中国对虾(Penaeus chinensis)消化系统发生的研究

本文对中国对虾消化道和中肠腺的发生进行了研究。完整的中肠管形成于Ｎ３期，它是由幼虫腹面的内胚层板向背中线上卷合拢而形成。在Ｚ１期消化道完全贯通。至Ｍ１期，胃分化为贲门胃和幽门胃两部分，中肠前盲囊和中肠后盲囊也在此期出现，同时胃磨的雏形发生，但完整的胃磨形成于Ｐ期。另外，中肠腺始于Ｎ４－５期中肠前端突出的两对中肠腺盲囊。第一对中肠腺盲囊于Ｍ３期退化消失，而第二对中肠腺盲囊则发育为成体的中肠腺。中肠腺小管由４种不同类型的细胞（胚性细胞、吸收细胞、纤维细胞和泡状细胞）所组成     

高速摄影对散体振动的研究

以现代高速摄影技术和图像分析以及数据处理方法，针对高效振动磨机中弹性散体工质（如钢棒、球体等）的振动力学进行了深入的探讨和分析，为研究散体动力学和振动超细粉碎过程中的能量分布和传递规律以及能量与物质的相互转换机理奠定了基础，也为相关学科的发展提供了一种可以借鉴的方法。     

Some breakage characteristics of ultra-fine wet grinding with a centrifugal mill

A centrifugal mill is a high-power intensity media mill that can be used for ultra-fine grinding, employing centrifugal forces generated by gyration of the axis of the mill tube in a circle. The mill charge motion is quite different depending on the ratio of the gyration diameter to the mill diameter (G / D ratio), varying from a motion similar to that of a conventional tumbling media mill to that of a vibration mill. In this study, a centrifugal mill was constructed with an arrangement where the gyration diameter could be readily adjusted. The batch grinding characteristics of three different minerals (limestone, talc and illite) in water with dispersing agent were investigated at various G / D ratios. It was found that the optimum G / D ratio in terms of the specific energy consumption to give a desired fineness of product was different for the three minerals. This was due to their different reactions to the breakage mechanisms provided by the mill charge motion at varying G / D ratios. The size distributions became progressively narrower at increased grinding times, and particles finer than about 0.1 μm were not detected even for prolonged grinding times. Measurement of specific surface areas indicated that this was not due to an artifact of the size measurements by laser diffractometry. This implies that there is a limitation in which particles finer than 0.1 μm are not produced under the conditions tested in this type of mill, but further investigation is needed for experimental verification of this limit of comminution.     

Production of carbonate and silica nano-particles in stirred bead milling

This paper presents the experimental results of the mechanical production of silica and carbonate colloidal particles below 100 nm using two types of stirred bead mills (i.e., DCP Superflow 12 and PML H/V). It is shown that the stirred bead mill with very small beads can be used as an efficient equipment for the production of the colloidal particles in nanoscale from the feed materials of several microns in sizes at high energy consumptions. The DCP Superflow mill with high power densities is superior for the effective size reduction and production rate, compared to the conventional PML H/V mill with lower power densities. The smaller particles could be produced by the DCP Superflow mill at the same level of high energy inputs as from the PML H/V mill. The “grinding limit” for the processes in the mills has been discussed.     

关于求解碾磨机运动问题的相关讨论

针对关于求解碾磨机上一点运动的速度及加速度的问题展开讨论,从运动的不同角度考虑,给出了n种不同的解法。并将此问题拓展到一般情况下进行讨论,得出正确结论。并就一些相关问题进行了分析和解释。     

Pollution history and recovery of a boreal lake exposed to a heavy bleached pulping effluent load

