A novel coupled FDM-DEM modelling method for flexible membrane boundary in laboratory tests

Difficulties are involved in discrete element method (DEM) modelling of the flexible boundary, that is, the membranes covering the soil sample, which can be commonly found in contemporary laboratory soil tests. In this paper, a novel method is proposed wherein the finite difference method (FDM) and DEM are coupled to simulate the rubber membrane and soil body, respectively. Numerical plane strain and triaxial tests, served by the flexible membrane, are implemented and analysed later. The effect of the membrane modulus on the measurement accuracy is considered, with analytical formulae derived to judge the significance of this effect. Based on an analysis of stress-strain responses and the grain rotation field, the mechanical performances produced by the flexible and rigid lateral boundaries are compared for the plane strain test. The results show that (1) the effect of the membrane on the test result becomes more significant at larger strain level because the membrane applies additional lateral confining pressure to the soil body; (2) the tested models reproduce typical stress and volumetric paths for specimens with shear bands; (3) for the plane strain test, the rigid lateral boundary derives a much higher peak strength and larger bulk dilatation, but a similar residual strength, compared with the flexible boundary. The latter produces a more uniform (or ‘diffuse') rotation field and more mobilised local kinematics than does the former. All simulations show that the proposed FDM-DEM coupling method is able to simulate laboratory tests with a flexible boundary membrane.     

Geostatistical features of streambed vertical hydraulic conductivities in Frenchman Creek Watershed in Western Nebraska

This study evaluated the spatial variability of streambed vertical hydraulic conductivity (K_v) in different stream morphologies in the Frenchman Creek Watershed, Western Nebraska, using different variogram models. Streambed K_v values were determined in situ using permeameter tests at 10 sites in Frenchman, Stinking Water and Spring Creeks during the dry season at baseflow conditions. Measurements were taken both in straight and meandering stream channels during a 5 day period at similar flow conditions. Each test site comprised of at least three transects and each transect comprised of at least three K_v measurements. Linear, Gaussian, exponential and spherical variogram models were used with Kriging gridding method for the 10 sites. As a goodness-of-fit statistic for the variogram models, cross-validation results showed differences in the median absolute deviation and the standard deviation of the cross-validation residuals. Results show that using the geometric means of the 10 sites for gridding performs better than using either all the K_v values from the 93 permeameter tests or 10 K_v values from the middle transects and centre permeameters. Incorporating both the spatial variability and the uncertainty involved in the measurement at a reach segment can yield more accurate grid results that can be useful in calibrating K_v at watershed or sub-watershed scales in distributed hydrological models.     

Preliminary investigation of mercury in bone tissues of skua and penguin in Antarctica using AFS and Synchrotron Radiation X-ray Fluorescence （SR-XRF）

Mercury （Hg） was investigated in bone tissues of skua （ Catharacta maccormick） and penguin （Pygoscelis adeliae） collected in the maritime Antarctic using atomic fluorescence spectrometry （AFS） and synchrotron radiation X-ray fluorescence （SR-XRF） method. The total levels of mercury in bone tissues of penguin and skua are much lower than those in other organs （e. g. , kidney, liver）. The toxic effects of mercury in bone tissues of seabirds in polar region are not known. We have used SR- XRF method to map the distribution of trace levels of mercury in bones. The levels of mercury are found to be enriched somewhere near the periosteal surface and/or endosteal surface. The distribution of mercury shows strongly correlation with that of some essential elements and probably poses negative effect on the bone metabolism inferring from the relationship of mercury with the other elements. These studies represent a first step toward understanding the toxic effects of mercury on bone of polar animals by suggesting the possible microscopic investigation.     

地下洞库勘察中的深斜孔钻探和压水试验技术

青岛市黄岛区拟建设海底地下油气储藏库,前期地质勘察工作要求施工倾角45°、深220m的取心钻孔4个,并在孔内分段进行压水试验.本文介绍了如何利用XY-4型金刚石小口径钻机施工基岩深斜孔及压水试验技术.     

