Modelling the effect of changing precipitation inputs on deep soil water utilization

Forests in the Southeastern United States are predicted to experience future changes in seasonal patterns of precipitation inputs as well as more variable precipitation events. These climate change‐induced alterations could increase drought and lower soil water availability. Drought could alter rooting patterns and increase the importance of deep roots that access subsurface water resources. To address plant response to drought in both deep rooting and soil water utilization as well as soil drainage, we utilize a throughfall reduction experiment in a loblolly pine plantation of the Southeastern United States to calibrate and validate a hydrological model. The model was accurately calibrated against field measured soil moisture data under ambient rainfall and validated using 30% throughfall reduction data. Using this model, we then tested these scenarios: (a) evenly reduced precipitation; (b) less precipitation in summer, more in winter; (c) same total amount of precipitation with less frequent but heavier storms; and (d) shallower rooting depth under the above 3 scenarios. When less precipitation was received, drainage decreased proportionally much faster than evapotranspiration implying plants will acquire water first to the detriment of drainage. When precipitation was reduced by more than 30%, plants relied on stored soil water to satisfy evapotranspiration suggesting 30% may be a threshold that if sustained over the long term would deplete plant available soil water. Under the third scenario, evapotranspiration and drainage decreased, whereas surface run‐off increased. Changes in root biomass measured before and 4 years after the throughfall reduction experiment were not detected among treatments. Model simulations, however, indicated gains in evapotranspiration with deeper roots under evenly reduced precipitation and seasonal precipitation redistribution scenarios but not when precipitation frequency was adjusted. Deep soil and deep rooting can provide an important buffer capacity when precipitation alone cannot satisfy the evapotranspirational demand of forests. How this buffering capacity will persist in the face of changing precipitation inputs, however, will depend less on seasonal redistribution than on the magnitude of reductions and changes in rainfall frequency.     

Fully coupled elastoplastic hydro-mechanical analysis of unsaturated porous media using a meshfree method

This paper presents the first application of an advanced meshfree method, ie, the edge-based smoothed point interpolation method (ESPIM), in simulation of the coupled hydro-mechanical behaviour of unsaturated porous media. In the proposed technique, the problem domain is spatially discretised using a triangular background mesh, and the polynomial point interpolation method combined with a simple node selection scheme is adopted for creating nodal shape functions. Smoothing domains are formed on top of the background mesh, and a constant smoothed strain, created by applying the smoothing operation over the smoothing domains, is assigned to each smoothing domain. The deformation and flow models are developed based on the equilibrium equation of the mixture, and linear momentum and mass balance equations of the fluid phases, respectively. The effective stress approach is followed to account for the coupling between the flow and deformation models. Further coupling among the phases is captured through a hysteretic soil water retention model that evolves with changes in void ratio. An advanced elastoplastic constitutive model within the context of the bounding surface plasticity theory is employed for predicting the nonlinear behaviour of soil skeleton. Time discretisation is performed by adopting a three-point discretisation method with growing time steps to avoid temporal instabilities. A modified Newton-Raphson framework is designed for dealing with nonlinearities of the discretised system of equations. The performance of the numerical model is examined through a number of numerical examples. The state-of-the-art computational scheme developed is useful for simulation of geotechnical engineering problems involving unsaturated soils.     

Fast genetic mapping in barley: case studies of cuticle mutants using RNA-sequencing

Barley(Hordeum vulgare L.) is one of the earliest domesticated crop species and ranked as the fourth largest cereal production worldwide. Forward genetic studies in barley have greatly advanced plant genetics during the last century; however, most genes are identified by the conventional mapping method. Array genotyping and exome-capture sequencing have also been successfully used to target the causal mutation in barley populations, but these techniques are not widely adopted because of associated costs and partly due to the huge genome size of barley. This review summarizes three mapping cases of barley cuticle mutants in our laboratory with the help of RNA-sequencing. The causal mutations have been successfully identified for two of them and the target genes are located in the pericentromeric regions. Detailed information on the mapping-by-sequencing, mapping-and-sequencing, and RNA-sequencing assisted linkage mapping are presented and some limitations and challenges on the mapping assisted by RNA sequencing are also discussed. The alternative and elegant methods presented in this review may greatly accelerate forward genetics of barley mapping, especially for laboratories without large funding.     

