Metamorphism in Archaean greenstone belts: calculated fluid compositions and implications for gold mineralization

An inescapable consequence of the metamorphism of greenstone belt sequences is the release of a large volume of metamorphic fluid of low salinity with chemical characteristics controlled by the mineral assemblages involved in the devolatilization reactions. For mafic and ultramafic sequences, the composition of fluids released at upper greenschist to lower amphibolite facies conditions for the necessary relatively hot geotherm corresponds to those inferred for greenstone gold deposits (X_CO2= 0.2–0.3). This result follows from the calculation of mineral equilibria in the model system CaO–MgO–FeO–Al₂O₃–SiO₂–H₂O–CO₂, using a new, expanded, internally consistent dataset. Greenstone metamorphism cannot have involved much crustal over-thickening, because very shallow levels of greenstone belts are preserved. Such orogeny can be accounted for if compressive deformation of the crust is accompanied by thinning of the mantle lithosphere. In this case, the observed metamorphism, which was contemporaneous with deformation, is of the low-P high-T type. For this type of metamorphism, the metamorphic peak should have occurred earlier at deeper levels in the crust; i.e. the piezothermal array should be of the ‘deeper-earlier’type. However, at shallow crustal levels, the piezothermal array is likely to have been of ‘deeper-later’type, as a consequence of erosion. Thus, while the lower crust reached maximum temperatures, and partially melted to produce the observed granites, mid-crustal levels were releasing fluids prograde into shallow crustal levels that were already retrograde. We propose that these fluids are responsible for the gold mineralization. Thus, the contemporaneity of igneous activity and gold mineralization is a natural consequence of the thermal evolution, and does not mean that the mineralization has to be a consequence of igneous processes. Upward migration of metamorphic fluid, via appropriate structurally controlled pathways, will bring the fluid into contact with mineral assemblages that have equilibrated with a fluid with significantly lower X_CO2. These assemblages are therefore grossly out of equilibrium with the fluid. In the case of infiltrated metabasic rocks, intense carbonation and sulphidation is predicted. If, as seems reasonable, gold is mobilized by the fluid generated by devolatilization, then the combination of processes proposed, most of which are an inevitable consequence of the metamorphism, leads to the formation of greenstone gold deposits predominantly from metamorphic fluids.     

Stratigraphy and sedimentation rates of Upper Cretaceous deep-water systems of the Rhenodanubian Group (Eastern Alps, Germany)

In the Bavarian Alps (Germany), west of the Isar River, the abyssal deposits of the Lower Barremian to Upper Campanian Rhenodanubian Group consist of siliciclastic and calcareous turbidites alternating with hemipelagic non-calcareous mudstones. The up to 1500-m-thick succession, deposited in the Penninic Basin to the south of the European Plate, is characterized by a low mean sedimentation rate (c. 25 mm kyr⁻¹) over 60 million years. Palaeocurrents and turbidite facies distribution patterns suggest that sedimentation occurred on a weakly inclined abyssal plain. The highest sedimentation rates (up to 240 mm kyr⁻¹) were associated with the calcareous mud turbidites of the newly defined Röthenbach Subgroup, which includes the Piesenkopf, Kalkgraben and Hällritz formations (Middle Coniacian to Middle Campanian). These calcareous turbidites prograded from the west, and interfinger towards the east with red hemipelagic claystone. A high sea level presumably favoured pelagic carbonate production and accumulation on the shelves and on internal platforms in the western part of the basin, whereas siliciclastic shelves with steep slope angles have bordered the eastern part of the basin, where a dearth of turbidite sedimentation and increased Cretaceous oceanic red beds deposition occurred. In contrast to the eustatically-induced Middle Coniacian to Lower Campanian Cretaceous oceanic red beds (calcareous nannoplankton zones CC14 to CC18), red hemipelagites of Early Cenomanian age (upper part of calcareous nannoplankton zone CC9) and early Late Campanian age (upper part of zone CC21 and zone CC22) are interpreted as the result of regional tectonic activity.     

