The double solid reactant method: II. An application to the shallow groundwaters of the Porto Plain,Vulcano Island (Italy)

This paper presents an example of application of the double solid reactant method (DSRM) of Accornero and Marini (Environmental Geology, 2007a), an effective way for modeling the fate of several dissolved trace elements during water–rock interaction. The EQ3/6 software package was used for simulating the irreversible water–rock mass transfer accompanying the generation of the groundwaters of the Porto Plain shallow aquifer, starting from a degassed diluted crateric steam condensate. Reaction path modeling was performed in reaction progress mode and under closed-system conditions. The simulations assumed: (1) bulk dissolution (i.e., without any constraint on the kinetics of dissolution/precipitation reactions) of a single solid phase, a leucite-latitic glass, and (2) precipitation of amorphous silica, barite, alunite, jarosite, anhydrite, kaolinite, a solid mixture of smectites, fluorite, a solid mixture of hydroxides, illite-K, a solid mixture of saponites, a solid mixture of trigonal carbonates and a solid mixture of orthorhombic carbonates. Analytical concentrations of major chemical elements and several trace elements (Cr, Mn, Fe, Ni, Cu, Zn, As, Sr and Ba) in groundwaters were satisfactorily reproduced. In addition to these simulations, similar runs for a rhyolite, a latite and a trachyte permitted to calculate major oxide contents for the authigenic paragenesis which are comparable, to a first approximation, with the corresponding data measured for local altered rocks belonging to the silicic, advanced argillic and intermediate argillic alteration facies. The important role played by both the solid mixture of trigonal carbonates as sequestrator of Mn, Zn, Cu and Ni and the solid mixture of orthorhombic carbonates as scavenger of Sr and Ba is emphasized.

Strength and stability of frictional sliding of gabbro gouge at elevated temperatures

To investigate the strength of frictional sliding and stability of mafic lower crust, we conducted experiments on oven-dried gabbro gouge of 1 mm thick sandwiched between country rock pieces (with gouge inclined 35° to the sample axis) at slip rates of 1.22 × 10^− 3 mm/s and 1.22 × 10^− 4 mm/s and elevated temperatures up to 615 °C. Special attention has been paid to whether transition from velocity weakening to velocity strengthening occurs due to the elevation of temperature.Two series of experiments were conducted with normal stresses of 200 MPa and 300 MPa, respectively. For both normal stresses, the friction strengths are comparable at least up to 510 °C, with no significant weakening effect of increasing temperature. Comparison of our results with Byerlee's rule on a strike slip fault with a specific temperature profile in the Zhangbei region of North China shows that the strength given by experiments are around that given by Byerlee's rule and a little greater in the high temperature range.At 200 MPa normal stress, the steady-state rate dependence a − b shows only positive values, probably still in the “run-in” process where velocity strengthening is a common feature. With a normal stress of 300 MPa, the values of steady-state rate dependence decreases systematically with increasing temperature, and stick-slip occurred at 615 °C. Considering the limited displacement, limited normal stress applied and the effect of normal stress for the temperatures above 420 °C, it is inferred here that velocity weakening may be the typical behaviour at higher normal stress for temperature above 420 °C and at least up to 615 °C, which covers most of the temperature range in the lower crust of geologically stable continental interior. For a dry mafic lower crust in cool continental interiors where frictional sliding prevails over plastic flow, unstable slip nucleation may occur to generate earthquakes.     

Spatial correlation of deformation and mineral reaction in experimentally deformed plagioclase–olivine aggregates

Shear deformation of hot pressed plagioclase–olivine aggregates was studied in the presence and absence of mineral reaction. Experiments were performed at 900 °C, 1500 MPa, and a constant shear strain rate of 5×10⁻⁵ s⁻¹ in a solid medium apparatus. Whether the mineral reaction between plagioclase and olivine takes place or not is controlled by choosing the appropriate plagioclase composition; labradorite (An₆₀) does not react, anorthite (An₉₂) does. Labradorite–olivine aggregates deformed without reaction are very strong and show strain hardening throughout the experiment. Syndeformational reaction between olivine and anorthite causes a pronounced strain weakening. The reaction produces fine-grained opx–cpx–spinel aggregates, which accommodate a large fraction of the finite strain. Deformation and reaction are localised within a 0.5-mm-wide sample. Three representative samples were analysed for their fabric anisotropy R* and shape-preferred orientation α* (fabric angle with the shear plane) using the autocorrelation function (ACF). Fabric anisotropy can be calibrated to quantify strain variations across the sheared samples. In the deformed and reacted anorthite–olivine aggregate, there is a strong correlation between reaction progress and strain; regions of large shear strain correspond to regions of maximum reaction progress. Within the sample, the derived strain rate variations range up to almost one order of magnitude.     

