对地方电视台转播CCTV时延的测定

讲述了同步广播卫星电视时间信号的测量方法和测量结果，获得了CCTV1、CCTV2通过同一颗卫星（亚太－1A）转播的时延差值为16333μs，测量精度在10ns以内；CCTV2、CCTV4分别经两颗卫星（亚太－1A、亚洲－Ⅱ）转播，在陕西天文台卫星地面接收站时延差值为1644．20μs，精度为50μs，并分析了影响时延差值和精度的原因。同时测量了地方电视台转播亚太－1A的CCTV信号与直接接收亚太－1A的CCTV信号的时延差值，其测量精度为0．1μs。这些结果为利用同步广播卫星的电视信号进行高精度的时间服务提供了参考依据。     

大气层对GPS信号传播影响的规律之探讨──关于广州地区大气层对GPS系统定位定时影响问题研究之二

大气层对ＧＰＳ信号的传播有时间延迟作用，时廷将影响ＧＰＳ系统的定位和定时精度，且随气象因素的变化而变化．本文根据３年有关的气象资料，采用大气指数模型分析了广州地区大气层随昼夜变化、季节变化和太阳活动变化对ＧＰＳ信号传播时延影响的变化规律．分析得知，在信号垂直传播时，大气层对ＧＰＳ信号传播的影响，用距离表示．最大时为２．６９１ｍ，最小时也会产生１．９９３ｍ的误差；如果信号斜传播，误差因仰角因素将更大．     

卫星电视授时系统及精度估计

我国已建成短波、长波授时台，进行毫秒级、微秒级的时间服务．随着现代科技和经济的发展，上述方法已不能满足国家及国际交流的需要．本文提出卫星电视授时系统，同步卫星定位精度小于１１０ｍ，卫星授时精度为亚微秒。两原子钟利用卫星进行时刻同步，其精度与两原子钟的距离有关，相距３千多公里的两钟同步精度小于３５ｎｓ，相距数百公里的两原子钟同步精度小于２０ｎｓ     

低频扩频中伪随机序列产生方法的研究

伪随机序列的产生是实现BPC低频时码发播台扩展频谱技术升级的一个重要环节。针对BPC低频时码发播台的现有系统，提出了伪随机序列的产生方案，并对其性能作了分析。     

拉格朗日插值法在渔业资源评估上的应用

应用拉格朗日插值法拟合鱼类体长与体重之间的函数关系 ,使用计算机VB语言进行编写程序 ,与常用的线性回归法、Ricker法进行比较 ,得出体长与体重的关系式为Pn(x) =∑nk=0yklk(x)=∑nk=0(∏nj=0j≠kx-xjxk-xj)yk 。     

The Asiago Extrasolar Planet Transit Search

RATS is an Italian project devoted to Hot Jupiter search with the transit method. A planet transiting in front of a host star can be mimed by several, and well defined, astrophysical phenomena (Brown, 2003). In order to recognize these false alarms we can utilize a preventive strategy to limit false alarm rates and a spectroscopic follow up to refuse no transit candidates. As preventive strategy it is important to develop an accurate target field selection, with well defined requisites, in order to maximize the solar type star numbers and to minimize the risk of possible astrophysical false alarms.     

原子钟噪声的蒙特卡络模拟方法

讨论了原子钟噪声的蒙特卡络模拟方法．具体过程是：先产生模拟所需的正态分布随机数，从实际钟的阿仑方差估算出噪声电平，然后用１组递点函数产生高质量的模拟钟时差的随机序列．在对１台商品铯钟进行具体模拟后，给出了真实数据与模拟值的阿仑方差之问的相符程度，最后对实际问题进行了分析．     

Travel time based approach for the assessment of vulnerability of karst groundwater: the Transit Time Method

Karst aquifers represent important water resources in many parts of the world. Unfortunately, karst aquifers are characterised by high contamination risks. This paper presents a travel time based method for the estimation of karst groundwater vulnerability. It considers (1) physics-based lateral flow within the uppermost weathered zone (epikarst) in a limestone-dominated region and (2) high velocities of vertical infiltration at discrete infiltration points (e.g. sinkholes) or lines (e.g. dry valleys, faults). Consequently, the Transit Time Method honours the actual flow path within the unsaturated zone of a karst aquifer system. A test site in Northern Jordan was chosen for the demonstration of the assessment technique, i.e. the catchment area of the Qunayyah Spring north of the capital Amman. The results demonstrate that zones of highest vulnerability lie within valleys and nearby main fault zones. It also reveals that regions, categorised as protected areas by other methods due to thick unsaturated zones, contribute to a major degree to the total risk.     

A method to estimate the forces exerted by internal solitons on cylindrical piles

Internal soliton is the large amplitude wave existing in the pycnocline, induced by internal tide in the condition of special bottom topography. During its propagation process, the induced disturbance can bring about strong convergence of sea water and sudden strong current (wave-induced-current), which can cause severe threat to the ocean engineering structures, such as oil drilling platform and pipeline. In this paper, Morison’s empirical method, modal separation and regression analyses are introduced to estimate the forces and torques exerted by internal soliton on cylindrical piles. As an example, a limited set of observational data recording a passage of the internal soliton near Dongsha Islands is used to estimate the horizontal velocity and its acceleration in a vertical section for computing the force and torque on a supposed pile, and the estimation results are reasonable. It is shown that, the higher number of the modes retained in the calculation, the better the estimation of velocity profile fits the observational one. A better overall approximation to the real solution can be reached if there are more observational current data acquired in a whole vertical profile.