We examined the effects of heavy pulp mill discharges on the Lake Lievestuoreenjärvi ecosystem and the later recovery of diatom and chironomid communities from age-dated short core samples. Beginning in 1927 the lake received a heavy effluent load from a sulphite pulp mill. Except for the recession during the Second World War and the temporary closure of the mill from 1967 to 1971, the industrial load, containing large quantities of nutrients, organic matter and toxic compounds, increased continuously. In the early 1980s, laboratory documents were falsified by the directors of the mill and the systematic illegal effluent overload led to a collapse of the whole lake ecosystem. In 1985, the outdated plant was finally closed down. Based on the assessment of chemical properties and biological remains of the sediment, we distinguished five developmental phases in the ecological state of the lake. In the pre-industrial phase, the pelagic and profundal benthic communities were dominated by species preferring ultraoligotrophic or oligotrophic lakes. Concomitant with the increasing discharge and deposition of chlorine compounds, resin acids, and mercury, as well as strong acidity and hypolimnetic and epilimnetic anoxia, the ecological status changed in a short period from excellent to bad. Finally, in the early 1960s, the majority of the lake was virtually dead and the aquatic life survived only in the uppermost littoral zone. Since 1985, a fast recovery in the water quality has led to a strong, but temporary eutrophy in pelagic communities. The main peak of eutrophication was caused by the invasion of a species new to the lake,Aulacoseira granulata var.angustissima. Later, the pelagic communities shifted towards oligotrophy, but the original, pre-industrial status has not been re-established. The profundal benthic communities have not achieved the pre-industrial structure, but at present indicate mesotrophy.     

MODIS数据在黄河凌汛监测中的应用

对MODIS数据的特性及其在黄河凌汛监测中的应用情况进行了探讨和总结。试验结果表明 ,MODIS数据在冰雪检测方面具有很大的潜力     

Development of a soil moisture‐based distributed hydrologic model for determining hydrologically based critical source areas

A simple grid cell‐based distributed hydrologic model was developed to provide spatial information on hydrologic components for determining hydrologically based critical source areas. The model represents the critical process (soil moisture variation) to run‐off generation accounting for both local and global water balance. In this way, it simulates both infiltration excess run‐off and saturation excess run‐off. The model was tested by multisite and multivariable evaluation on the 50‐km² Little River Experimental Watershed I in Georgia, U.S. and 2 smaller nested subwatersheds. Water balance, hydrograph, and soil moisture were simulated and compared to observed data. For streamflow calibration, the daily Nash‐Sutcliffe coefficient was 0.78 at the watershed outlet and 0.56 and 0.75 at the 2 nested subwatersheds. For the validation period, the Nash‐Sutcliffe coefficients were 0.79 at the watershed outlet and 0.85 and 0.83 at the 2 subwatersheds. The per cent bias was less than 15% for all sites. For soil moisture, the model also predicted the rising and declining trends at 4 of the 5 measurement sites. The spatial distribution of surface run‐off simulated by the model was mainly controlled by local characteristics (precipitation, soil properties, and land cover) on dry days and by global watershed characteristics (relative position within the watershed and hydrologic connectivity) on wet days when saturation excess run‐off was simulated. The spatial details of run‐off generation and travel time along flow paths provided by the model are helpful for watershed managers to further identify critical source areas of non‐point source pollution and develop best management practices.     

An analytical approach to ascertain saturation‐excess versus infiltration‐excess overland flow in urban and reference landscapes

Uncontrolled overland flow drives flooding, erosion, and contaminant transport, with the severity of these outcomes often amplified in urban areas. In pervious media such as urban soils, overland flow is initiated via either infiltration‐excess (where precipitation rate exceeds infiltration capacity) or saturation‐excess (when precipitation volume exceeds soil profile storage) mechanisms. These processes call for different management strategies, making it important for municipalities to discern between them. In this study, we derived a generalized one‐dimensional model that distinguishes between infiltration‐excess overland flow (IEOF) and saturation‐excess overland flow (SEOF) using Green–Ampt infiltration concepts. Next, we applied this model to estimate overland flow generation from pervious areas in 11 U.S. cities. We used rainfall forcing that represented low‐ and high‐intensity events and compared responses among measured urban versus predevelopment reference soil hydraulic properties. The derivation showed that the propensity for IEOF versus SEOF is related to the equivalence between two nondimensional ratios: (a) precipitation rate to depth‐weighted hydraulic conductivity and (b) depth of soil profile restrictive layer to soil capillary potential. Across all cities, reference soil profiles were associated with greater IEOF for the high‐intensity set of storms, and urbanized soil profiles tended towards production of SEOF during the lower intensity set of storms. Urban soils produced more cumulative overland flow as a fraction of cumulative precipitation than did reference soils, particularly under conditions associated with SEOF. These results will assist cities in identifying the type and extent of interventions needed to manage storm water produced from pervious areas.     

基于SEED波形文件的运行率统计

介绍了基于SEED波形文件运行率计算的技术和实现方法,介绍了SEED文件中标识时间的特殊掩码、时间片的具体格式和程序的实现,并给出了与其相关的部分源代码.