Effects of the geometry of two‐dimensional fractures on their hydraulic aperture and on the validity of the local cubic law

Flow through rough fractures is investigated numerically in order to assess the validity of the local cubic law for different fracture geometries. Two‐dimensional channels with sinusoidal walls having different geometrical properties defined by the aperture, the amplitude, and the wavelength of the walls' corrugations, the corrugations asymmetry, and the phase shift between the two walls are considered to represent different fracture geometries. First, it is analytically shown that the hydraulic aperture clearly deviates from the mean aperture when the walls' roughness, the phase shift, and/or the asymmetry between the fracture walls are relatively high. The continuity and the Navier–Stokes equations are then solved by means of the finite element method and the numerical solutions compared to the theoretical predictions of the local cubic law. Reynolds numbers ranging from 0.066 to 66.66 are investigated so as to focus more particularly on the effect of flow inertial effects on the validity of the local cubic law. For low Reynolds number, typically less than 15, the local cubic law properly describes the fracture flow, especially when the fracture walls have small corrugation amplitudes. For Reynolds numbers higher than 15, the local cubic law is valid under the conditions that the fracture presents a low aspect ratio, small corrugation amplitudes, and a moderate phase lag between its walls.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

High-resolution H i and radio continuum observations of the SNR G290.1−0.8

We have observed the supernova remnant (SNR) G290.1−0.8 in the 21-cm H  i line and the 20-cm radio continuum using the Australia Telescope Compact Array (ATCA). The H  i data were combined with data from the Southern Galactic Plane Survey to recover the shortest spatial frequencies. In contrast, H  i absorption was analysed by filtering extended H  i emission, with spatial frequencies shorter than 1.1 kλ. The low-resolution ATCA radio continuum image of the remnant shows considerable internal structure, resembling a network of filaments across its 13-arcmin diameter. A high-resolution ATCA radio continuum image was also constructed to study the small-scale structure in the SNR. It shows that there are no structures smaller than ∼17 arcsec, except perhaps for a bright knot to the south, which is probably an unrelated object. The H  i absorption study shows that the gas distribution and kinematics in front of SNR G290.1−0.8 are complex. We estimate that the SNR probably lies in the Carina arm, at a distance 7 (±1) kpc. In addition, we have studied nearby sources in the observed field using archival multiwavelength data to determine their characteristics.     

Synthetic SH seismograms in a laterally varying medium by the discrete wavenumber method

Summary. We present a new method to calculate the SH wavefield produced by a seismic source in a half-space with an irregular buried interface. The diffracting interface is represented by a distribution of body forces. The Green's functions needed to solve the boundary conditions are evaluated using the discrete wavenumber method. Our approach relies on the introduction of a periodicity in the source-medium configuration and on the discretization of the interface at regular spacing. The technique developed is applicable to boundaries of arbitrary shapes and is valid at all frequencies. Some examples of calculation in simple configurations are presented showing the capabilities of the method.     

Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)

Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.     

Morphological analysis of the drainage system in the Eastern Alps

We study the morphology of the major rivers draining the Eastern Alps to test whether the active tectonics of this part of the orogen is reflected in the shape of channel profiles of the river network. In our approach we compare channel profiles measured from digital elevation models with numerically modelled channel profiles using a stream power approach. It is shown that regions of high stream power coincide largely with regions of highest topography and largest uplift rates, while the forelands and the Pannonian Basin are characterised by a significantly lower stream power. From stream power modelling we conclude that there is young uplift at the very east of the Eastern Alps, in the Bohemian Massif and in the Pohorje Range. The impact of the Pleistocene glaciations is explored by comparing properties of rivers that drain in proximal and distal positions relative to the ice sheet during the last glacial maximum. Our analysis shows that most knick points, wind gaps and other non-equilibrium features of catchments covered by ice during the last glaciations (Salzach, Enns) can be correlated with glacial processes. In contrast the ice free catchments of the Mur and Drava are characterized by channels in morphological equilibrium at the first approximation and are showing only weak evidence of the strong tectonic activity within these catchments. Finally, the channel profiles of the Adige and the divide between the upper Rhine and Danube catchments differ significantly from the other catchments. We relate this to the fact that the Adige and the Rhine respond to different base levels from the remainder of the Eastern Alps: The Adige may preserve a record from the Messininan base level change and the Rhine is subject to the base level lowering in the Rhine Graben.     

Migration of the Ganga river and its implication on hydro-geological potential of Varanasi area, U.P., India

Borehole data reveals that during Late Quaternary, the Ganga river was non-existent in its present location near Varanasi. Instead, it was flowing further south towards peripheral craton. Himalayan derived grey micaceous sands were being carried by southward flowing rivers beyond the present day water divide of Ganga and mixed with pink arkosic sand brought by northward flowing peninsular rivers. Subsequently, the Ganga shifted to its present position and got incised. Near Varanasi, the Ganga river is flowing along a NW-SE tectonic lineament. The migration of Ganga river is believed to have been in response to basin expansion caused due to Himalayan tectonics during Middle Pleistocene times. Multi-storied sand bodies generated as a result of channel migration provide excellent aquifers confined by a thick zone of muddy sediments near the surface. Good quality potable water is available at various levels below about 70 m depth in sandy aquifers. Craton derived gravelly coarse-to-medium grained sand forms the main aquifer zones of tens of meter thickness with enormous yield. In contrast, the shallow aquifers made up of recycled interfluve silt and sandy silt occur under unconfined conditions and show water-level fluctuation of a few meters during pre-and post-monsoon periods.