Metamorphism in Archaean greenstone belts: calculated fluid compositions and implications for gold mineralization

An inescapable consequence of the metamorphism of greenstone belt sequences is the release of a large volume of metamorphic fluid of low salinity with chemical characteristics controlled by the mineral assemblages involved in the devolatilization reactions. For mafic and ultramafic sequences, the composition of fluids released at upper greenschist to lower amphibolite facies conditions for the necessary relatively hot geotherm corresponds to those inferred for greenstone gold deposits (X_CO2= 0.2–0.3). This result follows from the calculation of mineral equilibria in the model system CaO–MgO–FeO–Al₂O₃–SiO₂–H₂O–CO₂, using a new, expanded, internally consistent dataset. Greenstone metamorphism cannot have involved much crustal over-thickening, because very shallow levels of greenstone belts are preserved. Such orogeny can be accounted for if compressive deformation of the crust is accompanied by thinning of the mantle lithosphere. In this case, the observed metamorphism, which was contemporaneous with deformation, is of the low-P high-T type. For this type of metamorphism, the metamorphic peak should have occurred earlier at deeper levels in the crust; i.e. the piezothermal array should be of the ‘deeper-earlier’type. However, at shallow crustal levels, the piezothermal array is likely to have been of ‘deeper-later’type, as a consequence of erosion. Thus, while the lower crust reached maximum temperatures, and partially melted to produce the observed granites, mid-crustal levels were releasing fluids prograde into shallow crustal levels that were already retrograde. We propose that these fluids are responsible for the gold mineralization. Thus, the contemporaneity of igneous activity and gold mineralization is a natural consequence of the thermal evolution, and does not mean that the mineralization has to be a consequence of igneous processes. Upward migration of metamorphic fluid, via appropriate structurally controlled pathways, will bring the fluid into contact with mineral assemblages that have equilibrated with a fluid with significantly lower X_CO2. These assemblages are therefore grossly out of equilibrium with the fluid. In the case of infiltrated metabasic rocks, intense carbonation and sulphidation is predicted. If, as seems reasonable, gold is mobilized by the fluid generated by devolatilization, then the combination of processes proposed, most of which are an inevitable consequence of the metamorphism, leads to the formation of greenstone gold deposits predominantly from metamorphic fluids.     

电容测试法判断测井电缆系统故障

测井电缆因长途颠簸、拉伸及绞车缠绕挤压,电缆连接器、电缆、绞车滑环、滑环连线等部位极易出现故障。电容测试法是一种简易、快速的检测方法,该法可在现场准确诊断出故障电缆的位置。以四芯铠装电缆为例,每根缆芯的正常阻值约为80Ω/1 000m,两缆芯间的分布电容约为170PPF/1 000m。在实际检测中,根据电容较小时测点的位置,可以有效判断故障部位;而电缆故障位置则可利用电阻及电容的线性关系进行计算予以确定。     

随钻测录井地质导向二维分解实时绘图方法

根据随钻测录井实时地质导向和大斜度、水平井评价成图技术需求，针对传统绘图方法存在的弊端，提出了将测录井信息、井眼轨迹和地质模型进行二维分解的实时绘图方法。针对二维分解绘图方法绘图时空复杂度较高的问题，给出了不同事件驱动下的局部实时计算和拷屏重绘算法，控制了对CPU和内存的消耗、提高了绘图效率，消除了实时绘图的闪烁和卡顿现象。应用实例表明，二维分解实时绘图方法能够实现大尺度随钻测录井地质导向图形的流畅、无卡顿实时绘图，可提高大斜度、水平井储层模型评价的刻画精度和时效。     

HD-4002型综合测井仪

HD 4002型综合测井仪是核工业北京地质研究院于1998年开始研制的, 其目标是为铀矿地质系统提供适合砂岩型铀矿勘查的轻便型数字测井仪, 满足测井生产的需要。该仪器于2001 年3月通过部级鉴定, 2002至2003年投入海拉尔盆地铀矿勘查测井试生产。本文介绍了仪器的用途、功能及特点、性能指标, 简要说明了各部分的工作原理。     

