元素、微量元素及硅、氧同位素等研究,探讨了羊蹄子山-磨石山钛矿区无矿白色硅质岩和富钛硅质岩的成因及形成地质构造环境。研究结果表明,呈厚层状产出的无矿白色硅质岩具较高的SiO2、Al2O3含量及Al/(Al Fe Mn)、Al2O3/(Al2O3 Fe2O3)比值,稀土元素总量很低,其北美页岩标准化配分模式为向右倾的曲线,无明显铈异常和铕异常,表明其形成于受陆源影响的大陆边缘构造环境;赋矿岩系中薄层状富钛硅质岩的TiO2、Fe2O3、Cu、V含量较高,但Al/(Al Fe Mn)、Al2O3/(Al2O3 Fe2O3)比值较低,稀土元素总量较高,北美页岩标准化曲线为明显左倾型-平坦型,具弱的负铈异常,表明其形成于洋脊及附近环境。两种硅质岩的δ30Si值为变化较小的负值,与热水沉积和某些生物成因硅质岩的硅同位素组成相似,两者的δ18O值范围和平均值均相似。两类硅质岩的成因及形成构造环境不同,富钛硅质岩的地球化学特征表明,该矿床的形成与本区元古宙海底火山热液喷流作用有关。     

Formation of ‘Beach Rock’ at Siesta Key, Florida and its influence on barrier island development

Seaward-dipping strata of carbonate-cemented shell debris located along the coast of Siesta Key on the Gulf Coast of the Florida peninsula have long been interpreted to be beachrock equivalent in age to the Pleistocene Anastasia Formation (Stage 5e) of the east coast of Florida. Detailed examination of thin sections along with radiometric dating and isotopic analyses demonstrates clearly that this is a Holocene deposit that is not beachrock but was lithified in a meteoric environment. Whole rock dates, dates from shells only, and from cement only demonstrate that these beach deposits were in place by at least 1800 yr BP and might have been there as long ago as 4300 yr BP. This means that some type of barrier island was in place at that time. Previous investigations have depicted Siesta Key as having a maximum age of 3000 yr with these deposits being located about 2 km landward of the beach deposits. This suggests that the beach deposits might have been the site of the original position of Siesta Key. These data also indicate that sea level must have been near its present position at the time that these foreshore beach deposits were deposited; sometime between 1800 and 4300 yr ago. This scenario indicates that sea level along this coastal reach probably reached its present level at least about 2000 yr ago.     

深层搅拌法在超软弱港口地基上的工程应用

某港口堆场地基上部5．0m系吹填而成，地表下18m范围均属软土，经真空预压初级加固后地基承载力仅在80—90kPa，局部区域上部淤泥土层土性指标较差，含水量大于50％，地基承载力不足60kPa。为了使地基达到230kPa的承载要求，设计采用深层搅拌法加固超软弱地基。通过现场成桩工艺试验和检测表明，桩身水泥土强度在90d龄期时大于1．80MPa，单桩承载力标准值大于150kN，以φ600桩径、桩长13．5m、置换率为0．308和φ500桩径、桩长13．5m、置换率为0．267两种方案布置的复合地基承载力标准值均超过了230kPa的设计要求。试验结果表明，深层搅拌法在港口超软弱地基土应用只要施工工艺适当，完全可以使地基承载力提高2—3．5倍以土，从而节省大量的工程投资。     

Carbon and oxygen isotopic composition of car- bonate cements of different phases in terrigenous siliciclastic reservoirs and significance for their origin： A case study from sandstones of the Triassic Yanchang Formation, southwestern Ordos Basin, China

