Spectroscopic binaries near the North Galactic Pole paper 18: HD 118670

Photoelectric radial-velocity measurements show that HD 118670 is a double-lined spectroscopic binary in an orbit which is not quite circular and whose period is about 48 days. Spectral types of K0 V and K7 V would satisfy the photometry and the mass ratio; the mass function would then suggest the possibility of eclipses. However, actual spectral classification indicates a luminosity somewhat above the main sequence     

Crustal and upper mantle structures of the brazilian coast

The Rayleigh wave phase and group velocities in the period range of 24–39 sec, obtained from two earthquakes which occurred in northeastern brazil and which were recorded by the Brazilian seismological station RDJ (Rio de Janeiro), have been used to study crustal and upper mantle structures of the Brazilian coastal region. Three crustal and upper mantle models have been tried out to explain crustal and upper mantle structures of the region. The upper crust has not been resolved, due basically to the narrow period range of the phase and group velocities data. The phase velocity inversions have exhibited good resolutions for both lower crust and upper mantle, with shear wave velocities characteristic of these regions. The group velocity data inversions for these models have showed good results only for the lower crust. The shear wave velocities of the lower crust (3.86 and 3.89 km/sec), obtained with phase velocity inversions, are similar to that (=3.89 km/sec) found byHwang (1985) to the eastern South American region, while group velocity inversions have presented shear velocity (=3.75 km/sec) similar to that (=3.78 km/sec) found byLazcano (1972) to the Brazilian shield. It was not possible to define sharply the crust-mantle transition, but an analysis of the phase and group velocity inversions results has indicated that the total thickness of the crust should be between 30 and 39 km. The crustal and upper mantle model, obtained with phase velocity inversion, can be used as a preliminary model for the Brazilian coast.     

Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.     

Experimental Investigation of Instantaneous Properties of Wave Slamming on the Plate

The purpose of this paper is to investigate the instantaneous properties of wave slamming on the plate structure of an open structure.The advanced instantaneous measuring technique-Particle Image Velocimetry(PIV) is applied to acquire the instantaneous velocity field of wave slamming.From the cross-correlation analysis results of the images captured by the CCD camera,the flow fields of wave impacting on the structure are displayed visually,and the instantaneous whole-field fluid velocity vectors are obtained.The relation between the instantaneous peak impacting pressures and the instantaneous velocities of water particles is studied by probability analysis.     

肋柱式锚杆支挡结构的徐变次内力分析

采用老化徐变理论和等效弹性模量法,对肋柱式锚杆支挡结构的徐变影响提出了具体计算方法,并通过实例计算了支挡结构的徐变次内力。计算结果表明,在逆作法条件下,随着开挖深度的加大,岩土侧向压力也增大,使后期施工的混凝土构件产生的徐变次内力也随之增大;考虑徐变后使结构设计更加安全可靠,尤其坡脚处后期浇筑的混凝土构件,更要关注徐变的影响。     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

Ductile deformation of garnet in mylonitic gneisses from the Münchberg Massif (Germany)

Mylonitic gneisses from the Münchberg Massif contain single grains (type I) and polycrystalline aggregates (type II) of garnet displaying a distinct elongation parallel to a macroscopic lineation which is interpreted as the result of ductile deformation. Lattice-preferred orientations of quartz (textures) symmetrical to the macroscopic foliation and lineation and the lack of rotational microfabrics indicate that the bulk deformation was pure shear at least during the latest strain increments. Garnet textures measured by EBSD together with microprobe analyses demonstrate that these two structural types of garnet can be related to two different processes of ductile deformation: (1) For the single grains stretching can be attributed to diffusion creep along grain boundary zones (Coble creep). The related mass transfer is indicated by the fact that primary growth zones are cut off at the long faces of the grains while the related strain shadow domains do not show comparable chemical zoning. Pressure solution and precipitation suitable to produce similar structures can be largely ruled out because retrogressive reactions pointing to the presence of free hydrous fluids are missing. (2) For the polycrystalline garnet aggregates consisting of cores grading into fine-grained mantles, dislocation creep and associated rotation recrystallization can be assumed. Continuous lattice rotation from the core to the outer polycrystalline rim allow a determination of the related dominant slip systems which are {100}<010> and equivalent systems according to the cubic lattice symmetry. The same holds for garnets which appear to be completely recrystallized. For this type of fine-grained aggregates an alternative nucleation model is discussed. Due to penetrative dislocation glide in connection with short range diffusion and the resulting lattice rotation, primary growth zones are strongly disturbed.Since for the considered rock unit of the Münchberg Massif peak metamorphic temperatures between 630 and 670 °C can be assumed, this study clearly demonstrates that the inferred processes of ductile garnet deformation can occur not only in HT regimes as often suggested in the literature even if embedded within a matrix of “low-strength” minerals like quartz, feldspars and micas.     

Crustal structure of the Eastern Alps along the TRANSALP profile from wide-angle seismic tomography

The objective of the TRANSALP project is an investigation of the Eastern Alps with regard to their deep structure and dynamic evolution. The core of the project is a 340-km-long seismic profile at 12°E between Munich and Venice. This paper deals with the P-wave velocity distribution as derived from active source travel time tomography. Our database consists of Vibroseis and explosion seismic travel times recorded at up to 100 seismological stations distributed in a 30-km-wide corridor along the profile. In order to derive a velocity and reflector model, we simultaneously inverted refractions and reflections using a derivative of a damped least squares approach for local earthquake tomography. 8000 travel time picks from dense Vibroseis recordings provide the basis for high resolution in the upper crust. Explosion seismic wide-angle reflection travel times constrain both deeper crustal velocities and structure of the crust–mantle boundary with low resolution. In the resulting model, the Adriatic crust shows significantly higher P-wave velocities than the European crust. The European Moho is dipping south at an angle of 7°. The Adriatic Moho dips north with a gentle inclination at shallower depths. This geometry suggests S-directed subduction. Azimuthal variations of the first-break velocities as well as observations of shear wave splitting reveal strong anisotropy in the Tauern Window. We explain this finding by foliations and laminations generated by lateral extrusion. Based on the P-wave model we also localized almost 100 local earthquakes recorded during the 2-month acquisition campaign in 1999. Seismicity patterns in the North seem related to the Inn valley shear zone, and to thrusting of Austroalpine units over European basement. The alignment of deep seismicity in the Trento-Vicenza region with the top of the Adriatic lower crust corroborates the suggestion of a deep thrust fault in the Southern Alps.