Environmental risk evaluation of the use of mine spoils and treated sewage sludge in the ecological restoration of limestone quarries

The ecologic restoration criteria in areas degraded from extraction activities require making use of their mine spoils. These materials do not meet fertility conditions to guarantee restoration success and therefore, need the incorporation of organic amendments to obtain efficient substratum. Reducing the deficiencies in the organic material and restoration material nutrients with the contribution of treated sewage sludge is proposed in this work. This experiment was based on a controlled study using columns. The work was conducted with two mine spoils, both very rich in calcium carbonate. The first mineral, of poor quality, came from the formation of aggregates of crushed limestone (Z). The other residual material examined originated in limestone extraction, formed by the levels of interspersed non-limestone materials and the remains of stripped soils (D). Two treatments were undertaken (30,000 and 90,000 kg/ha of sewage sludge), in addition to a control treatment. The water contribution was carried out with a device that simulated either short-duration rain or a flooding irrigation system in order to cover the surface and then percolate through the soil. The collection of leached water took place 24 h after the applications. Different parameters of the leached water were determined, including pH, electrical conductivity, nitrate anions, ammonium, phosphates, sulphates and chlorides. The values obtained for each irrigation application are discussed, and the nitrate values obtained were very elevated.     

土壤渗滤处理技术在海岛生活污水处理中的应用

土壤渗滤处理系统设备简单、投资少、操作管理方便、能耗低,净化效果良好,在处理海岛生活污水领域具有广阔的发展前景.根据鼓浪屿目前污水水质、水量的特点,采用土壤渗滤高度水处理技术对污水进行处理,污染物经过土壤的物理、化学和生物作用,出水达到《城市污水再生利用城市杂用水水质》(GB/T18920-2002),具有不产生污泥,运行简单,氮磷去除效率高,无二次污染等特点.     

从厌氧反应器的发展谈UASB反应器的改良

对厌氧反应器的发展沿革、技术现状和研究进展进行了较为全面的总结。介绍了第 1代、第 2代和第 3代厌氧反应器的特点及应用状况。分析了厌氧反应器的发展趋势 ,对比了 EGSB、IC反应器与 UASB反应器的结构特征 ,提出并验证了改良 UASB反应器。结果显示 ,改良 UASB反应器有利于提高负荷和设备开发。     

完全混合活性污泥法处理含海水污水时基质降解与需氧量之间的关系

文章采用完全混合活性污泥法研究了大生活用海水进入城市污水系统后 ,不同海水盐度下基质降解与需氧量之间的关系。结果表明随着污水中海水比例的增加 ,代谢单位重量有机物所需的氧量和污泥自身氧化需氧率也呈增加趋势     

大生活用海水生化处理技术研究进展

采用海水作为大生活用水最结解沿海城市淡水资源紧缺局面的有效途径之一。该技术得以推广应用的技术关键是大生活用海水的后处理技术，文章综述了大生活用海水的生化处理技术的研究现状，并提出了今后的研究方向。     

底部浮泥表层推移速度分布的ADCP—GPS估测方法

ADCP对底跟踪走航观测的流速数据中包含水体底部浮泥、底沙运动信息,对比GPS定位方法算出的水体流速数据可以分离出浮泥相对于GPS定位的运动信号,从而达到对底质推移观测的目的。     

烟台市污水处理深海排放工程设计方案研究与选择

沿海城市污水处理深海排放工程在我国起步较晚，烟台市污水处理深海排放工程我国目前规模最大的同类工程，且已进入施工阶段，本文详细阐述了该工程及水工设计方案，在我国城市污水２深海排放工程领域作了积极有益的探索。     

ASM1中污水水质参数与化学计量系数的估测

简要介绍了活性污泥1号模型中14个污水水质参数与5个化学计量系数的估测方法和典型取值。     

The origin of accretionary lapilli

Experimental investigations in a recirculating wind tunnel of the mechanisms of formation of accretionary lapilli have demonstrated that growth is controlled by collision of liquid-coated particles, due to differences in fall velocities, and binding as a result of surface tension forces and secondary mineral growth. The liquids present on particle surfaces in eruption plumes are acid solutions stable at 100% relative humidity, from which secondary minerals, e.g. calcium sulphate and sodium chloride, precipitate prior to impact of accretionary lapilli with the ground. Concentric grain-size zones within accretionary lapilli build up due to differences in the supply of particular particle sizes during aggregate growth. Accretionary lapilli do not evolve by scavenging of particles by liquid drops followed by evaporation — a process which, in wind tunnel experiments, generates horizontally layered hemispherical aggregates. Size analysis of particles in the wind tunnel air stream and particles adhering to growing aggregates demonstrate that the aggregation coefficient is highly grain-size dependent. Theoretical simulation of accretionary lapilli growth in eruption plumes predicts maximum sizes in the range 0.7–20 mm for ash cloud thicknesses of 0.5–10 km respectively.     

Laboratory study of the rates and products of the phototransformations of naphthalene adsorbed on samples of titanium dioxide,ferric oxide,muscovite, and fly ash

The photodegradation of naphthalene (NPH), chosen as a model of polynuclear aromatic pollutants, has been studied in the presence of a layer of four water-insoluble inorganic solids which can be found in the troposphere (TiO₂, Fe₂O₃, muscovite, and a fly ash sample). Direct photolysis of NPH is negligible at >340 nm. Dark adsorption of NPH on TiO₂ (mainly anatase, nonporous, 50 m² g^–1) at 293 K corresponds to a surface coverage ofca. 50% at equilibrium. Under these conditions (saturated surface), the stationary-state photocatalytic degradation reaches 0.4 molecule nm^–2 h^–1 (>340 nm, radiant fluxca. 22 mW cm^–2). Dioxygen is required and its partial pressure in air is such that the degradation is zero order in O₂. Water vapor markedly increases the rate. The other particulates have also an effect, less important than that of TiO₂, however quite noticeable with respect to surface area unit for the fly ash sample which contains 3.2% Fe₂O₃. Apart from 1,4-naphthoquinone, which is the main intermediate product in all cases, 2-naphthol, phthalide, phthaldialdehyde, phthalic acid, acetophenone, benzaldehyde, benzoic acid are also formed on dry TiO₂. Depending on their volatility, these compounds are transferred to the gas phase or remain principally adsorbed on the solid particles where they are further transformed. For instance, phthalic acid (or anhydride) and benzoic acid are generated from 1,4-naphthoquinone. Degradation mechanisms are briefly discussed.