我国煤炭资源开发利用中某些问题的探讨

针对我国煤炭资源开发利用中存在的诸如煤炭资源的低效率应用、无序开采、生态环境恶化等问题，指出了我国煤炭资源管理法规中存在的问题，提出了加强煤炭资源开发管理、构建煤炭循环经济体系、加大安全投入、加强煤炭矿区环境的治理和保护、健全有偿使用资源法规制度等对策。     

金刚石中分子氢的赋存状态研究

金刚石中分子氢的定向红外光谱研究表明在垂直于(100),(110)和(111)三个方向上所测得分子氢的浓度是不相同的,且不同样品中的变化趋势也不同,即分子氢在金刚石中的定向性不明显;MNDO法计算结果显示分子氢在金刚石中的稳定程度大小关系依次为沿〈111〉定向的键心与反键心组合(a.b+b.c)〉六角体空隙(H)〉四面体空隙(T1)〉菱形中心(C1＝C2)〉四面体空隙(T2).     

Inelastic displacement ratios for evaluation of existing structures

Results of a detailed statistical study of constant relative strength inelastic displacement ratios to estimate maximum lateral inelastic displacement demands on existing structures from maximum lateral elastic displacement demands are presented. These ratios were computed for single‐degree‐of‐freedom systems with different levels of lateral strength normalized to the strength required to remain elastic when subjected to a relatively large ensemble of recorded earthquake ground motions. Three groups of soil conditions with shear wave velocities higher than 180m/s are considered. The influence of period of vibration, level of lateral yielding strength, site conditions, earthquake magnitude, distance to the source, and strain‐hardening ratio are evaluated and discussed. Mean inelastic displacement ratios and those associated with various percentiles are presented. A special emphasis is given to the dispersion of these ratios. It is concluded that distance to the source has a negligible influence on constant relative strength inelastic displacement ratios. However, for periods smaller than 1s earthquake magnitude and soil conditions have a moderate influence on these ratios. Strain hardening decreases maximum inelastic displacement at a fairly constant rate depending on the level of relative strength for periods of vibration longer than about 1.0s while it decreases maximum inelastic displacement non‐linearly as the period of vibration shortens and as the relative‐strength ratio increases for periods of vibration shorter than 1.0s. Finally, results from non‐linear regression analyses are presented that provide a simplified expression to be used to approximate mean inelastic displacement ratios during the evaluation of existing structures built on firm sites. Copyright © 2003 John Wiley & Sons, Ltd.     

Cyclic tests on large‐scale models of existing bridge piers with rectangular hollow cross‐section

Cyclic tests on two large‐scale models of existing bridge piers with rectangular hollow cross‐section were performed in the ELSA laboratory. The prototype structure is an existing reinforced concrete highway bridge constructed in Austria in 1975. The piers presented several seismic deficiencies and consequently they showed poor hysteretic behaviour and limited deformation capacity as well as undesirable failure modes that do not comply with the requirements of modern codes for seismic‐resistant structures. Experimental data are compared to numerical and empirical predictions. Copyright © 2003 John Wiley & Sons, Ltd.     

湖南黄金洞金矿毒砂中Au赋存状态的电子探针研究

本文利用ＪＸＡ－８８００Ｍ超大型电子探针，以湖南黄金洞金矿含金毒砂为研究对象。利用金特征Ｘ－射线扫描方法和微区含金含量，对不可见金赋存状态的研究方法和温试条件进行了探索，先观察背散射电子图像，排除金在含金矿物毒砂中呈显显微颗粒存在的可能性，继而用ＬｉＦ晶体测定金Ｌ＝８８．７６Ｌａｌ峰位，然后逐渐放大倍数（ｘ３００，ｘ１０００，ｘ５０００，ｘ３００００，ｘ２０００００）进行金特征，Ｘ－射线连续测量，，结果发现金元素总 是均匀分布在重砂中，从而证实了金呈品格金形式存在的推测。     

The hydrocarbon generation mechanism and the three-stage type model of hydrocarbon generation for carbonate source rocks

The diagenetic mechanism and process of carbonate rocks, which is different to that of clastic rocks, decides the existence of different existing state organic matters in carbonate rocks. This has been verified by both the microscopic observation of organic petrology and the analysis of organic geochemistry of many samples. Based on the hydrous pyrolysis simulation experiment of the low-mature carbonate rocks, the contrasting study on the yield and their geochemistry characteristics of different existing state soluble organic matters of a series of various maturity samples shows that the different existing state organic matters make different contributions to hydrocarbon generation during every evolution state. So that, the hydrocarbon generation process of carbonate rocks can be summarized as the following three stages: the first is the direct degradation of biogenic bitumen macromolecules during the immature stage, the second is the thermal degradation of a large amount of kerogen at the mature stage, the last stage is the expulsion or release of inclusion organic matter owing to the increased thermal expansion pressure during the high evolution stage. Part of achievements of the Eighth Five-Year National Science-Technology Key-Task Project “85-102-02-07”.     

综合分析技术在微细粒浸染型金矿金赋存状态研究中的应用

采用化学组分分析、物相分析、粒度筛析、X射线面扫描分析、矿物分离分析并结合数理统计分析等综合分析技术对微细粒浸染型金矿进行工艺矿物学研究,较为快速、准确地查明该金精矿金的赋存状态.几种分析方法互为补充,结果吻合.     

既有建筑地基基础加固劈裂注浆法在青纸汽运办公楼的应用

青纸汽运办公由于部分基础座落在松散的杂填土层上，产生不均匀沉降破坏，通过劈裂注浆加固，建筑物停止沉降，地基土承载力标准值提高了4倍，效果显著。加固劈裂注浆法是治理既有建筑地基基础沉降灾害的有效方法之一。     

“入世“给地质勘查业带来的机遇与挑战

我国"入世"后,外国跨国公司必然会进入我国的地质市场.对比,本文指出了国内地勘单位与跨国公司相比,在技术力量、资本和管理水平等方面存在的问题,以及它们的介入所带来的不利影响和机遇,针对这些问题提出了具体的对策及所采取的措施.     

Development and validation of a metallic haunch seismic retrofit solution for existing under‐designed RC frame buildings

The feasibility and efficiency of a seismic retrofit solution for existing reinforced concrete frame systems, designed before the introduction of modern seismic‐oriented design codes in the mid 1970s, is conceptually presented and experimentally investigated. A diagonal metallic haunch system is introduced at the beam–column connections to protect the joint panel zone from extensive damage and brittle shear mechanisms, while inverting the hierarchy of strength within the beam–column subassemblies and forming a plastic hinge in the beam. A complete step‐by‐step design procedure is suggested for the proposed retrofit strategy to achieve the desired reversal of strength hierarchy. Analytical formulations of the internal force flow at the beam–column‐joint level are derived for the retrofitted joints. The study is particularly focused on exterior beam–column joints, since it is recognized that they are the most vulnerable, due to their lack of a reliable joint shear transfer mechanism. Results from an experimental program carried out to validate the concept and the design procedure are also presented. The program consisted of quasi‐static cyclic tests on four exterior, ? scaled, beam–column joint subassemblies, typical of pre‐1970 construction practice using plain round bars with end‐hooks, with limited joint transverse reinforcement and detailed without capacity design considerations. The first (control specimen) emulated the as‐built connection while the three others incorporated the proposed retrofitted configurations. The experimental results demonstrated the effectiveness of the proposed solution for upgrading non‐seismically designed RC frames and also confirmed the applicability of the proposed design procedure and of the analytical derivations. Copyright © 2006 John Wiley & Sons, Ltd.