Non-Newtonian topographic relaxation on Europa

Models of topographic support on Europa by lateral shell thickness variations have previously assumed a Newtonian ice viscosity. Here I show that using a more realistic stress-dependent viscosity gives relaxation times which can be significantly different. Topography of wavelength 100 km cannot be supported by lateral shell thickness variations for ∼50 Myr, unless the shell thickness is <10 km or the ice grain size >10 mm. Shorter wavelength topography would require even thinner shells, but may be supported elastically. Global-scale variations in shell thickness, however, can be supported for geological timescales if the shell thickness is O(10 km).     

VO_IMPAT:中国虚拟天文台图像处理分析工具

中国虚拟天文台图像处理分析工具（VO_IMPAT），是由国家天文台虚拟天文台项目组开发的一项服务，它提供了对数字巡天图像数据（Digital Sky Survey，DSS）、天文星表以及其他数据库的交互访问。VO_IMPAT的设计目的是实现多波段天文数据的融合。可以将不同波段的星表叠加到DSS底图上，如光学波段的USNO星表、近红外波段的2MASS星表、射电波段的NVSS星表和X射线波段的RASS星表。同时VO_IMPAT还可以对图像进行放大、缩小、伪彩色、等高线、直方图、尖锐化、平滑化、旋转等处理，不同的星表数据可以采用不同的颜色和图标显示。     

FITS、BMP和SCR图象格式及相互转换

本文详细介绍图象的ＦＩＴＳ格式、ＢＭＰ格式和ＳＣＲ格式。ＦＩＴＳ格式已经是天文界的通用格式，几乎所有的天文软件包都支持这一格式，而ＢＭＰ格式在ＰＣ计算机上有广泛的运用，有大量ＰＣ软件支持ＢＭＰ图象的显示，处理和打印。云南天文台的ＳＣＲ格式是ＰＣ机采集ＣＣＤ图象所使用的格式。实现这三种格式的相互转换，就可以自由的将ＣＣＤ图象在ＰＣ机和工作站上进行各种处理。转换的包括图象头和图象数据的转换，其关键在于交换数据的高低字节。     

图象的模型及其统计特性

本文对图象的统计特性及其适用模型作了分析。讨论了以前常用的平稳图象模型的缺陷,对实际图象的统计特性作了分析,认为它是非平稳的,不满足各态历经性,同时在空间上是高度相关的;讨论了相应的随机参数统计模型和描述性统计模型。指出作用于整幅图象的“全局”图象复原算法比每次只独立计算单个象元的“点”图象复原算法更为优越。     

Statistical analysis of sand grain/bed collision process recorded by high-speed digital camera

A high‐speed digital camera was employed to record the sand grain/bed collision process. With image processing and a statistical method, a series of parameters of the collision process were obtained. The results show that the collision process of a grain with rebounding can be represented by two parameters: the kinetic energy restitution coefficient and the collision angle. Both parameters satisfy a normal distribution, and they are dependent on one another. With an increase of the collision angle, the distribution of the kinetic energy restitution gradually reduces from a broad to a narrow range with low values. The percentage of vertical velocity restitution coefficients greater than 1 can reach 70% or more, which ensures that the settling time of the sand grains in the air increases and that they receive more energy from the air to progress the saltation movement.     

Dynamic recrystallization near the brittle-plastic transition in naturally and experimentally deformed quartz aggregates

The electron backscattering diffraction technique (EBSD) was used to analyze bulging recrystallization microstructures from naturally and experimentally deformed quartz aggregates, both of which are characterized by porphyroclasts with finely serrated grain boundaries and grain boundary bulges set in a matrix of very fine recrystallized grains. For the Tonale mylonites we investigated, a temperature range of 300–380 °C, 0.25 GPa confining pressure, a flow stress range of ~ 0.1–0.2 GPa, and a strain rate of ~ 10^− 13 s^− 1 were estimated. Experimental samples of Black Hills quartzite were analyzed, which had been deformed in axial compression at 700 °C, 1.2–1.5 GPa confining pressure, a flow stress of ~ 0.3–0.4 GPa, a strain rate of ~ 10^− 6 s^− 1, and to 44% to 73% axial shortening. Using orientation imaging we investigated the dynamic recrystallization microstructures and discuss which processes may contribute to their development. Our results suggest that several deformation processes are important for the dismantling of the porphyroclasts and the formation of recrystallized grains. Grain boundary bulges are not only formed by local grain boundary migration, but they also display a lattice misorientation indicative of subgrain rotation. Dynamic recrystallization affects especially the rims of host porphyroclasts with a hard orientation, i.e. with an orientation unsuitable for easy basal slip. In addition, Dauphiné twins within porphyroclasts are preferred sites for recrystallization. We interpret large misorientation angles in the experimental samples, which increase with increasing strain, as formed by the activity of fluid-assisted grain boundary sliding.     

