Dissolution and depletion of ferromagnesian minerals from Holocene tephra layers in an acid bog,New Zealand,and implications for tephra correlation

This study examines the depletion of ferromagnesian silicate minerals from a sequence of thin, distal, mainly rhyolitic tephra layers of Holocene age preserved in an acid peat bog (Kopouatai), North Island, New Zealand. The rate of such depletion has been fast, as indicated by the complete loss of biotite from one tephra layer (Kaharoa Tephra), in which it is normally dominant, in only ca. 770 yr. Chemical dissolution is advocated as the likely cause for the depletion, with amphiboles and other mineral grains commonly showing etch pits, microcaves, and other characteristic surface solution features. Theoretical thermodynamic and kinetic models show a marked increase in the rate of dissolution of all ferromagnesian minerals under conditions of low pH (< 4), but that where silica concentrations in solution are high the relative proportions of minerals remaining are unaffected. However, where concentrations of dissolved silica are low, as in most bog environments, the relative proportions of ferromagnesian minerals are affected as well as absolute amounts being decreased. Amphiboles are depleted relative to pyroxenes, consistent with kinetic studies. The results show that the identification and correlation of tephras on the basis of relative abundances of ferromagnesian minerals alone may be unreliable, and emphasise the need to use multiple criteria in such studies.     

广西岩溶区金属硫化物矿床风化与元素表生迁移特征

对广西岩溶区三个铅锌硫化物矿床风化带观测结果表明，中低山岩溶区硫化物矿床具有更强烈的风化淋滤作用，但次生晕面积较小；岩溶平原区硫化物矿床风化与元素表生迁移特征较相似于非岩溶区的情况，表现在可产生较宽的ｐＨ偏低带和较大面积的次生晕     

Microbial release of potassium from K-bearing minerals by thermophilic fungus Aspergillus fumigatus

A strain of thermophilic fungus Aspergillus fumigatus was cultured with K-bearing minerals to determine if microbe-mineral interactions enhance the release of mineralic potassium. Experiments were carried out in two settings, one with the mineral grains and the fungal cells in direct contact, and the other employing a membrane (pore size 0.22 μm) to separate the two. Measurements over a period of 30 days showed that, irrespective of the experimental setup, the concentration of free K in the culture was drastically higher than those in any of the control experiments where no living organism was present. Moreover, the occurrence of mineral-cell physical contact enhanced potassium release by an additional factor of 3 to 4 in comparison to the separation experiments. For contact experiments, Electron Probe Microanalysis revealed the formation of mycelium-mineral aggregates, and Atomic Force Microscopy imaging further indicated the possible ingestion of mineral particles by the fungus cells. Contrasting to what was observed and expected in control experiments, the potassium solubilization rate showed a positive dependence upon pH when fungi and minerals were mixed directly, and exhibited no correlations with solution acidity if cell-rock contact was restrained. These results appear to suggest that A. fumigatus promoted potassium release by means of at least three likely routes, one through the complexation of soluble organic ligands, another appealing to the immobile biopolymers such as the insoluble components of secretion, and the third related to the mechanical forces in association with the direct physical contact between cells and mineral particles.     

An Attempt to Predict the Failure Time of Abandoned Mine Pillars

Summary  Left in place pillars of abandoned mines are subject to weathering (e.g action of water, bacteria) that degrades their mechanical strength and eventually leads to collapse. A simple weathering model is proposed, that is governed by two parameters: the rate of progression of weathered front and the rate of degradation of the compressive strength with time. Both plane strain and axisymmetric analyses are performed and closed form solutions of the variation with time of the bearing capacity of the pillar are given. Experimental data of the tests conducted on gypsum and anhydrite specimens attacked by water are presented. It is shown that in order to fit the experimental data a third parameter must be introduced. New closed form solutions are given and the data are used for estimating the time to failure of abandoned gypsum mines in Northern Italy. Authors’ address: Dr. Riccardo Castellanza, Research Assistant, Department of Structural Engineering, Milan University of Technology (Politecnico), Piazza Leonardo da Vinci 32, 20133 Milan, Italy     

Inhomogeneous substrate analysis using EM300 backscatter imagery

Backscatter reflectivity from multibeam echo-sounders provides a powerful tool to efficiently characterize seafloor substrates. A comprehensive EM300 bathymetric and backscatter survey has been completed of Cook Strait, in central New Zealand. This paper presents a detailed analysis of the realtime corrections applied to the raw EM300 multibeam data and additional corrections required to compute angular variations of the backscatter strength. The corrections, including the local absorption coefficient, the influence of seafloor topography and sound refraction in the water column, are determined for different Cook Strait seafloor substrates. Modifying MB-System software code, we extracted the backscatter signal parameters in order to quantify the raw backscatter strength and apply additional processing. Profiles of backscatter strength versus incidence angle were computed for a variety of sites characterized by flat seafloor and homogeneous substrates, and for which ground-truth data were available. For each homogeneous site, different but characteristic backscatter profiles are observed that can be interpreted in terms of sediment facies. To analyze heterogeneous substrates, we present a statistical technique, based on a 3-dimensional distribution of (incidence angle, backscatter strength) couples that preserves geological information of the substrate components. This analysis, using backscatter data acquired on a submarine volcano, north of New Zealand, clearly differentiates soft sediments and lava flows within a heterogeneous substrate.     

声波在水-多孔介质海底界面上的反射与透射

声波在海底界面的反射和透射是海底散射、海底混响、海底目标探测的重要问题。利用Biot多孔介质声传播理论对声波在水-多孔海底界面上的反射和透射进行了分析,具体给出反射声波的反射系数,3种透射声波的透射系数以及声能透射系数随入射波入射角和频率(10~40 kHz)的变化关系,分析了各种透射波对透射声能的贡献。多孔海底介质参数分别采用Stoll和Chotiros给出的2组参数进行理论计算。     

Hydrothermal Vent Geology and Biology at Earth’s Fastest Spreading Rates

Earth’s fastest present seafloor spreading occurs along the East Pacific Rise near 31°–32° S. Two of the major hydrothermal plume areas discovered during a 1998 multidisciplinary geophysical/hydrothermal investigation of these mid-ocean ridge axes were explored during a 1999 Alvin expedition. Both occur in recently eruptive areas where shallow collapse structures mark the neovolcanic axis. The 31° S vent area occurs in a broad linear zone of collapses and fractures coalescing into an axial summit trough. The 32° S vent area has been volcanically repaved by a more recent eruption, with non-linear collapses that have not yet coalesced. Both sites occur in highly inflated areas, near local inflation peaks, which is the best segment-scale predictor of hydrothermal activity at these superfast spreading rates (150 mm/yr).     

海底勘查技术的最新发展

本文将介绍用于探测海底三维地质特征的海底勘查的最新发展。它主要包括海底地形测绘技术，海底形貌观测技术、海底地层声学探测技术等。     

南海北部外陆架和上陆坡海底滑坡稳定性研究

海洋工程地质调查发现，在南海北部外陆架和上陆坡海底，有大片滑坡，其水深范围约在１８０－６５０ｍ之间，它们沿着陆架外缘坡折处呈北东－南西方向分布，其具体位置往往与古三角洲前缘的海底陡坎及古海岸线位置密切相关，大量浅层地震，旁侧声纳，底质取样分析和土体力学理论计算表明，本区滑坡主要是由于地形坡度，沉积物特性，土体自身重力，它们是区内海底很不稳定的地带，是一种重要的地灾害因素，在海洋工程地质设计和实施时