定水头注水引起的含水层水平运动和应变

基于含水层固体颗粒与孔隙水不可压缩的假设 ,本文导出了单井注水情况下泰斯承压含水层水平运动速度与水头之间的基本关系式。然后利用注水井壁处的应力、应变边界条件 ,进一步导出了单井定水头注水引起的泰斯承压含水层水平运动速度、位移和应变解析表达式。该水平位移与应变由两部分组成 :一部分为由注水压力本身引起的经典弹性力学解项 ,它仅随半径而变化 ,与注水时间无关 ;另一部分为由地下水头变化引起的水动力学位移和应变解项。其中 ,含水层水动力学水平位移随时间加长呈指数增长特征 ,水动力学径向应变则表现为近井处拉张、远井处挤压的分区特征 ,且近井拉张区随时间加长逐渐向外扩展。单井注水含水层水动力学水平位移、应变解的导出 ,完善和发展了单孔内压经典弹性平面力学问题解     

变形分析的Bayes估计与检验

由于观测条件的变化，观测值方差将产生随机波动。本文根据Ｂａｙｅｓ估计理论，推导了线性模型待估参数的分布函数及观测值方差估计公式，并将其用于位移检验。计算结果表明，在同样的置信度下，本方法更符合实际。文中还对参数估值的统计性质进行了讨论。     

塔中4号油藏渗透率分布的非均质性及渗流方向研究

研究油藏内部油水渗流方向时,主要考虑渗透率影响,引入两个水平方向渗透率比、水平与垂向渗透率比参数来分析。前者反映样品所在储层平面上两个水平方向渗流能力的差异,后者反映样品所在储层水平与垂向渗流能力的差异,并经小柱样测试和全岩心测试两种方法确定两个参数。通过对塔中4号油藏CⅠ油组9口井2306个样品两种渗透率比值分布直方图分析,研究了CⅠ油组渗透率的非均质性及其渗流方向:CI油组储层在水平方向的渗流能力有很大差异,具有明显的方向性。储层垂向渗流能力明显小于水平方向的渗流能力。     

Predicting ground-motion variations at the Turkey-flat test site,California

Results of a single group participating in an international experiment are analyzed. The experiment served to verify computational predictions of the ground-motion variations due to near-surface geological effects at a site established for that purpose by the California Department of Conservation. Based on an acceleration record at a rock location, and geotechnical model of medium, records at the other locations of a nearby sedimentary deposit were predicted. A 2-D finite-difference sensitivity analysis suggested that the lateral wave-propagation effects are negligibly small, and locally 1-D computations are sufficient for the present site. Those computations are compared with observations not available to the authors during the blind prediction. Peak accelerations, peak velocities and RMS accelerations were predicted with errors less than 159%, 114% and 62%, respectively. Maxima of the response spectra were fitted within a factor of 2. The predicted and observed Husid's plots (i.e., the normalized cumulative plots of the acceleration squared) have the correlation coefficients 0.98. The detected misfits do not show any simple relation to the instrument location, component, frequency, or time.     

Integrated approach for identification of potential groundwater zones in Seethanagaram Mandal of Vizianagaram District,Andhra Pradesh,India

Identifying a good site for groundwater exploration in hard rock terrain is a challenging task. In hard rocks, groundwater occurs in secondary porosity developed due to weathering, fracturing, faulting, etc., which is highly variable within short distance and contributing to near-surface inhomogeneity. In such situations topographic, hydrogeological and geomorphological features provide useful clues for the selection of suitable sites. Initially, based on satellite imagery, topographical, geomorphological and hydrogeological features, an area of about 149 km² was demarcated as a promising zone for groundwater exploration in the hard rock tract of Seethanagaram Mandal, Vizianagaram District, Andhra Pradesh, India. A total of 50 Vertical Electrical Soundings (VES) were carried out using Wenner electrode configuration. An interactive interpretation of the VES data sharpened the information inferred from geomorphological and hydrogeological reconnaissance. Ten sites were recommended for drilling. Drilling with Down-The-Hole Hammer (DTH) was carried out at the recommended sites down to 50 to 70 m depths. The interpreted VES results matched well with the drilled bore well lithologs. The yields of bore wells vary from 900 to 9000 liters per hour (lph).     

微型氢化物发生装置在冷原子吸收分光光度法测汞中的应用

采用微型氢化物发生装置-冷原子吸收分光光度法测定了焊锡料及纽扣电池中的汞。在酸性介质中,用硼氢化钾将汞离子还原为汞原子,用载气将汞蒸气导入石英管,原子吸收分光光度计在波长253.7 nm处进行测定。选择了实验条件,对共存离子的干扰等进行了考察。方法的检出限为0.34 ng/mL,11次测定的相对标准偏差(RSD)小于6%,加标回收率为94.4%~104.7%。