Interference of Multiple Strip Footings on Sand Using Small Scale Model Tests

By using small scale model tests, the interference effect on the vertical load-deformation behavior of a number of equally spaced strip footings, placed on the surface of dry sand, was investigated. At any stage, all the footings were assumed to (i) carry exactly equal magnitude of load, and (ii) settle to the same extent. No tilt of the footing was permitted. The effect of clear spacing (s) among footings on the results was explored. A new experimental setup was proposed in which only one footing needs to be employed rather than a number of footings. The bearing capacity increases continuously with decrease in spacing among the footings. The interference effect becomes further prominent with increase in soil friction angle. In contrast to an increase in the bearing capacity, with decrease in spacing of footings, an increase in the footing settlement associated with the ultimate state of shear failure was observed. The present experimental observations were similar to those predicted by the available theory, based on the method of characteristics. As compared to the theory, the present experimental data, however, indicates much greater effect of interference especially for larger spacing among footings.     

Developing a Marine Information System by Integrating Existing Ocean Models Using Object-Oriented Technology

Information systems developed for different applications within the environmental domain have common characteristics, which can potentially be abstracted for sharing and reuse of design and software modules. This article presents an approach to designing for reuse by abstracting commonalities in the design of a Marine Information System (MIS), facilitating data management in a prototype operational monitoring, forecasting, and management system for the North Atlantic and the Nordic Seas. A detailed study of the requirements and data analysis was carried out, and Object-Oriented Technology (OOT) is employed to encapsulate abstractions and to promote reuse of code and design. This article identifies the Object-Oriented Frameworks (OOFW) required to build the MIS. It also provides guidelines to environmental scientists for restructuring legacy software and employing modern programming techniques.     

Experimental investigation on a two-part underwater towed system

An experimental set-up is developed and proved to be effective for laboratory study of an underwater towed system. The experimental technique gives a practical method for monitoring the kinematic and dynamic performance of an underwater towed system in a ship towing tank. Both the theoretical and experimental results in the investigation indicate that the hydrodynamic response of a towed vehicle to the wave induced motion of a towing ship can be significantly reduced by applying a two-part tow method. A comparison of the numerical and experimental results in the investigation demonstrates that the numerical simulation results are close to the experimental data, overall agreement between experimental and theoretical results is satisfactory. The results qualitatively verify the mathematical model of a two-part underwater towed system proposed by Wu and Chwang [Wu, J., Chwang, A.T., 2000. A hydrodynamic model of a two-part underwater towed system. Ocean Engineering 27 (5), 455–472].     

虚拟现实技术在矿物数字博物馆中的应用

详细介绍基于照片的虚拟现实技术在矿物数字博物馆中的实现方法和应用,并对VRML与基于照片的虚拟现实技术进行分析研究,进而对两种实现方法的发展方向和应用前景提出见解。     

Effects of detailed soil spatial information on watershed modeling across different model scales

Hydro-ecological modelers often use spatial variation of soil information derived from conventional soil surveys in simulation of hydro-ecological processes over watersheds at mesoscale (10–100 km²). Conventional soil surveys are not designed to provide the same level of spatial detail as terrain and vegetation inputs derived from digital terrain analysis and remote sensing techniques. Soil property layers derived from conventional soil surveys are often incompatible with detailed terrain and remotely sensed data due to their difference in scales. The objective of this research is to examine the effect of scale incompatibility between soil information and the detailed digital terrain data and remotely sensed information by comparing simulations of watershed processes based on the conventional soil map and those simulations based on detailed soil information across different simulation scales. The detailed soil spatial information was derived using a GIS (geographical information system), expert knowledge, and fuzzy logic based predictive mapping approach (Soil Land Inference Model, SoLIM). The Regional Hydro-Ecological Simulation System (RHESSys) is used to simulate two watershed processes: net photosynthesis and stream flow. The difference between simulation based on the conventional soil map and that based on the detailed predictive soil map at a given simulation scale is perceived to be the effect of scale incompatibility between conventional soil data and the rest of the (more detailed) data layers at that scale. Two modeling approaches were taken in this study: the lumped parameter approach and the distributed parameter approach. The results over two small watersheds indicate that the effect does not necessarily always increase or decrease as the simulation scale becomes finer or coarser. For a given watershed there seems to be a fixed scale at which the effect is consistently low for the simulated processes with both the lumped parameter approach and the distributed parameter approach.     