First U–Pb SHRIMP age of the Hauterivian stage, Neuquén Basin, Argentina

A high-resolution ion-microprobe (SHRIMP) U–Pb zircon age from a tuff layer intercalated in the ammonoid bearing sedimentary succession of the Neuquén Basin in Argentina provides a robust geochronologic date to add to the absolute ages and to improve the relative chronology of the Early Cretaceous Hauterivian stage. The tuff layer appears interbedded between shales of the upper member (Agua de la Mula) of the Agrio Formation within the Spitidiscus riccardii ammonoid zone (base of the Late Hauterivian) yielding a date of 132.5 ± 1.3 Ma. This date confirms and supports an accurate correlation between the ammonoid biostratigraphy of the Neuquén Basin with the Western Mediterranean Province of the Tethys during the Early Cretaceous and matches with the most recently published time scale. It also casts doubts on the validity of K–Ar ages on glauconite-grains recently reported from the Lower Cretaceous of the Vocontian Basin of France.     

太平洋三海区热液烟囱物的氧同位素特征及形成温度

使用氧同位素方法 ,测试了西太平洋马里亚纳岛弧、马里亚纳海槽、冲绳海槽和东太平洋加拉帕戈斯裂谷的海底热液烟囱和硫化物全岩样品。结果表明 :马里亚纳岛弧上的埃斯梅拉尔达破火山口的热液硫化物的形成温度最高 (达 2 75℃ ) ,而成为高温产物的代表 ;冲绳海槽和加拉帕戈斯裂谷烟囱 ,表现为中高温类型 ,其氧同位素温度在 1 5 0℃左右 ;马里亚纳海槽以蛋白石为主要矿物的烟囱物 ,则显示出典型的低温热液类型 ,少量黄铁矿砂试样则表现出中温类型特征。但上述区域大都不同程度地存在有闪锌矿、黄铁矿、黄铜矿等中高温热液矿物 ,说明研究区除马里亚纳海槽明显有中低温热液活动类型外 ,其它区域皆具备中高温热液活动特征     

黑龙江省鸡西盆地南、北两带城子河组精细对比

鸡西盆地被平麻断裂分割成南、北两个条带,多数研究者将南带1煤之下的海相层叠伏于北带海相层或底砾岩之下,称为“城子河组下段”或“石河北组”。利用事件地层学的原理,分析盆地内城子河组早期盆地裂陷、海侵、火山喷发、聚煤等重大事件在地层精细对比方面的意义,甄别出了盆地中重大事件的地层记录．以等时层为基础建立对比框架。通过大量钻井资料追溯对比,认为盆地中坳陷部位的渴湖海湾沉积是南北两带的沉积过渡类型,根据微体古生物研究,南北两带海相层中的沟鞭藻类化石面貌基本一致,南北带的海相层应是同一层位,初步实现了盆地内南、北两个条带城子河组的精细对比,为恢复盆地古地理环境奠定了可靠的基础。     

Preservation/exhumation of ultrahigh-pressure subduction complexes

Ultrahigh-pressure (UHP) metamorphic terranes reflect subduction of continental crust to depths of 90–140 km in Phanerozoic contractional orogens. Rocks are intensely overprinted by lower pressure mineral assemblages; traces of relict UHP phases are preserved only under kinetically inhibiting circumstances. Most UHP complexes present in the upper crust are thin, imbricate sheets consisting chiefly of felsic units ± serpentinites; dense mafic and peridotitic rocks make up less than  10% of each exhumed subduction complex. Roundtrip prograde–retrograde P–T paths are completed in 10–20 Myr, and rates of ascent to mid-crustal levels approximate descent velocities. Late-stage domical uplifts typify many UHP complexes.

Sialic crust may be deeply subducted, reflecting profound underflow of an oceanic plate prior to collisional suturing. Exhumation involves decompression through the P–T stability fields of lower pressure metamorphic facies. Scattered UHP relics are retained in strong, refractory, watertight host minerals (e.g., zircon, pyroxene, garnet) typified by low rates of intracrystalline diffusion. Isolation of such inclusions from the recrystallizing rock matrix impedes back reaction. Thin-aspect ratio, ductile-deformed nappes are formed in the subduction zone; heat is conducted away from UHP complexes as they rise along the subduction channel. The low aggregate density of continental crust is much less than that of the mantle it displaces during underflow; its rapid ascent to mid-crustal levels is driven by buoyancy. Return to shallow levels does not require removal of the overlying mantle wedge. Late-stage underplating, structural contraction, tectonic aneurysms and/or plate shallowing convey mid-crustal UHP décollements surfaceward in domical uplifts where they are exposed by erosion. Unless these situations are mutually satisfied, UHP complexes are completely transformed to low-pressure assemblages, obliterating all evidence of profound subduction.     

