Gradation affects basic mechanical characteristics of Chinese calcareous sand as airport subgrade of reefs

Abstract

Construction of the reefs in the South China Sea is a significant foundation to the secure stability and economic development of China. The construction of an airport runway is necessary for this realization. The calcareous sand is the main primary material in the runway construction. A certain type of calcareous sand near a certain reef of the South China Sea was studied in this paper. To investigate this specific calcareous sand, quartz sand was used as a reference for comparison. Microscopic 3-D imaging, compression and triaxial tests were conducted to test the micro, squeezing and shear properties. The effect mechanism of gradation on the calcareous sand’s compressibility and shear characteristics are discussed from a mesoscopic viewpoint using 3-D morphology. Calcareous sand particles are multiangular and flatter in comparison with quartz sand. The larger the particle sizes are, the more different the two sands’ morphologies are. The compressibility of calcareous sand is greater, and the effect of the coarse fraction (5–1?mm) content in the gradation plays the most significant role in this feature. When the coarse particles’ content is less than 25% and the mass ratio of the middle and fine particles (M) is constant, there is the worst coarse fraction content causing the calcareous sand to be most likely compressed. The worst coarse fraction content decreases with the increase in M, and an empirical formula is proposed. When the gradation, relative density and confining pressure are the same, the peak shear stress and strain of calcareous sand are all at a high level. The effect of confining pressure is manifested in calcareous sand. The shear strength and dilation of calcareous sand are also most affected by the medium coarse fraction (5–0.25?mm) content.     

对一种振冲碎石桩复合地基沉降计算方法——Priebe法的改进

通过对经典的Priebe沉降计算法分析,以及面积置换率的变化对桩体压缩性假设作了改进;对桩土重度差异及承受荷载时应力和变形与深度的关系作了分析,归纳出相应的数学计算公式,用工程实例进行了验证。得到的结果表明改进是合理、适用的,可为今后的设计和施工提供参考。     

肋柱式锚杆支挡结构的徐变次内力分析

采用老化徐变理论和等效弹性模量法,对肋柱式锚杆支挡结构的徐变影响提出了具体计算方法,并通过实例计算了支挡结构的徐变次内力。计算结果表明,在逆作法条件下,随着开挖深度的加大,岩土侧向压力也增大,使后期施工的混凝土构件产生的徐变次内力也随之增大;考虑徐变后使结构设计更加安全可靠,尤其坡脚处后期浇筑的混凝土构件,更要关注徐变的影响。     

(ϖμ/ϖT) P of the lower mantle

We estimate (/T) _P of the lower mantle at seismic frequencies using two distinct approaches by combining ambient laboratory measurements on lower mantle minerals with seismic data. In the first approach, an upper bound is estimated for |(/T) _P | by comparing the shear modulus () profile of PREM with laboratory room-temperature data of extrapolated to high pressures. The second approach employs a seismic tomography constraint ( lnV _S / lnV _P ) _P =1.8–2, which directly relates (/T) _P with (K _S /T) _P . An average (K _S /T) _P can be obtained by comparing the well-established room-temperature compression data for lower mantle minerals with theK _S profile of PREM along several possible adiabats. Both (K _S /T) and (/T) depend on silicon content [or (Mg+Fe)/Sil of the model. For various compositions, the two approaches predict rather distinct (/T) _P vs. (K _S /T) _P curves, which intersect at a composition similar to pyrolite with (/T) _P =–0.02 to –0.035 and (K _S /T) _P =–0.015 to –0.020 GPa/K. The pure perovskite model, on the other hand, yields grossly inconsistent results using the two approaches. We conclude that both vertical and lateral variations in seismic velocities are consistent with variation due to pressure, temperature, and phase transformations of a uniform composition. Additional physical properties of a pyrolite lower mantle are further predicted. Lateral temperature variations are predicted to be about 100–250 K, and the ratio of ( lnp/ lnV _S ) _P around 0.13 and 0.26. All of these parameters increase slightly with depth if the ratio of ( lnV _S / lnV _P ) _P remains constant throughout the lower mantle. These predicted values are in excellent agreement with geodynamic analyses, in which the ratios ( ln / lnV _S ) _P and ( / lnV _S ) _P are free parameters arbitrarily adjusted to fit the tomography and geoid data.     