Early carbonate cements in the Yanchang Formation sandstones are composed mainly of calcite with relatively heavier carbon isotope （their δ^18O values range from -0.3‰- -0.1‰） and lighter oxygen isotope （their δ^18O values range from -22.1‰- -19.5‰）. Generally, they are closely related to the direct precipitation of oversaturated calcium carbonate from alkaline lake water. This kind of cementation plays an important role in enhancing the anti-compaction ability of sandstones, preserving intragranular volume and providing the mass basis for later disso- lution caused by acidic fluid flow to produce secondary porosity. Ferriferous calcites are characterized by relatively light carbon isotope with δ^13C values ranging from -8.02‰ to -3.23‰, and lighter oxygen isotope with δ^18O values ranging from -22.9‰ to -19.7‰, which is obviously related to the decarboxylation of organic matter during the late period of early diagenesis to the early period of late diagenesis. As the mid-late diagenetic products, ferriferous cal- cites in the study area are considered as the characteristic authigenic minerals for indicating large-scaled hydrocarbon influx and migration within the clastic reservoir. The late ankerite is relatively heavy in carbon isotope with δ^13C values ranging from -1.92‰ to -0.84‰, and shows a wide range of variations in oxygen isotopic composition, with δ^18O values ranging from -20.5‰ to -12.6‰. They are believed to have nothing to do with decarboxylation, but the previously formed marine carbonate rock fragments may serve as the chief carbon source for their precipitation, and the alkaline diagenetic environment at the mid-late stage would promote this process.     

西藏扎布耶盐田盐渍土的改性配比试验

根据盐渍土的物理化学性质,采用掺入不同比例石灰或水泥的方法进行改性处理。经击实、抗剪和抗压强度试验结果表明,盐渍土掺入石灰或水泥改性后,混合料的最大干密度、最优含水率、强度指标等均有增加,特别是内聚力迅速增长。研究表明,盐渍土混合料的性状得到了明显改善,改性后的混合料可用于修建盐田埝堤类相关工程。     

硅质碎屑砂岩中胶结物来源的新认识

分析了浅埋藏砂岩的成岩环境,并从岩石学、矿物学、同位素及质量平衡估算方面论证硅质碎屑砂岩中的胶结物主要来源于砂岩浅埋藏期间的地下水,进而分析浅埋藏带内地下水的流动机制及早期胶结作用对晚期成岩作用的影响。     

“Tripoli”的含义及译名的讨论

“Tripoli”是一种新型的石英质工业矿物原料,在我国长期被误译为硅藻土,影响地质部门对这一新矿种的认识和寻找。本文追溯了“Tripoli”一名的由来,正确地阐述了“Tripoli”的本质特征,分析了在国内文献中长期被误译的根源,指明了其正确含义,并建议废除各种不正确的中译名,译为“粉石英”。     

硫铅酸盐“S”型瞬凝水泥干法护壁堵漏技术研究

介绍了硫铝酸盐“Ｓ”型瞬凝水泥干法者漏时使用的配方,阐述了输送工具和扫孔钻具的设计以及灌注工艺技术。     

Modeling of the classification behavior of the diaphragms used in multi-chamber cement mills

A new approach has been developed for describing the classification that arises at the diaphragm in multi-chamber ball mills. Fourteen industrial scale cement mills have been sampled in this study and after mass balancing, model fits of the equipment were done. Successive mill product predictions for the sampled conditions were achieved, and requirements to build up an optimization capable model are discussed.     

A Solution to the Problem of Predicting the Suitability of Silty–clayey Materials for Cement-stabilization

Major geotechnical problems in construction involving silty–clayey soils are due to their low strength, durability and high compressibility of soft soils, and the swell–shrink nature of the overconsolidated swelling soils. Confronted with these problems, a suitable ground improvement technique is needed, for deep excavations in soft clays, for stability, durability and deformation control. Cement-stabilization is one of the alternatives. An increase in strength and durability, reduction in deformability are the main aims of this method. Conventional cement-stabilization methods are used mainly for surface treatment. However, the use of cement has recently been extended to a greater depth in which cement columns were installed to act as a type of soil reinforcement (deep cement–soil mixing and cement jet grouting). In situ engineering properties of these silty–clayey soils are often variable and difficult to predict. For this reason cement-stabilization methods have a basic target to control the aforementioned engineering properties of these clays so that the properties of a silty–clayey soil become more like the properties of a soft rock such as clayey shale or lightly cemented sandstone. So cement-stabilization of these soils is essential to control their engineering properties and to predict their engineering behaviour for construction. In an effort to predict, classify and study the suitability of silty–clayey soils for cement-stabilization both slaking and unconfined compressive strength tests were carried out on clayey–sand mixtures consisted of two types of clays, kaolin and bentonite. Finally diagrams were prepared to study the variation of slaking and strength due to compaction, curing time and cement percentage and also to predict areas of efficient cement-stabilization.