超基性岩中含铜、钴块状硫化物矿床——德尔尼铜矿成因新认识

长期以来对德尔尼铜矿的成因存在着不同认识。从矿石组成和结构、构造来看,应属典型的块状硫化物矿石,矿床亦应属于含铜黄铁矿型矿床。但从其地质产状来看又与一般的黄铁矿型矿床大不相同,与一般的岩浆熔离铜镍硫化物矿床也有较多差异。这就是本矿床类型独特之处。近年来通过工作又取得一些新资料,特别是超基性岩和矿石的同位素年龄数据。本文在综合新老资料基础上,提出新看法,认为该矿床形成于上地幔,再就位于地壳浅部。其成因类型暂定为:“深部熔离—构造侵位矿床”。鉴于本矿床与一般块状硫化物矿床相比有其独特性,建议命名为“德尔尼型”。     

Formation Pressure Evaluation Method for Single Well

The paper deals with the methods of formation pressure evaluation for a single well by using the very common ac-cepted parameters, such as drilling exponent , and flowline temperature , etc. which is part of compiling the end well report.     

The Expansion of the Distance Between Two Arbitrary Gravitating Points as Applied to Specific Models of Celestial Bodies

For the complete system of biharmonic functions a suitable representation in spheroidal coordinates is found. It is used for expanding the distance between two arbitrary gravitating points and its inverse quantity in appropriate series. Such expansions can be of interest and useful in a number of problems of celestial mechanics and stellar dynamics.     

Deep Processes of Basin Evolution:A Case Study of the Southern Songliao Basin and Adjacent Area,NE China in Mesozoic-Cenozoic

1IntroductionOne of the key factors related to basin geody-namics is deep process controlling formation and evolution of sedimentary basin. Depth and tempera-ture of asthenosphere,existence of mantle plume,occurrence of mantle melting,and amounts of melts under depressurization during thinning of lithosphere are controlling factors influenced formation and characteristics of extensional basin directly (Li,1994). Rifting is probably governed by frictional forces exerted on the base of litho…     

Tests and constraints on theories of galaxy formation and evolution

Tests and constraints on current theories of galaxy formation and evolution are presented. They are derived from observations of the Northern Hubble Deep Field with WFPC2 and NICMOS. Photometric redshifts, extinctions and spectral energy distributions are calculated for all objects in the field. The tests and constraints are derived from the output of this analysis. The tests of the predictions from hierarchical and pure luminosity evolution galaxy evolution calculations favor the hierarchical model. Constraints are provided by the current luminosity function and its evolution to a redshift of 6. This revised version was published online in August 2006 with corrections to the Cover Date.     

Reliability assessment of serviceability performance of braced retaining walls using a neural network approach

In urban environments, one major concern with deep excavations in soft clay is the potentially large ground deformations in and around the excavation. Excessive movements can damage adjacent buildings and utilities. There are many uncertainties associated with the calculation of the ultimate or serviceability performance of a braced excavation system. These include the variabilities of the loadings, geotechnical soil properties, and engineering and geometrical properties of the wall. A risk‐based approach to serviceability performance failure is necessary to incorporate systematically the uncertainties associated with the various design parameters. This paper demonstrates the use of an integrated neural network–reliability method to assess the risk of serviceability failure through the calculation of the reliability index. By first performing a series of parametric studies using the finite element method and then approximating the non‐linear limit state surface (the boundary separating the safe and ‘failure’ domains) through a neural network model, the reliability index can be determined with the aid of a spreadsheet. Two illustrative examples are presented to show how the serviceability performance for braced excavation problems can be assessed using the reliability index. Copyright © 2005 John Wiley & Sons, Ltd.     

Application of stress release models to historical earthquakes from North China

Univariate and multivariate stress release models are fitted to historical earthquake data from North China. It is shown that a better fit is obtained by treating separately the Eastern part of the region, including the North China Plain and Bohai Sea, and the Western part of the region, including the Ordos Plateau and its Eastern boundary. Further improvement is obtained by fitting the large events (M7.6) and smaller events in the Western region by different stress release models. The comparisons are made by computing the likelihoods of the fitted models and discounting the number of parameters used by Akaike's AIC criterion. The models are used to develop long-term risk scenarios for the East and West regions.