Effects of ageing and overconsolidation on the elastic stiffness of a remoulded clay

Summary Results of resonant column tests were used to determine values of low amplitude shear modulus (G ₀) of a remoulded kaolinite clay for different durations of ageing and for different values of consolidation stress (₀) and overconsolidation ratio (OCR). It was found that after completion of primary consolidation the values of G ₀ increased linearly with the logarithm of time and after a week of confinement the value of normalized rate of secondary increase of shear modulus (N _G ) could be reliably estimated. Values of N _G were found to derease linearly with the logarithm of OCR and with the logarithm of ageing duration. This similarity of behaviour provided a basis for establishing an equivalency between age and equivalent overconsolidation ratio (OCR)_eq. The effects of ₀ and OCR on the value of G ₀ were also established in a functional form that indicated a stronger influence compared to that predicted by the Hardin Equation.     

Experimental investigation of the elastic modulus of a fractal system—A model of fractured rocks

The elastic properties of a physical model representing a damaged rock matrix were studied using a square lattice deformed under tensile stress. The elastic modulusM of such a system varies in agreement with percolation theory as|x–x _c | ^f , wherex is the damage parameter andx _c the threshold value of the damage parameter,f3.6. Atxx _c the scale dependence ofM can be expressed asML ^–f/v , whereL is the size of the sample andv the correlation exponent in percolation theory.The experimental results are of interest in assessing elastic properties in earthquake focal zones and fault zones in general.     

Atomistic calculations of structural and elastic properties of serpentine minerals: the case of lizardite

The physical properties of the hydrous phyllosilicate lizardite have been investigated by atomistic simulation using the GULP code based on transferable semi-empirical interatomic potentials. Lizardite behavior was first investigated during structure relaxation at room temperature. The Helmholtz free energy is minimum for an equilibrium structure that is in agreement with experiment. The bulk, shear, and Young modulii for lizardite were calculated along with the Poisson ratio. From the shear and bulk modulii, we also calculated translational and longitudinal acoustic wave velocities that are important quantities for tectonophysics models. As expected, lizardite is stiffer in the a direction parallel to the layers than in the c perpendicular direction; the variation of the unit cell parameters with pressure is in good agreement with experiment. The cohesive energy between two successive layers along c direction was calculated at 0.33 eV (i.e., 0.11 eV per OH bond) in good agreement with recent ab initio calculations. Upon pressure and temperature variations, we evidenced that structural changes are mainly pressure induced; pressure being accommodated by a decrease of the c parameter up to 10 GPa. We also found that the change of slope in the derivative of the c cell parameter with respect to pressure occurring around 2 GPa originates from the bending of the interlayer hydroxyl groups with respect to the layer normal direction.     

Compressibility and shear strength of a residual soil

A detailed study was performed to investigate the compressibility and the shear strength of a residual soil in Omdurman, Sudan. The soil resulted from weathering of sandstone and mudstone. The soil is classified as sandy clayey silt (MH-CH) and is generally partially saturated. Consolidation tests were performed to study the compressibility of the soil and UU, CIU and insitu tests (CPT and SPT) were performed to study the shear strength characteristics of the soil. The characteristics of this residual soil can generally be predicted using correlations proposed in the literature for transported soils. The soil is of low to medium compressibility and exhibits slight apparent overconsolidation behavior. The soil dilates during shear and shows no long term effective cohesion. Problems associated with open cuts in this soil are attributed to loss of strength upon saturation.     

Deformability characteristics of brazilian laterites

This paper summarizes the resilient and permanent deformation characteristics of laterite gravels, determined by cyclic loading in triaxial tests of compacted specimens. A study of laterite pavements was carried out on eight paved road sections in the state of Mato Grosso. Also reported is the influence of fine sand admixture, specimen size and soaking in two laterite samples from Roraima and Rondônia in the North of Brazil. The experimental relationships of resilient moduli against applied stresses are interpreted empirically for models what may be incorporated in a structural analysis of full depth of laterite pavement.