Non-Newtonian topographic relaxation on Europa

Models of topographic support on Europa by lateral shell thickness variations have previously assumed a Newtonian ice viscosity. Here I show that using a more realistic stress-dependent viscosity gives relaxation times which can be significantly different. Topography of wavelength 100 km cannot be supported by lateral shell thickness variations for ∼50 Myr, unless the shell thickness is <10 km or the ice grain size >10 mm. Shorter wavelength topography would require even thinner shells, but may be supported elastically. Global-scale variations in shell thickness, however, can be supported for geological timescales if the shell thickness is O(10 km).     

Statistical analysis of sand grain/bed collision process recorded by high-speed digital camera

A high‐speed digital camera was employed to record the sand grain/bed collision process. With image processing and a statistical method, a series of parameters of the collision process were obtained. The results show that the collision process of a grain with rebounding can be represented by two parameters: the kinetic energy restitution coefficient and the collision angle. Both parameters satisfy a normal distribution, and they are dependent on one another. With an increase of the collision angle, the distribution of the kinetic energy restitution gradually reduces from a broad to a narrow range with low values. The percentage of vertical velocity restitution coefficients greater than 1 can reach 70% or more, which ensures that the settling time of the sand grains in the air increases and that they receive more energy from the air to progress the saltation movement.     

Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Impact of lightning on organic matter-rich soils: influence of soil grain size and organic matter content on underground fires

A detailed study was carried out on a piece of land that had been struck by lightning during the violent rainstorm that raged over the Island of S?o Miguel (Azores Archipelago) in late October 2006. Temperature and gas measurements (CO₂, CO, H₂S and CH₄) were performed in four study trenches, dug in an area of ∼3 m², where an underground fire had been initiated by the impact with a lightning stroke, followed by the emission of a column of gases and smoke. The soil under study was originally a well-pedogenized about 80 cm thick bed, made of volcanic clayey to silty tephra fallouts and contained 5.5–9.7% of organic matter. The underground fire was monitored for one week and revealed a peak release of 404 ppm CO and 3.4% CO₂ originating from a horizon located about 45 cm under the soil surface. Measurements of temperature, performed one week after the impact, indicated a maximum value of 326°C inside the soil, while 516.5°C were measured on the surface of a lava block interred about 20 cm under the surface. Subsequently, a stratigraphic and sedimentologic study proved the role of the grain-size of the soil and of the organic matter content of the different horizons of the impact area, in determining the ratio between anoxic/oxidised combustion conditions and in the progress of the process itself. It was also noticed that combustion was not total all over in the soil bed and that the process had slightly migrated toward SW during the observation period. The combustion process went on for about ten days, in spite of several other violent rainstorms, until it was artificially extinguished through the excavations made to obtain study trenches. This particular circumstance evidenced the potential natural hazard represented by this kind of atmospheric event, especially in a land where the volcanic nature of the soil may easily mislead inexperienced observers and, consequently, delay proper action.     

Spring and summer phytoplankton communities in the Chukchi and Eastern Beaufort Seas

Phytoplankton pigments and size-fractionated biomass in the Chukchi and Beaufort Seas showed spatial and temporal variation during the spring and summer of 2002. Cluster analysis of pigment ratios revealed different assemblages over the shelf, slope and basin regions. In spring, phytoplankton with particle sizes greater than 5 μm, identified as diatoms and/or haptophytes, dominated over the shelf. Smaller (<5 μm) phytoplankton containing chlorophyll b, most likely prasinophytes, were more abundant over the slope and basin. Due to extensive ice cover at this time, phytoplankton experienced low irradiance, but nutrients were near maximal for the year. By summer, small prasinophytes and larger haptophytes and diatoms co-dominated in near-surface assemblages in largely ice-free waters when nitrate was mostly depleted. Deeper in the water column at 1–15% of the surface irradiance larger sized diatoms were still abundant in the upper nutricline. Phytoplankton from the shelf appeared to be advected through Barrow Canyon to the adjacent basin, explaining similar composition between the two areas in spring and summer. Off-shelf advection was much less pronounced for other slope and basin areas, which are influenced by the low-nutrient Beaufort gyre circulation, leading to a dominance of smaller prasinophytes and chlorophytes. The correlation of large-sized fucoxanthin containing phytoplankton with the higher primary production measurements shows promise for trophic status to be estimated using accessory pigment ratios.     