遥测地震仪发射机电路分析及检修

在无线遥测地震仪器中 ,发射机长期使用容易出现输出功率下降、无输出功率、发射频率不准等故障。分析了发射机典型电路——石英晶体主振电路、倍频电路、激励级电路、功率放大级电路的基本原理。排除发射机的故障时 ,先从不同单元电路逐一检查、测试 ,判断故障类型 ,最后进行发射机总调试     

恩洪-老厂地区煤层气成藏条件研究

煤层气盆地、煤层气系统、煤层气区带的存在及发育程度是煤层气藏形成的充分与必要条件。恩洪盆地和老厂一圭山盆地老厂煤矿区具备了形成煤层气藏的条件。研究其形成煤层气藏的特定条件，总结其煤层气藏模式，是煤层气勘探目标评价的基础。     

A Physical and Numerical Investigation on the Stability of Shallow Tunnels in Strain Softening Media

Summary The behaviour up to failure of shallow underground openings is discussed on the basis of some laboratory, small-scale model tests and of finite element simulation. The experimental results are first illustrated. They were obtained from two-dimensional (plane strain) and three-dimensional tunnel models tested under standard gravity conditions. Then, the phenomenon of strain localisation that characterizes the medium surrounding the model tunnels is discussed, recalling two alternative approaches for its numerical interpretation. On this basis, a finite element procedure for strain softening analyses is outlined and applied to the simulation of the tests in both two- and three-dimensional conditions. The comparison between experimental and numerical results leads to some conclusions on the influence of strain localisation on the overall behaviour of shallow tunnels and on the stability of their headings.     

Exhumation of high-pressure rocks of the Kokchetav massif: facts and models

The exhumation of ultrahigh-pressure (UHP) metamorphic units from depths more than 100-120 km is one of the most intriguing questions in modern petrology and geodynamics. We use the diamondiferous Kumdy-Kol domain in the Kokchetav Massif to show that exhumation models should take into consideration initially high uplift velocities (from 20 down to 6 cm/year) and the absence of the deformation of UHP assemblages. The high rate of exhumation are indicated by ion microprobe (SHRIMP) dating of zircons from diamondiferous rocks and supported by the low degree of nitrogen aggregation in metamorphic diamonds.Diamondiferous rocks in the Kumdy-Kol domain occur as steeply dipping (60°-80°) thin slices (few hundred metres) within granite-gneiss. Using geological, petrological and isotopic-geochemical data, we show that partial melting of diamondiferous metamorphic rocks occurred; a very important factor which has not been taken into account in previous models.Deformation of diamondiferous rocks at Kumdy-Kol is insignificant; diamond inclusions in garnet are often intergrown with mica crystals carrying no traces of deformation. All these facts could be explained by partial melting of metapelites and granitic rocks in the Kumdy-Kol domain. The presence of melt is responsible for an essential reduction of viscosity and a density difference (Δρ) between crustal rocks and mantle material and reduced friction between the upwelling crustal block, the subducting and overriding plates. Besides Δρ, the exhumation rate seems to depend on internal pressure in the subducting continental crustal block which can be regarded as a viscous layer between subducting continental lithosphere and surrounding mantle.We construct different models for the three stages of exhumation: a model similar to “corner flow” for the first superfast exhumation stage, an intermediate stage of extension (most important from structural point of view) and a very low rate of exhumation in final diapir+erosional uplift.