A geological and geotechnical investigation of the settlement area of Zümrüt Building (Konya, Turkey) which caused 92 fatalities due to its collapse

This study examines the local geological conditions and soil structure as possible causes of the collapse of the Zümrüt Building 2 February 2004. This catastrophe resulted in 92 fatalities and 35 injuries. This study also examines other views which claim weak soil structure, elastic and consolidation settlement of soil and excessive groundwater extraction as well as subsidence resulting from the underground silt erosion as possible factors. Zümrüt Building was constructed on normally consolidated, low plasticity clay. The underground water table was 30 m in depth. The internal friction angle of soil was 8°–30°, its cohesion was between 34 and 127 kN/m² and standard penetration test numbers varied between 11 and 50. The underground water level beneath Zümrüt Building had risen 4.5 m since its construction. Therefore the claim that subsidence resulting from the decrease of underground water level contributed to the collapse is incorrect. Secondly the settlement, resulting from the filling up of the pores created by the silt receding with the underground water, was 4.4 mm in total, and attributing this as the primary cause of the collapse is also incorrect. Soil properties, in situ and laboratory test results showed that the existing and/or expected settlement and the differential ground settlement in the Zümrüt building vicinity had the potential to cause structural damage. The tensile stresses caused by differential settlements recorded here are thought to be an indicator, but not the main cause contributing to the collapse of the building. The Zümrüt Building collapse was due to several compounding mistakes during the construction phase. These were geotechnical and other project faults and the use of low quality construction materials. The resulting catastrophe caused 92 fatalities, 35 injuries and a material loss of approximately US$7 million.     

基于群桩基础沉降估算确定压缩层厚度的探讨

在现行规范中,由于桩基沉降估算模式的不同,压缩层厚度的确定方法也不完全相同。对这些方法进行归纳、总结,并通过具体的工程实例,对由不同估算模式确定的压缩层厚度及沉降估算结果进行探讨与分析,认为对于工程场地地质资料掌握较为翔实的情况下,压缩层厚度可采用变形比法确定,否则,宜根据应力比法确定。     

一种计算台风风场的方法

揭示Ｒａｎｋｉｎｅ涡风场模式和Ｊｅｌｅｓｎｉａｎｓｋｉ风场模式之间的联系，并设计了一种台风风场分布模式，它的风速分布曲线落在Ｊｅｌｅｓｎｉａｎｓｋｉ和Ｒａｎｋｉｎｅ涡两个风场模式的风速分布曲线之间，具有一个既优于Ｊｅｌｅｓｎｉａｎｓｋｉ又优于Ｒａｎｋｉｎｅ涡的风速衰减速率，因此它同时克服了Ｒａｎｋｉｎｅ涡模式计算风速偏小和Ｊｅｌｅｓｎｉａｎｓｋｉ模式计算风速偏大的缺点，以一种比较合理的变化趋势向远方衰减，成为一个比较切合实际的台风风场分布模式。同时，文中提出的移行台风风场计算方法对宫崎正卫、上野武夫和Ｊｅｌｅｓｎｉａｎｓｋｉ模式都有一定的改进。     

Numerical and simplified methods for the calculation of the total horizontal wave force on a perforated caisson with a top cover

The VOF method and the k–ε model, combined with the equation of state of air at constant temperature, have been used to calculate the total horizontal wave force caused by monochromatic waves acting on a perforated caisson with a top cover. From comparison of various parameters, such as the total horizontal force, the pressure difference on the front wall, the pressure on the back wall and the pressure on the top cover, between the numerical results and test data, it can be seen that the numerical results agree well with the test data. It is concluded that the method described in this paper can be utilized to calculate wave forces acting on perforated caissons with a top cover in the case of nonovertopping, nonbreaking waves. A simplified method to calculate the total horizontal force has been developed, based on test data, using a least-squares method. A comparison between the numerical results and the values calculated from the simplified equations shows good agreement. Therefore the simplified equations can be used in engineering applications to evaluate the total horizontal force on a perforated caisson with a top cover.     

黑潮区台风域海-气热输送量的计算

根据1972和1974年经过黑潮区的两个台风个例,计算和分析了台风各部位在不同的海气条件下热量输送的垂直分布特点。表明,在台风前部信风带中,热量垂直输送限于700hPa以下,在1000hPa处有约167.47—209.34J/(cm~2·h)的最大值,700hPa以上热量向下输送;在台风中心区,热量输送量最大,在1000hPa处接近420J/(cm~2·h),在850hPa附近可能有热输送量的最大值,其上随高度减小;在台风后部偏南气流中,向上热输送量较小;各层最大值不超过84J/(cm~2·h)。     

斜坡提砌石护面厚度的计算

介绍了斜坡式防波堤砌石护面中的插砌条石和干砌块石在波浪作用下的力学图式及作用机理 ,重点给出考虑摩擦力作用时的砌石块体稳定厚度的计算公式 ,并结合工程实例验证了公式的适用性     

港口靠船桩工作性状计算的双参数法

港口靠船桩是承受重复性荷载或多循环荷载的一种横向承载桩。双参数法能较好地描述靠船桩 (单桩、群桩 )的桩土工作性状。用双参数法进行计算时 ,所给的地面条件必须由重复荷载或多循环荷载作用下实测出来。根据现场试桩资料 ,标定桩土参数 ,即k =mx1/n的指数l/n、桩土相对柔度系数α、桩土综合刚度EI等值 ,可以用来设计试桩附近局部地区同类条件下的其它长桩。对于没有进行试桩的某些工程 ,可以联合运用双参数法和p -y曲线法进行桩的分析     

Recruitment patterns of Serpula vermicularis L. (Polychaeta, Serpulidae) in Loch Creran, Scotland

This study aimed to contribute to conservation management of reefs of Serpula vermicularis by increasing understanding of the factors influencing larval settlement. The study was carried out in Loch Creran, which supports the most extensive known development of S. vermicularis reefs in the world. Settlement plates were deployed to examine the influence of season, depth, reef density, substrate type and orientation. Monthly deployment of plates revealed settlement of S. vermicularis to occur predominantly from mid-June to mid-October, peaking in late August to early September. Settlement of Pomatoceros spp. peaked much earlier, in late May to early June. Deployment of plates at different depths revealed a marked reduction in S. vermicularis settlement intensity between 6 and 12 m. As this corresponds with the deeper limit of the peripheral fringe of serpulid reefs in the loch, it is suggested that this limit is imposed by a depth-correlated settlement response, rather than reduction in available substrata. Comparisons of various substrata showed a preference by S. vermicularis larvae for a slate over a scallop substrate and no evidence of enhanced recruitment to occupied or unoccupied tubes of S. vermicularis, suggesting that gregarious attraction is unlikely to be a factor causing reef formation. Settlement onto the upper side of a horizontal scallop substrate was found to be insignificant in comparison with the underside or a vertically orientated scallop. Evidence for the role of light in controlling the depth and substrate-orientation preferences of S. vermicularis larvae is discussed. Based on the results of this study, recommendations are made regarding remediation of areas suffering reef damage.     

Resources calculation of cobalt-rich crusts with the grid subdivision and integral method

On the basis of three geological models and several orebody boundaries,a method of grid subdivision and integral has been proposed to calculate and evaluate the resources of cobalt-rich crusts on the seamounts in the central Pacific Ocean.The formulas of this method are deduced and the interface of program module is designed.The method is carried out in the software "Auto mapping system of submarine topography and geomorphology MBChart".This method and program will possibly become a potential tool to calculate the resources of seamounts and determine the target diggings for China's next Five-year Plan.