Organic carbon deposition and phosphorus accumulation during Oceanic Anoxic Event 2 in Tarfaya, Morocco

With a multi-proxy approach, an attempt was made to constrain productivity and bottom-water redox conditions and their effects on the phosphorus accumulation rate at the Mohammed Plage section on the Tarfaya coast, Morocco, during the Cenomanian-Turonian Anoxic Event (OAE 2). A distinct δ¹³C_org isotope excursion of +2.5‰ occurs close to the top of the section. The unusually abrupt shift of the isotope excursion and disappearance of several planktonic foraminiferal species (e.g. Rotalipora cushmani and Rotalipora greenhornensis) in this level suggests a hiatus of between 40–60 kyrs at the excursion onset. Nevertheless, it was possible to determine both the long-term environmental history as well as the processes that took place immediately prior to and during OAE 2. TOC% values increase gradually from the base of the section to the top (from 2.5% to 10%). This is interpreted as the consequence of a long-term eustatic sea-level rise and subsidence causing the encroachment of less oxic waters into the Tarfaya Basin. Similarly a reduction in the mineralogically constructed ‘detrital index’ can be explained by the decrease in the continental flux of terrigenous material due to a relative sea-level rise. A speciation of phosphorus in the upper part of the section, which spans the start and mid-stages of OAE 2, shows overall higher abundances of P_reactive mass accumulation rates before the isotope excursion onset and lower values during the plateau. Due to the probable short hiatus, the onset of the decrease in phosphorus content relative to the isotope excursion is uncertain, although the excursion plateau already contains lower concentrations. The C_org/P_total and V/Al ratios suggest that this reduction was mostly likely caused by a decrease in the available bottom oxygen content (probably as a result of higher productivity) and a corresponding fall in the phosphorus retention ability of the sediment. Productivity appears to have remained high during the isotope plateau possibly due to a combination of ocean-surface fertilisation via increased aridity (increased K/Al and Ti/Al ratios) and/or higher dissolved inorganic phosphorus content in the water column as a result of the decrease in sediment P retention. The evidence for decreased P-burial has been observed in many other palaeoenvironments during OAE 2. Tarfaya's unique upwelling paleosituation provides strong evidence that the nutrient recycling was a global phenomenon and therefore a critical factor in starting and sustaining OAE 2.     

软硬互层金刚石复合片钻头在地浸砂岩型铀矿中的研究及应用

针对近年在巴音戈壁盆地及鄂尔多斯盆地钻探所遇到的复杂地质情况,研究试验了PDC钻头,在地浸砂岩铀矿钻探生产中取得了良好的效果,并制定总结了相应的钻进参数.     

Wave interaction with a submarine pipeline in clayey soil due to random waves

The wave pressure and uplift force due to random waves on a submarine pipeline (resting on bed, partially buried and fully buried) in clayey soil are measured. The influence of various parameters viz., wave period, wave height, water depth, burial depth and consistency index of the soil on wave pressures around and uplift force on the submarine pipeline was investigated. The wave pressures were measured at three locations around the submarine pipeline (each at 120° to the adjacent one). It is found that the wave pressure and uplift force spectrum at high consistency index of the soil is smaller compared to that of low consistency index. Just burying the pipeline (e/D=1.0) in clayey soil reduces the uplift force to less than 60% of the force experienced by a pipeline resting on the seabed (e/D=0.0) for I_c=0.33.     

硅质碎屑砂岩中胶结物来源的新认识

分析了浅埋藏砂岩的成岩环境,并从岩石学、矿物学、同位素及质量平衡估算方面论证硅质碎屑砂岩中的胶结物主要来源于砂岩浅埋藏期间的地下水,进而分析浅埋藏带内地下水的流动机制及早期胶结作用对晚期成岩作用的影响。     

用于砾石夹层钻进的新型PDC钻头的研制与使用

无压浸渍工艺生产的PDC石油钻头钻遇砾石夹层不适应。根据砾石夹层砾石坚硬、软硬互层、非均质、研磨性强的特点，研究了新型PDC钻头，在钻头结构上主要采取外抛内锥带辅助切削齿的结构形式，在复合片上主要采用非平面结合方式，即采用双向多条直槽非平面结合。按此方案设计与生产了3只钻头，分别在3口井试用，直接钻穿砾石夹层馆陶组地层井段，钻井效率提高26%，突破了砾石夹层钻进不能使用PDC钻头的禁区。     

PDC钻头切削齿破岩载荷规律的分析

对PDC钻头冠部形状及不同的布齿密度和切削齿在不同的磨损状态下对PDC钻头切削齿受力的影响进行了分析；用相邻的3个切削齿之间的关系(不同的切削齿与切削齿之间的径向距离和切削齿之间的高度差)来分析PDC钻头冠部形状和切削齿布齿密度对切削齿受力的影响，以及将切削齿的磨损状态简化成与切削齿在钻头上装配方向垂直的平面来分析切削齿磨损状态对切削齿受力的影响。     

硬致密泥岩钻进的新型复合片钻头的研究与应用

介绍了一种新型齿形的复合片钻头，在硬致密泥岩中钻进，与常规复合片钻头相比，具有很高的钻进效率和高的钻头寿命，解决了泥岩钻进效率低的难题。     

PDC钻头在寺河煤矿瓦斯预抽放钻井中的应用

在寺河矿区一期瓦斯地面预抽放钻井施工中，使用传统的镶齿三牙轮钻头钻进，钻进速度低，仅为2.0m／h，且井斜不易控制、钻头寿命短、成本较高。通过对寺河煤矿地层特征的分析，在二期工程施工中，9#煤以上地层优选六翼内凹式PDC钻头钻进，采取一定技术措施并合理调整钻压、转速及泵量等钻进参数，钻速可达7．0m/h，井斜也得到有效控制，降低了钻井成本。     

含油玄武岩中绿泥石的形成温度

以苏北盆地高邮凹陷闵桥地区含油玄武岩中的绿泥石为研究对象，探讨了其成因和形成温度，认为玄武岩中绿泥石有两种形成方式、五条形成途径：其一为蚀变演化，包括：火山玻璃、斜长石、辉石的蚀变，交代橄榄石斑晶，以及皂石的进一步演化；其二为沉淀结晶，包括从热液中直接沉淀生长和胶体溶液充填后的结晶。计算结果显示，蚀变演化形成的绿泥石，其形成温度为128－271℃；沉淀结晶形成的绿泥石，其形成温度为31－63℃。玄武岩中绿泥石形成温度与埋藏深度间没有明显的线性相关。进一步研究表明，本区玄武岩作为储油层，其进油时的温度为62－118℃，不超出48－137℃。     

电镀PDC石油全面钻头及其在油气田中的应用

采用低温电镀工艺生产ＰＤＣ石油全面钻头对金刚石无任何热损伤，对喷咀进行组合设计，在两口井中进行试验，取得了很好的经济效益和社会效益，并分析了钻头的特点及存在的问题。