Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Effect of Cyclic Loading Frequency on Undrained Behaviors of Undisturbed Marine Clay

Based on a series of cyclic triaxial tests, the effect of cyclic frequency on the undrained behaviors of undisturbed marine clay is investigated. For a given dynamic stress ratio, the accumulated pore water pressure and dynamic strain increase with the number of cycles. There exists a threshold value for beth the accumulated pore water pressure and dynamic strain, below which the effect of cyclic frequency is very small, but above which the accumulated pore water pressure and dynamic strain increase intensely with the decrease of cyclic frequency for a given number of cycles. The dynamic strength increases with the increase of cyclic frequency, whereas the effect of cyclic frequency on it gradually diminishes to zero when the number of cycles is large enough, and the dynamic strengths at different frequencies tend to the same limiting minimum dynamic strength. The test results demonstrate that the reasons for the frequency effect on the undrained soil behaviors are beth the creep effect induced by the loading rate and the decrease of sample effective confining pressure caused by the accumulated pore water pressure.     

东南亚10°—25°N,105°—130°E海区热带风暴异常路径的分析

本文４１ａ（１９４９－１９８９年）的资料，对东南亚１０°－２５°Ｎ，１０５°－１３０°Ｅ范围７－９月出现的热带风暴异常路长进行了普查统计和气候分析。结果表明：产生异常路径热风暴的机率约占区域内热带风暴总数的２０％；异常路径的产生与热带风暴所处的地理位置，季节，环下等因素有关。正确地考虑气候规律和具体的天气条件相结合是预报带式风暴异常路径成败的关键。     

井中激电地-井方式井旁球体正反演

以激发极化法中的地-井方式中的体极化球形体作为研究对象,采用解析法对地下半空间的电位场进行求解,利用提取出的井中二次场异常电位差进行反演,得出极化球体的球心离井的距离和球心的埋深。通过计算机进行正反演模拟,验证了进行正反演计算的解析式的正确性,并从物理意义上对正反演过程中出现的现象进行分析。最后给出该方法的适用条件以及注意事项。研究对激发极化法地下勘探目标的定量分析具有明确意义。     

潜水面对储层压力的作用机制

潜水面与地表不一致会使储层压力产生异常,给煤层气勘探开发造成影响。从异常压力的成因机理入手,应用理论分析与实例解剖相结合的方法,通过不同系统中潜水面对储层压力的作用机制研究,分析了开放系统中区域潜水面变化所引起的储层压力变化规律,反映了盆地水动力场作用下的储层压力系统的动态演化过程,指出潜水面变化是储层异常压力形成的重要机制。     

肋柱式锚杆支挡结构的徐变次内力分析

采用老化徐变理论和等效弹性模量法,对肋柱式锚杆支挡结构的徐变影响提出了具体计算方法,并通过实例计算了支挡结构的徐变次内力。计算结果表明,在逆作法条件下,随着开挖深度的加大,岩土侧向压力也增大,使后期施工的混凝土构件产生的徐变次内力也随之增大;考虑徐变后使结构设计更加安全可靠,尤其坡脚处后期浇筑的混凝土构件,更要关注徐变的影响。     

Possible creep-related tilt precursors obtained in the Central Apennines (Italy) and in the Southern Caucasus (Georgia)

Daily averaged tilt component data from two sites of the Central Apennines (Italy) and of the Southern Caucasus (Georgia), respectively, revealed intermediate-term tilts as possible precursors to earthquakes (M=3.0÷4.7) which occurred in the above-mentioned seismic areas within a distance of 50 km from the sites. A good temporal correlation as well as a fair spatial correspondence between these residual tilts (with amplitude and duration of some microradians and months, respectively) and main shocks were pointed out, by removing both secular trends and seasonal thermoelastic effects from the raw tilts. An attempt was made to justify the above-mentioned results, based on the assumption that the observed intermediate-term preseismic tilts are the manifestation of aseismic creep episodes of comparable duration in the fault materials of thrust faults close to the tilt sites. The mechanism refers to a strain field slowly propagating from the preparation focal area to the tilt site, through crustal blocks separated by weak transition zones. This propagation is thought to be the cause of the local aseismic fault slip recorded by the tiltmeters. Previously, both discrete structures and strain propagation effects were revealed in the Central Apennines and are thought also to exist in the Southern Caucasus. As in the past, the rheological properties of fault materials are revealed as viscoelastic ones. In fact, creep equations obtained by applying several viscoelastic models on our data, proved to fit quite well some of the observed tilt precursors, producing viscosity and rigidity values very similar to those reported in literature.Professor Petr Viktorovich Manjgaladze died during the writing of this paper     

Ductile deformation of garnet in mylonitic gneisses from the Münchberg Massif (Germany)

Mylonitic gneisses from the Münchberg Massif contain single grains (type I) and polycrystalline aggregates (type II) of garnet displaying a distinct elongation parallel to a macroscopic lineation which is interpreted as the result of ductile deformation. Lattice-preferred orientations of quartz (textures) symmetrical to the macroscopic foliation and lineation and the lack of rotational microfabrics indicate that the bulk deformation was pure shear at least during the latest strain increments. Garnet textures measured by EBSD together with microprobe analyses demonstrate that these two structural types of garnet can be related to two different processes of ductile deformation: (1) For the single grains stretching can be attributed to diffusion creep along grain boundary zones (Coble creep). The related mass transfer is indicated by the fact that primary growth zones are cut off at the long faces of the grains while the related strain shadow domains do not show comparable chemical zoning. Pressure solution and precipitation suitable to produce similar structures can be largely ruled out because retrogressive reactions pointing to the presence of free hydrous fluids are missing. (2) For the polycrystalline garnet aggregates consisting of cores grading into fine-grained mantles, dislocation creep and associated rotation recrystallization can be assumed. Continuous lattice rotation from the core to the outer polycrystalline rim allow a determination of the related dominant slip systems which are {100}<010> and equivalent systems according to the cubic lattice symmetry. The same holds for garnets which appear to be completely recrystallized. For this type of fine-grained aggregates an alternative nucleation model is discussed. Due to penetrative dislocation glide in connection with short range diffusion and the resulting lattice rotation, primary growth zones are strongly disturbed.Since for the considered rock unit of the Münchberg Massif peak metamorphic temperatures between 630 and 670 °C can be assumed, this study clearly demonstrates that the inferred processes of ductile garnet deformation can occur not only in HT regimes as often suggested in the literature even if embedded within a matrix of “low-strength” minerals like quartz, feldspars and micas.     

Experimental and numerical studies of rock salt strain hardening

The work presented in this paper comes as part of a research program dealing with the thermomechanical behaviour of rock salt. It aims to study laboratory and in-situ long-term behaviour by means of creep tests with deviator and temperature changes. The laboratory results, using a triaxial multi-stages creep tests, highlighted the strain hardening character of rock salt. Furthermore, the in-situ results, using a borehole dilatometer multi-step creep test, have shown that the drilling is carried out in a weakly stressed pillar. The interpretation of the laboratory results, using the J.LEMAITRE law, did not indicate full agreement with all the test results. As a result a ‘double’ J.LEMAITRE model, which takes into account a double strain hardening variable, has been put forward. The validation of this model on the laboratory creep tests is very satisfactory. Furthermore, the activation energy seems satisfactory to represent the influence of the temperature. The in-situ behaviour modelling is clearly more complex than the modelization based on laboratory tests. In fact, it seems that if the rock salt behaviour is maintained by J.LEMAITRE law, it is necessary to vary with the stress, at least, one of the parameters assumed constant in the basic law.