Screening of polymers on selected Hawaii soils for erosion reduction and particle settling

In recent years, high‐molecular‐weight anionic polyacrylamides (PAMs) have been tested on a variety of soils, primarily in temperate climates. However, little information is available regarding the effectiveness of PAM for preventing soil loss through runoff in tropical settings. Screening tests were performed using three negatively charged PAMs and one positively charged PAM on five Hawaii soils (two Oxisols, one Vertisol, and two Aridisols) to determine erosion loss, sediment settling, and aggregate stability. A laboratory‐scale rainfall simulator was used to apply erosive rainfall at intensities from 5 to 8·5 cm h^?1 at various PAM doses applied in both dry and solution forms. Soil detachment due to splash and runoff, as well as the runoff and percolate water volumes, were measured for initial and successive storms. The impact of PAM on particle settling and aggregate stability was also evaluated for selected soil‐treatment combinations. Among the PAMs, Superfloc A‐836 was most effective, and significantly reduced runoff and splash sediment loss for the Wahiawa Oxisol and Pakini Andisol at rates varying between 10 and 50 kg ha^?1. Reduced runoff and splash sediment loss were also noted for PAM Aerotil‐D when applied in solution form to the Wahiawa Oxisol. Significant reductions in soil loss were not noted for either the Lualualei Vertisol or the Holomua Oxisol. It is believed that the high montmorillonite content of the Lualualei Vertisol and the low cation‐exchange capacity of the Holomua Oxisol diminished the effectiveness of the various PAMs tested. The polymers were also found to enhance sediment settling of all soils and helped improve their aggregate stability. This screening study shows the potential use of PAM for tropical soils for applications such as infiltration enhancement, runoff reduction, and enhanced sedimentation of detention ponds. Copyright © 2005 John Wiley & Sons, Ltd.     

Siltation Prediction for Navigation Channels and Harbour Basins on Muddy Beach

- This paper, after briefly reviewing the experimental research on sediment transport on muddy beach since the 1950s, improves and perfects the method for forecasting siltation in navigation channels and harbour basins which was first put forward in China by the authors. In consideration of silty sediment and sand, some factors in forecasting methods have been changed and modified. Consequently, the modified methods can be used either to compute siltation in navigation channels and harbour basins on muddy beach or to compute siltation and scouring in navigation channels and harbour basins on both silty beach and sandy beach. The verification of field data from eleven large, medium and small natural harbours shows a good agreement between the forecasting by the modified method and the natural conditions. Finally, the paper deals with the rational utilization of water area after the construction of the West Dyke in Lianyungang, the maintenance of water depth of the navigation channel at the entrance, siltation distribution, siltation in the navigation channel and harbour basin for ships of 100 thousand tonnnage. Results once again prove that the prospect of constructing Lianyungang Harbour into a deepwater harbour is bright.     

Lower Cd/P ratio in settling particles than in surface seawater in the Okinawa Trough

The characteristics of the ratios between cadmium (Cd) and phosphorus (P) in settling particles collected from the Okinawa Trough in the East China Sea were examined using a sediment trap, moored at a depth of 811 m for one year. The Cd/P ratios varied within a narrow range throughout the year, in spite of the large seasonal change in the total dry mass, Cd, and P fluxes. The average Cd/P ratio of settling particles was 0.062 (nmol/μmol), which was obviously lower than that of surface seawater around the study site (0.16). This lower ratio in the Okinawa Trough particles collected using the 811 m-moored trap certainly reflected the mixture of biologically produced organic matter around the study site and other components that were mainly transported as lateral flux from the shelf edge and slope area of the East China Sea.     