Mapping Proterozoic unconformity-related uranium deposits in the Rockhole area, Northern Territory, Australia using landsat ETM+

The Rockhole area, Northern Territory, Australia, hosts a number of Proterozoic unconformity-related uranium deposits. The geology of the area features within Paleoproterozoic rocks of the Pine Creek Orogen, near the unconformity with overlying platform cover sandstone of the Paleo- to Mesoproterozoic McArthur Basin. Landsat Enhanced Thematic Mapper plus (ETM+) data was used in the Rockhole area to assist in mapping geological structures and lithology, and to identify anomalous concentrations of ferrous minerals, the product of alteration, which can be indicators of buried uranium mineralization. Several image-processing procedures were applied to the ETM+ data to identify, isolate and enhance mineralogical information as simple and complex false color composites. ETM+ 754 shown as red green and blue respectively was the best simple image. Overall, complex images based on Principal Component Analysis proved to be the most useful products. Sandstone, shale and siltstone, the target lithologies, Koolpin Formation, the target stratigraphic unit, and bleaching pattern due to the removal of iron(II) compounds, the target alteration pattern, were confidently mapped to provide information required by the mineral emplacement model, which ultimately identified areas of likely uranium mineralization. Thus the contrasting behavior of the two principle oxidation states of uranium and iron can be utilized to map/delineate bleached alteration zones associated with economic concentrations of uranium using multispectral sensors like Landsat or better hyperspectral sensors.     

Impact of lightning on organic matter-rich soils: influence of soil grain size and organic matter content on underground fires

A detailed study was carried out on a piece of land that had been struck by lightning during the violent rainstorm that raged over the Island of S?o Miguel (Azores Archipelago) in late October 2006. Temperature and gas measurements (CO₂, CO, H₂S and CH₄) were performed in four study trenches, dug in an area of ∼3 m², where an underground fire had been initiated by the impact with a lightning stroke, followed by the emission of a column of gases and smoke. The soil under study was originally a well-pedogenized about 80 cm thick bed, made of volcanic clayey to silty tephra fallouts and contained 5.5–9.7% of organic matter. The underground fire was monitored for one week and revealed a peak release of 404 ppm CO and 3.4% CO₂ originating from a horizon located about 45 cm under the soil surface. Measurements of temperature, performed one week after the impact, indicated a maximum value of 326°C inside the soil, while 516.5°C were measured on the surface of a lava block interred about 20 cm under the surface. Subsequently, a stratigraphic and sedimentologic study proved the role of the grain-size of the soil and of the organic matter content of the different horizons of the impact area, in determining the ratio between anoxic/oxidised combustion conditions and in the progress of the process itself. It was also noticed that combustion was not total all over in the soil bed and that the process had slightly migrated toward SW during the observation period. The combustion process went on for about ten days, in spite of several other violent rainstorms, until it was artificially extinguished through the excavations made to obtain study trenches. This particular circumstance evidenced the potential natural hazard represented by this kind of atmospheric event, especially in a land where the volcanic nature of the soil may easily mislead inexperienced observers and, consequently, delay proper action.     

Contribution of the SISCam Web-based GIS to the seismotectonic study of Campania (Southern Apennines): an example of application to the Sannio-area

In this article the implementation and potential of the Seismotectonic Information System of the Campania Region (SISCam) are described, in particular an application of this Web-based GIS system to the seismotectonic analysis of the Sannio area (Southern Apennines) is performed. WEB-GIS technologies greatly contribute to both the environmental monitoring and the disaster management of areas affected by high natural risks. Specifically the SISCam system has been developed with the aim of providing easy access and fast diffusion, through Internet technology, of the most significant geological, geophysical, and territorial data relative to the Campania Region. The Sannio area has been selected as our application example because it is among the most active seismic regions in Italy. This portion of the Southern Apennines which was hit by the June 5, 1688 strong earthquake (M _W = 6.7, CPTI 1999) and by some low- and moderate-energy seismic sequences (1990–1992, 1997), is characterized by a complex inherited tectonic setting and low-tectonic deformation rates that hide the seismogenic sources position. Since this case study turned out to be complicated, the use of the SIScam WEB-GIS has become indispensable because it allowed us to visualize, integrate and analyze all the data available, in order to obtain an accurate and direct picture of the seismotectonic setting of the area. Moreover, a different approach of data analysis was necessary, due to the lack of up-to-date neotectonic and structural data; therefore, the operation of this GIS system enabled us to process and generate some original informative layers, through image analysis, such as new structural lineaments represented on a map of the potential active faults of the area, which has been the final result of our application, as a contribution to new knowledge about the local seismic risk parameters.     

Field observations of waves generated by passing ships: A note

This short contribution reports the results of a field study on the nearshore characteristics of waves generated by both conventional and high speed passenger ferries. The field observations took place in the late summer of 2005, at a beach close to the port of Mytilene (Island of Lesbos, Greece), and involved the visual observation of ship waves, using digital video recordings and image processing techniques. The results showed that passage of the fast ferry was associated with a longer, more complex and energetic nearshore event; this event not only did include higher nearshore waves (up to 0.74 m) and was organised in different wave packets, but it was also an order of magnitude longer (∼ 680 s) than the conventional ferry event. Regarding the effects on beach sediment dynamics, the fast ferry waves were estimated to be very efficient in mobilising the nearshore sediments in contrast to those of the conventional ferry. The fast ferry service appears to generate daily prolonged nearshore events, which contain waves with higher energy than those expected from the normal summer wind wave regime of the area; these events also include some high and very steep waves, which can be particularly erosive. Therefore, fast ferry wakes may have considerable impacts on the seasonal beach sediment dynamics/morphodynamics and the nearshore benthic ecology, as well as they may pose significant risks to bathers, affecting the recreational use of the beaches exposed to fast ferry traffic. Finally, the study has shown that satisfactory field observations of the nearshore characteristics of ship-generated (and wind) waves can be obtained using inshore deployments of calibrated poles, digital video cameras and appropriate image processing algorithms.