PVC-U塑料管在浅层地热能地下水资源开发工程中应用与研究

PVC-U塑料管具有耐腐蚀、不结垢、质量轻、使用寿命长等特点。将其应用于浅层地热能开发和供水管井工程中,不但可以解决金属井管腐蚀破裂、结垢和水源热泵回灌难等问题,而且还减少了水井维修费用、延长其使用寿命。结合河南郑州实施的437、400 m两眼浅层地热能开发和供水管井示范工程实践,详细论述了PVC-U塑料管成井工艺、存在问题及解决方法的研究成果。     

Stress Sharing Behavior and Its Mechanism during Consolidation Process in Composite Ground Improved by Sand Compaction Piles with Low Replacement Area Ratio

In order to accurately design a sand compaction pile (SCP) with low replacement area ratio, it is important to understand the mechanical interaction between the sand pile and clay ground and its mechanism during consolidation process in composite ground. In this article, therefore, a series of numerical analyses on composite ground improved by SCP with low replacement area ratio were carried out. The applicability of numerical analyses, in which an elasto-viscoplastic consolidation finite element method was applied, were confirmed by comparing the results obtained from a series of laboratory model tests with the composite ground improved by SCP. Through the results of the numerical analyses, mechanical behavior of the sand pile and clay in composite ground during consolidation is elucidated, together with a stress sharing mechanism between sand pile and clay.     

Field measurements and monitoring of wastewater discharge in sea water

This paper reports a study of the field measurements and monitoring of wastewater discharge in sea water at Bari East (Italy). A wastewater sea outfall system is an integral and fundamental part of each wastewater treatment with ultimate sink in the sea water. The design of a water treatment plant and wastewater outfall must take into account the use of the environmental water, the values of physicochemical parameters to be respected in order to safeguard the use itself and the quality of the environmental water where wastewater is issued. In the present study measurements of sea current velocity components were carried out with a VM-ADP (Vessel-Mounted Acoustic Doppler Profiler). Salinity, wind directions and velocities were assessed with, for one survey, the total faecal coliforms and other biochemical parameters. It was emphasized that the measurements necessary for monitoring cannot be concentrated in the wastewater outfall pipe zone only, but should be extended to a neighbouring area of the outfall pipe, with an extension depending on the wastewater discharge, the polluting charge and the magnitude of the sea currents and the winds typical of the zone of interest. The analyses presented in this paper confirm that the sea zones close to the wastewater outfall pipe are particularly sensitive and vulnerable. Such results must be considered in the planning of a wastewater outfall pipe.     

苏北盐城凹陷复合含油气系统

苏北盐城凹陷含油气系统可划分为上、下2个复合含油气系统。上复合含油气系统，即Pz、K2p、K2t(生)-K2t、E1f1(储)一E1f1 E1f2(盖)，古生界、中生界浦口组和泰州组为烃源岩层，泰州组和阜宁组一段为储集层，阜宁组一段顶部至二段暗色泥岩为区域盖层，油气沿深大断裂运移，油气成藏关键时刻在古近纪晚期至新近纪早期，有利勘探区在深大断裂附近的中、新生界发育地区；下复合含油气系统，即Pz、K2p(生)-Pz、K2p(储)-K2p3 K2p4(盖)，油气通过断层或不整合运移，油气大量生成的关键时刻为古近纪早期，该系统中气藏分布在古生界被中生界覆盖地区。     

Influence of large-diameter pipe pile driving on surrounding marine soils and adjacent submarine pipelines

Abstract

With the large-scale development and utilization of ocean resources and space, it is inevitable to encounter existing submarine facilities in pile driving areas, which necessitates a safety assessment. In this article, by referring to a wharf renovation project as a reference, the surrounding soil response and buried pipe deformation during pile driving in a near-shore submarine environment are investigated by three-dimensional (3D) numerical models that consider the pore water effect. Numerical studies are carried out in two different series: one is a case of a single pile focusing on the effect of the minimum plane distance of the pile–pipe, and the other is a case of double piles focusing on the effect of the pile spacing.     