Frost susceptibility of soils——A confusing concept that can misguide geotechnical design in cold regions

Frost susceptibility is a concept widely used in cold region geotechnical design, to quantify the capacity of a soil in generating frost heave and frost damage. The laboratory test used to verify frost susceptibility of a soil is based on the measurement of frost heave generated in the soil under specific conditions. In reality this concept is, however, more related to the soil's potential to thaw weakening than to frost heave. Recent experimental studies show that frost non-susceptible soils like clean sand and clean gavel can also generate much ice segregation and frost heave if the conditions are favourable, hence challenging the usefulness and suitability of soil classification based on frost susceptibility. It is further shown that the concept is not suitable for design scenarios where frost heave itself is a serious hazard, such as in high-speed rail embankments.     

Fault－weakening effect of reservoir temperature of hot spring and its influence on seismic activities

Ｆａｕｌｔ－ｗｅａｋｅｎｉｎｇ　ｅｆｆｅｃｔ　ｏｆ　ｒｅｓｅｒｖｏｉｒ　ｔｅｍｐｅｒａｔｕｒｅ　ｏｆ　ｈｏｔ　ｓｐｒｉｎｇ　ａｎｄ　ｉｔｓ　ｉｎｆｌｕｅｎｃｅ　ｏｎ　ｓｅｉｓｍｉｃ　ａｃｔｉｖｉｔｉｅｓ（林元武）Ｆａｕｌｔ－ｗｅａｋｅｎｉｎｇｅｆｆｅ...     

确定沉积岩成岩作用顺序的定量方法

本文从热力学基本定律出发，将复杂的成岩作用过程归结为各种不同的化学反应，从而建立了一套利用反应自由能定量确定成岩作用顺序的方法。该方法将沉积岩成岩作用历史研究从定性引向定量，使其更具理论依据，结果更可靠。利用本方法对国内外两个不同碎屑岩定量研究结果表明，这种方法获得的结果与传统方法的顺序完全一致，从而说明了该方法的良好实用性。     

A new model on the cause of Tangshan earthquakes in 1976

Introduction The Tangshan earthquake sequence in 1976 is one of most important events in North China. Although nearly thirty years passed and there are some researches on its cause, it is far from the end. Here we introduce two explanations for the cause of Tangshan earthquakes and point out their defects. One is that there is a diamond block in NEE direction in Tangshan region, which is shaped by cutting action of NingheChangli fault, FengtaiYejituo fault, Luanxian fault and Jiyunhe fau…     

Reaction textures in scapolite–wollastonite–grossular calc-silicate rock from the Kerala Khondalite Belt, Southern India: evidence for high-temperature metamorphism and initial cooling

Scapolite–wollastonite–grossular bearing calc-silicate rocks from the Vellanad area in the Kerala Khondalite Belt (KKB) of Southern India preserve a number of reaction textures which help to deduce their P–T–fluid history. Textures include calcite+plagioclase±quartz symplectites after scapolite, grossular+quartz coronas between wollastonite and plagioclase, grossular coronas between wollastonite and plagioclase+calcite that replace former scapolite, and grossular blebs replacing anorthite+calcite+quartz pseudomorphs of scapolite. Garnet coronas are also observed between clinopyroxene and wollastonite or scapolite or plagioclase. The reactions, apart from those involving clinopyroxene, can be modelled in the simple CaO–Al₂O₃–SiO₂–CO₂ system and interpreted using partial reaction grids constructed for the activities of end-members in the analysed phases. The reaction topologies produced are good approximations for the peak as well as retrograde mineral assemblages and reaction textures. For the compositions of the phases present in this study, the medium pressure calc-silicate assemblages are defined by the stable pseudo-invariant points [Qtz], [Mei] and [Grs]. The textural features interpreted using these activity-corrected grids indicate a phase of isobaric cooling from about 835°C to 750°C at 6 kbar in the Vellanad area. This is inconsistent with earlier studies on other lithologies from the KKB, most of which imply a post-peak P–T path involving near-isothermal decompression. However, as the temperatures obtained for the KKB from the calc-silicates are higher than those previously deduced from metapelites and garnet–orthopyroxene assemblages, the phase of near-isobaric cooling reported here is inferred to have proceeded prior to the onset of the decompression documented from studies of other rock types.