Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Metamorphism in Archaean greenstone belts: calculated fluid compositions and implications for gold mineralization

An inescapable consequence of the metamorphism of greenstone belt sequences is the release of a large volume of metamorphic fluid of low salinity with chemical characteristics controlled by the mineral assemblages involved in the devolatilization reactions. For mafic and ultramafic sequences, the composition of fluids released at upper greenschist to lower amphibolite facies conditions for the necessary relatively hot geotherm corresponds to those inferred for greenstone gold deposits (X_CO2= 0.2–0.3). This result follows from the calculation of mineral equilibria in the model system CaO–MgO–FeO–Al₂O₃–SiO₂–H₂O–CO₂, using a new, expanded, internally consistent dataset. Greenstone metamorphism cannot have involved much crustal over-thickening, because very shallow levels of greenstone belts are preserved. Such orogeny can be accounted for if compressive deformation of the crust is accompanied by thinning of the mantle lithosphere. In this case, the observed metamorphism, which was contemporaneous with deformation, is of the low-P high-T type. For this type of metamorphism, the metamorphic peak should have occurred earlier at deeper levels in the crust; i.e. the piezothermal array should be of the ‘deeper-earlier’type. However, at shallow crustal levels, the piezothermal array is likely to have been of ‘deeper-later’type, as a consequence of erosion. Thus, while the lower crust reached maximum temperatures, and partially melted to produce the observed granites, mid-crustal levels were releasing fluids prograde into shallow crustal levels that were already retrograde. We propose that these fluids are responsible for the gold mineralization. Thus, the contemporaneity of igneous activity and gold mineralization is a natural consequence of the thermal evolution, and does not mean that the mineralization has to be a consequence of igneous processes. Upward migration of metamorphic fluid, via appropriate structurally controlled pathways, will bring the fluid into contact with mineral assemblages that have equilibrated with a fluid with significantly lower X_CO2. These assemblages are therefore grossly out of equilibrium with the fluid. In the case of infiltrated metabasic rocks, intense carbonation and sulphidation is predicted. If, as seems reasonable, gold is mobilized by the fluid generated by devolatilization, then the combination of processes proposed, most of which are an inevitable consequence of the metamorphism, leads to the formation of greenstone gold deposits predominantly from metamorphic fluids.     

Optimization of grid-drilling using computer simulation

A computer simulation method has been developed to find efficient drilling grids for mineral deposits. A well-known ore deposit is used as a model to develop an efficient pattern for undiscovered ore bodies in the same area or in other prospects where similar geometry is suspected. The model for this study is the Austinville, Virginia deposit, a Mississippi Valley-type deposit composed of 17 ore bodies totaling 34 million short tons (30 million metric tons). The method employs a computer program that simulates drilling the model deposit with different patterns, including various levels of follow-up drilling. Follow-up holes are drilled in fences at one half the original spacing around holes in the grid that show ore-grade mineralization. Each pattern is drilled 100 times from random starting locations to provide a range of outcomes of drilling, including the best, worst, and most likely. For this study, patterns of 100 drill holes were composed of 10 fences spaced 1000–5000 feet (305–1524 m) apart, each with 10 holes spaced 200–1000 feet (61–305 m) apart. In all, 25 grids were used with zero to three levels of follow-up drilling. The 600/2000 grid, with drill holes spaced 600 feet (183 m) apart in fences spaced 2000 feet (610 m) apart, was compared with the 200/5000 grid because they represented contrasting outcomes. The 600/2000 grid penetrated many ore bodies consistently but with few multiple hits to individual ore bodies; whereas the 200/5000 grid inconsistently penetrated few ore bodies with many multiple hits. The 600/2000 grid was more efficient than the 200/5000 grid at hitting large ore bodies of 1,000,000 short tons or greater (900,000 metric tons or greater) and was made more effective by adding one cycle of follow-up drilling. The 600/2000 grid had a 97% chance of hitting one or more large ore bodies with at least one drill hole per ore body, and the 200/5000 grid had a 64% chance. Once hit, there was an 82% chance that the largest ore body would be penetrated by three or more holes when using the 600/2000 grid and an 88% chance using the 200/5000 grid.     

浅议地勘单位的物业管理

文章阐述了地勘单位物业管理社会化的必然性和内函 ,提出发展地勘单位物业管理的基本内容和需要解决的问题 ,最终实现以业养业 ,自我发展。     

黄金的成色

黄金的成色并不是一成不变的，它成色的高低是与成矿温度、成矿阶段、深度、时代、变质程度、水溶液及风化作用等有一定关系，我们从这些关系中可以寻找到我们找矿的捷径和依据。     

地球化学景观吸引子的发现及其意义

勘查地球化学对异常评价的最大不确定性源于对地球化学景观特性的认识不够。我们应用构造相空间的方法分析了浙江儒岙幅（1:5万）水系沉积物测量的Ag含量数据，揭示了地球化学景观是具有低维吸引子（DZ≈2．9）的混饨系统。这一发现将对勘查地球化学中采样密度的选择、地球化学场模拟、异常评价等根本性问题产生重大影响。     

火试金法测定铜精矿中金含量结果的不确定度评定

对火试金法测定铜精矿中金含量的结果进行不确定度评定。分析了铜精矿样品称量、铜精矿样品的不均匀性和配料处理,以及金粒称量等因素对金含量测量结果不确定度的影响,并得出火试金法测量铜精矿中金含量的扩展不确定度。     

河南洛宁段河金矿流体包裹体研究和矿床成因

河南省洛宁县段河石英脉型金矿主要包括石寨沟和岭东两个矿区,分别由3～4条含金石英脉构成。矿化过程从早到晚包括石英-黄铁矿、石英-多金属硫化物和石英-碳酸盐等3个阶段．其中中阶段金矿化最强,次为早阶段。各阶段石英中流体包裹体以气液两相包裹体为主．次为纯液体包裹体。激光拉曼测试表明,气液两相包裹体的液相为H2O,气相主要为Ho和CO2混合、纯H2O,次为纯CO2;纯液体包裹体为纯H2O。石寨沟矿区包裹体均一温度从早到晚依次为240．9～315．9℃．188．7～304．5℃,137．3～259．3℃：流体盐度变化依次为（6．74～12．85）wt%NaCl．eq,（2．41～8．68）wt％NaCl．eq,（2．24-7．86）wt%NaCl．eq。岭东矿区均一温度从早到晚依次为303．7-343．1℃,251．8-325．4℃,305．7～355．0℃：流体盐度变化依次为（5．11～11．70）wt％NaCl．eq,（2．74-10．11）wt％NaCl．eq,（0．53-6．74）wt％NaCl．eq。两矿区主成矿期流体均为中温、低盐度,早阶段流体为改造热液和变质热液的混合体,含一定量CO2,且流体CO2含量和盐度从早到晚逐渐降低。石寨沟矿区包裹体均一温度逐渐降低,而岭东矿区包裹体均一温度先降后升,加之岭东矿区各阶段成矿温度均高于石寨沟矿区．表明成矿流体系统主要受岩浆热驱动,岭东矿区更靠近岩体,且在晚阶段又有脉动性的岩浆加热．段河金矿区南部存在隐伏岩体。