Computational modeling of cyclic mobility and post-liquefaction site response

Under seismic excitation, liquefied clean medium to dense cohesionless soils may regain a high level of shear resistance at large shear strain excursions. This pattern of response, known as a form of cyclic mobility, has been documented by a large body of laboratory sample tests and centrifuge experiments. A plasticity-based constitutive model is developed with emphasis on simulating the cyclic mobility response mechanism and associated pattern of shear strain accumulation. This constitutive model is incorporated into a two-phase (solid–fluid), fully coupled finite element code. Calibration of the constitutive model is described, based on a unique set of laboratory triaxial tests (monotonic and cyclic) and dynamic centrifuge experiments. In this experimental series, Nevada sand at a relative density of about 40% is employed. The calibration effort focused on reproducing the salient characteristics of dynamic site response as dictated by the cyclic mobility mechanism. Finally, using the calibrated model, a numerical simulation is conducted to highlight the effect of excitation frequency content on post-liquefaction ground deformations.     

上海地震台阵的地震定位方法

详细介绍了上海地震台阵数据处理软件系统中的地震定位方法，用台阵的聚束方法得到地震的方位角和视慢度，根据统计得到的视慢度－震中距表推算震中距。并结合了地震台网的定位方法，由单台记录的各类主要震相从J－B走时表得到震中距，然后进行地震定位。该定位方法可对近震、远震进行定位处理，并由深震相得到震源深度。     

Statistical tests for regional seismic phase characterizations

In seismic analysis some assumptions are often made aboutthe data, e.g. stationarity and Gaussianity. This is not obvious for all realseismic data. Here, we use statistical tests for characterization of regionalseismic data. We apply tests for stationarity, symmetry, linearity, andtime-reversibility. In the analysis we use twelve regional seismic events inFennoscandia recorded with the seismic small-aperture arrays NORESS,ARCESS and FINESA at hypocentral distances in the range from 160 to1580 km. For the tests we use the regional phases Pn, secondary P, Sn and Lg-phases and the preceding noise. Two of the eventsare explosions, two are rockbursts and eight are earthquakes. Theperformance and possibilities of using statistical tests based on bispectra, asa complementary tool for conventional analysis of seismic phases isdemonstrated. The preceding noise recorded before the first onset of theP-wave for the twelve events is tested to be spatially stationarybetween each channel within each array and temporal stationary in 21consecutive time windows of 3.2 sec each. Also, the preceding noise issymmetric and linear. The seismic phases defined by the symmetry test asnon-Gaussian (not symmetric) are all linear. This means a linear model canbe used to characterize both the noise and the phases. The first P-phase for the two explosions is characterized as non-Gaussian at thethree arrays. For all 36 possibly first P-phase arrivals at the three arraystations, 23 are non-Gaussian. The second P-phase is non-Gaussian at13 of 36 data records, the S-phase at eleven of 36 and the Lg-phase at nine of 36. For all the four phases more than 32 of possible36 are time-reversible.     

Noise reduction and detection of weak, coherent signals through phase-weighted stacks

We present a new tool for efficient incoherent noise reduction for array data employing complex trace analysis. An amplitude-unbiased coherency measure is designed based on the instantaneous phase, which is used to weight the samples of an ordinary, linear stack. The result is called the phase-weighted stack (PWS) and is cleaned from incoherent noise. PWS thus permits detection of weak but coherent arrivals. The method presented can easily be extended to phase-weighted cross-correlations or be applied in the τ p domain. We illustrate and discuss the advantages and disadvantages of PWS in comparison with other coherency measures and present examples. We further show that our non-linear stacking technique enables us to detect a weak lower-mantle P -to- S conversion from a depth of approximately 840 km on array data. Hints of an 840 km discontinuity have been reported; however, such a discontinuity is not yet established due to the lack of further evidence.