Evolution from Oceanic Subduction to Continental Collision: a Case Study from the Northern Tibetan Plateau Based on Geochemical and Geochronological Data

Two apparently distinct, sub-parallel, paleo-subduction zonescan be recognized along the northern margin of the Tibetan Plateau:the North Qilian Suture Zone (oceanic-type) with ophioliticmélanges and high-pressure eclogites and blueschistsin the north, and the North Qaidam Belt (continental-type) inthe south, an ultrahigh-pressure (UHP) metamorphic terrane comprisingpelitic and granitic gneisses, eclogites and garnet peridotites.Eclogites from both belts have protoliths broadly similar tomid-ocean ridge basalts (MORB) or oceanic island basalts (OIB)in composition with overlapping metamorphic ages (480–440Ma, with weighted mean ages of 464 ± 6 Ma for North Qilianand 457 ± 7 Ma for North Qaidam), determined by zirconU–Pb sensitive high-resolution ion microprobe dating.Coesite-bearing zircon grains in pelitic gneisses from the NorthQaidam UHP Belt yield a peak metamorphic age of 423 ±6 Ma, 40 Myr younger than the age of eclogite formation, anda retrograde age of 403 ± 9 Ma. These data, combinedwith regional relationships, allow us to infer that these twoparallel belts may represent an evolutionary sequence from oceanicsubduction to continental collision, and continental underthrusting,to final exhumation. The Qilian–Qaidam Craton was probablya fragment of the Rodinia supercontinent with a passive marginand extended oceanic lithosphere in the north, which was subductedbeneath the North China Craton to depths >100 km at c. 423Ma and exhumed at c. 403 Ma (zircon rim ages in pelitic gneiss). KEY WORDS: HP and UHP rocks; subduction belts; zircon SHRIMP ages; Northern Tibetan Plateau     

阿尔金地区构造应力场及其对金属矿产分布的控制作用

构造应力场研究可以为区域矿产预测提供依据。主要根据节理、擦痕的测试分析，结合区域构造解析，确定阿尔金山东西向拉配泉－－红柳沟构造带经历了三期不同方向的应力作用：印支期以前的南北向挤压作用，印支－燕山期的北西－南东向的挤压和中生代晚期－新生代北东东－南南西向的挤压；并利用有限元数值模拟前两期构造应力场的演变过程，进而讨论了区域构造应力场对内生金属矿产分布规律的控制作用指出了区域寻找大型内生金属矿产的有利地段。     

Topography as a major factor in the development of arcuate thrust belts: insights from sandbox experiments

We have used sandbox experiments to investigate and to illustrate the effects of topography upon the development of arcuate thrust belts. In experiments where a sand pack shortened and thickened in front of an advancing rectilinear piston, the geometry of the developing thrust wedge was highly sensitive to variations in surface topography. In the absence of erosion and sedimentation, the surface slope tended to become uniform, as predicted by the theory of critical taper. Under these conditions, the wedge propagated by sequential accretion of new thrust slices. In contrast, where erosion or sedimentation caused the topographic profile to become irregular, thrusts developed out of sequence. For example, erosion throughout a hinterland caused underlying thrusts to remain active and inhibited the development of new thrusts in the foreland. Where initial topography was irregular in plan view, accreting thrusts tended to be arcuate. They were convex towards the foreland, around an initially high area; concave towards the foreland, around an initially low area. Initial plateaux tended to behave rigidly, while arcuate thrust slices accreted to them. Thrust motions were radial with respect to each plateau. Within transfer zones to each side, fault blocks rotated about vertical axes and thrust motions were oblique-slip. At late stages of deformation, the surface slope of the thrust wedge tended towards a uniform value. Initial mountains of conical shape (representing volcanoes) also escaped deformation, except at depth, where they detached. Arcuate thrust slices accreted to front and back. Where a developing thrust wedge was subject to local incision, accreting thrust slices dipped towards surrounding areas of high topography, forming Vs across valleys.Arcuate structural patterns are to be found around the three highest plateaux on Earth (Tibet, Pamirs and Altiplano) and around the Tromen volcanic ridge in the Neuquén Basin of northern Patagonia. We infer that these areas behaved in quasi-rigid fashion, protected as they were by their high topography.