深层搅拌法在超软弱港口地基上的工程应用

某港口堆场地基上部5．0m系吹填而成，地表下18m范围均属软土，经真空预压初级加固后地基承载力仅在80—90kPa，局部区域上部淤泥土层土性指标较差，含水量大于50％，地基承载力不足60kPa。为了使地基达到230kPa的承载要求，设计采用深层搅拌法加固超软弱地基。通过现场成桩工艺试验和检测表明，桩身水泥土强度在90d龄期时大于1．80MPa，单桩承载力标准值大于150kN，以φ600桩径、桩长13．5m、置换率为0．308和φ500桩径、桩长13．5m、置换率为0．267两种方案布置的复合地基承载力标准值均超过了230kPa的设计要求。试验结果表明，深层搅拌法在港口超软弱地基土应用只要施工工艺适当，完全可以使地基承载力提高2—3．5倍以土，从而节省大量的工程投资。     

基于粉喷桩复合地基沉降计算的探讨

在对粉喷桩复合地基现有的沉降计算理论分析的基础上,结合粉喷桩的荷载传递规律,提出符合工程实际的沉降计算方法。     

粉煤灰垫层与夯扩灌注桩联合处理高层建筑地基

利用夯扩灌注桩对桩端持力层的加密作用，可解决水下填筑问题，利用粉煤灰的可压密性和夯扩灌注桩承载力高的特点，可大幅提高复合地基承载力，减少工程投资。以河南洛阳某高层建筑为例，介绍了粉煤灰垫层和夯扩灌注桩组成的刚性桩复合地基在高层建筑地基中的应用。     

GIS-based flood hazard mapping at different administrative scales: A case study in Gangetic West Bengal, India

This paper addresses the need for an efficient and cost-effective methodology for preparing flood hazard maps in data poor countries, particularly those under a monsoon regime where floods pose a recurrent danger. Taking Gangetic West Bengal, India, as an example and using available historical data from government agencies, the study compiled a regional map indicating hazard prone subregional areas for further detailed investigation, thereby isolating actual high risk localities. Using a GIS (Geographical Information System), a composite hazard index was devised incorporating variables of flood frequency, population density, transportation networks, access to potable water, and availability of high ground and maximum risk zones were mapped accordingly. A digital elevation model derived from high resolution imagery available in the public domain was used to calculate elevated areas suitable for temporary shelter during a flood. Selecting administrative units of analysis at the lowest possible scales – rural development blocks (regional) and revenue villages (subregional) – also ensures that hazard mapping is prepared in line with the existing rural planning and administrative authorities responsible for remedial intervention.     

Monitoring of Over Cutting Area and Lubrication Distribution in a Large Slurry Pipe Jacking Operation

Slurry pipe jacking was firmly established as a special method for the non-disruptive construction of the underground pipelines of sewage systems. Pipe jacking, in its traditional form, has occasionally been used for short railways, roads, rivers, and other projects. Basically the system involves the pushing or thrusting of concrete pipes into the ground by a number of jacks. In slurry pipe jacking, during the pushing process, mud slurry and lubricant are injected into the face and the over cutting area that is between the concrete pipes and the surrounding soil. Next, the slurry fills voids and the soil stabilizes due to the created slurry cake around the pipes. Fillings also reduce the jacking force or thrust during operation. When the drivage and pushing processes are finished, a mortar injection into the over cutting area is carried out in order to maintain permanent stability of the surrounding soil and the over cutting area. Successful lubrication around the pipes is extremely important in a large diameter slurry pipe jacking operation. Control of lubrication and gaps between pipes and soil can prevent hazards such as surface settlement and increases in thrust. Also, to find voids around the pipes after the jacking process, in order to inject mortar for permanent stabilizing, an investigation around the pipes is necessary. To meet these aims, this paper is concerned with the utilization of known methods such as the GPR (Ground Penetrating Radar) system and borehole camera to maintain control of the over cutting area and lubricant distribution around the pipes during a site investigation. From this point of view, experiments were carried out during a tunnel construction using one of the largest cases of slurry pipe jacking in Fujisawa city, Japan. The advantages and disadvantages of each system were clarified during the tests.