Spatial variation of the intertidal sediments and macrozoo-benthic assemblages along Eighty-mile Beach, North-western Australia

The extensive intertidal flats along Eighty-mile Beach in North-western Australia appear to be monotonous and homogeneous and seem ideally suited to study tidal zonation in macrozoo-benthic communities and their possible correlates with characteristics of the sediment. In October 1999, we sampled benthic invertebrates and sediments at a total of 895 sampling stations distributed over six different locations, each location separated by 15 km of unsampled foreshore along Eighty-mile Beach. To test for the presence or absence of patterns of tidal zonation (distinct height-related zones of specific sediment grain sizes or zoobenthic taxonomic groups) or patchiness (distinct patches of specific sediment grain sizes or zoobenthic taxonomic groups not related to tidal height) each location was divided into three along-shore sections and each section (transect) was examined at two or three tidal heights. Zonation was observed for sediment grain sizes. Sediments were coarser at the highest intertidal level and finer towards the low water line. Benthic assemblages also differed among tidal heights, but in terms of species-composition the differences were not consistent among the locations. Each location supported a unique collection of benthic invertebrates. Therefore the hypothesis of the presence of distinct zones of specific species or zoobenthic taxonomic groups was rejected; the presence of benthic patches was confirmed. The distribution of sediments and the composition of benthic assemblages were surprisingly poorly correlated compared to those reported in 12 previous quantitative studies around the world. One possible explanation might be that super-cyclone Vance, which hit the study-area only six months before this study, contributed to this poor correlation. Alternatively, the poor correlation may indicate that biotic interactions are more important than the assumed abiotic structuring.     

Micro-fracture instabilities in granular solids

We study the aspect of unstable behavior (like strain localization bands) in elastic solids as a consequence of micro-fracturing. A two-scale approach of computational homogenization is considered. The macroscopic behavior is investigated by finite element computations on a unit cell. At the micro-level, we consider a granular structure with elastic grains. The inter-granular boundaries are modeled with cohesive laws, friction and unilateral contact. We show that decohesion between grains gives rise to macro-instabilities, indicated by the loss of ellipticity, typical for deformation localization bands. The relation between the microscopic softening on inter-granular boundaries and the onset of macro-instabilities is studied through numerical examples. The influence of the cohesive law and friction parameters is analyzed. For periodic distributions of granular structures, we prove the loss of periodicity by failure and the corresponding size dependence effect in the homogenized response. We present numerical examples of bifurcation of solutions for granular cell structures and of particular solutions specific to elementary volumes with periodic cell distribution. Size dependence appears in the unstable regime and is strongly influenced by cohesion and friction parameters.     

Microlites and "nanolites" in rhyolitic glass: microstructural and chemical characterization

 We used transmission electron microscopy (TEM) and scanning electron microscopy (SEM) to study magmatic crystals in the Ben Lomond rhyolite lava dome, Taupo Volcanic Center, New Zealand. Using TEM and SEM to investigate the size distributions of these crystals, we identified three size populations: microphenocrysts (>1.2 μm wide), microlites (>0.6 μm wide), and smaller crystals (<0.6 μm wide) which we term "nanolites". The predominant mineral phases of the microlites and nanolites are augites, pigeonites, and hypersthenes. The compositions and microstructures within these pyroxenes indicate disequilibrium crystallization at approximately 850–900  °C and undercoolings as high as 300  °C from equilibrium crystallization temperatures. Complex microstructures resulting from subsolidus reactions in augite and pigeonite are consistent with moderate cooling rates within the upper obsidian layer of the Ben Lomond rhyolite dome. This study demonstrates the existence of sub-micron magmatic crystals in a rhyolite and illustrates the potential of TEM to provide unique information about the crystallization and cooling histories of glassy volcanic rocks. Received: May 8, 1995 / Accepted: November 27, 1995     

Influence of sedimentary environments on mechanical properties of clastic rocks

The sedimentary environments are the intrinsic factor controlling the mechanical properties of clastic rocks. Examining the relationship between rock sedimentary environments and rock mechanical properties gives a better understanding of rock deformation and failure mechanisms. In this study, more than 55 samples in coal measures were taken from seven different lithologic formations in eastern China. Using the optical microscope the sedimentary characteristics, such as components of clastic rocks and sizes of clastic grains were quantitatively tested and analyzed. The corresponding mechanical parameters were tested using the servo-controlled testing system. Different lithologic attributes in the sedimentary rocks sampled different stress–strain behaviors and failure characteristics under different confining pressures, mainly due to different compositions and textures. Results demonstrate that clastic rocks have the linear best-fit for Mohr-Coulomb failure criterion. The elastic moduli in clastic rocks are highly dependent upon confining pressures, unlike hard rocks. The envelope lines of the mechanical properties versus the contents of quartz, detritus of the grain diameter of more than 0.03 mm, and grain size in clastic rocks are given. The compressive strength or elastic modulus and the grain diameter have a non-monotonic relation and demonstrate the “grain-diameter softening” effect.