The stability of a remediated bed in Hamilton Harbour,Lake Ontario,Canada

ABSTRACT In situ measurements of lakebed sediment erodibility were made on three sites in Hamilton Harbour, Lake Ontario, using the benthic flume Sea Carousel. Three methods of estimating the surface erosion threshold (τ_c(0)) from a Carousel time series were evaluated: the first method fits measures of bed strength to eroded depth (the failure envelope) and evaluates threshold as the surface intercept; the second method regresses mean erosion rate (E_m) with bed shear stress and solves for the floc erosion rate (E_f) to derive the threshold for E_m = E_f = 1 × 10^?5 kg m^?2 s^?1; the third method extrapolates a regression of suspended sediment concentration (S) and fluid transmitted bed shear stress (τ₀) to ambient concentrations. The first field site was undisturbed (C) and acted as a control; the second (W) was disturbed through ploughing and water injection as part of lakebed treatment, whereas the third site (OIP) was disturbed and injected with an oxidant used for remediation of contaminated sediment. The main objectives of this study were: (1) to evaluate the three different methods of deriving erosion threshold; (2) to compare the physical behaviour of lacustrine sediments with their marine estuarine counterparts; and (3) to examine the effects of ploughing and chemical treatment of contaminated sediment on bed stability. Five deployments of Sea Carousel were carried out at the control site. Mean erosion thresholds for the three methods were: τ_c(0) = 0·5 (±0·06), 0·27 (±0·01) and 0·34 (±0·03) Pa respectively. Method 1 overpredicted bed strength as it was insensitive to effects in the surface 1–2 mm, and the fit of the failure envelope was also highly subjective. Method 2 exhibited a wide scatter in the data (low correlation coefficients), and definition of the baseline erosion rate (E_f) is largely arbitrary in the literature. Method 3 yielded stable (high correlation coefficients), reproducible and objective results and is thus recommended for evaluation of the erosion threshold. The results of this method correlated well with sediment bulk density and followed the same trend as marine counterparts from widely varying sites. Mass settling rates, expressed as a decay constant, k, of S(t), were strongly related to the maximum turbidity at the onset of settling (S_max) and were also in continuity with marine counterparts. Thus, it appears that differences in salinity had little effect on mass settling rates in the examples presented, and that biological activity dominated any effects normally attributable to changes in salinity. Bedload transport of eroded aggregates (2–4 mm in diameter) took place by rolling below a mean tangential flow velocity (U_y) of 0·32 ms^?1 and by saltation at higher velocities. Mass transport as bedload was a maximum at U_y = 0·4 ms^?1, although bedload never exceeded 1% of the suspended load. The proportion of material moving as bedload was greatest at the onset of erosion but decreased as flow competence increased. Given the low bulk density and strength of the lakebed sediment, the presence of a bedload component is notable. Bedload transport over eroding cohesive substrates should be greater in estuaries, where both sediment density and strength are usually higher. Significant differences between the ploughed and control sites were apparent in both the erosion rate and the friction coefficient (φ), and suggest that bed recovery after disruption is rapid (< 24 h). τ_c(0) increased linearly with time after ploughing and recovered to the control mean value within 3 days. The friction coefficient was reduced to zero by ploughing (diagnostic of fluidization), but increased linearly with time, regaining control values within 6 days. No long‐term reduction in bed strength due to remediation was apparent.     

Effects of Column Diameter on Setting Behavior of Dredged Slurry in Sedimentation Experiments

This article investigates the influence of dimensions of a settling column on the settling mode and the settling rate. End conditions of the settling stage in the hindered settling were also analyzed. It was found that the settling mode in a column with a smaller diameter tends to be consolidation settling. The effect of a settling column wall decreases with increasing column diameter, and it can be ignored provided the column diameter is larger than 14.5 centimeters. For the difference in initial water content, the settling behavior of the slurry develops a different sensitivity to the diameter effect. The influence of column diameter reduces as the initial water content of the slurry becomes higher. It is suggested that the internal diameter of the column used in a sedimentation experiment should be 14.5 centimeters.     

大型桥梁钢沉井下沉过程局部冲刷研究

钢沉井下沉过程中局部冲刷的研究是同类桥墩设计和施工十分关心的重要课题,它对保证钢沉井安全有效施工、桥梁设计中施工期桥墩最大冲深、失稳和安全计算有重要参考价值。通过室内试验研究了钢沉井下沉过程中的局部冲刷机理和冲刷形态,探讨了桥墩下部钢沉井基础施工的相对高程对局部冲刷的变化规律,并将试验研究所获得的局部冲刷规律和影响因素,采用墩型系数方法引入局部冲刷计算中,给出了计算公式。研究成果补充了国家行业规范内容,对同类工程的设计、施工具有借鉴和指导意义。     

江苏大丰潮滩悬沙级配特征及其动力响应

根据2002和2003年夏季在江苏大丰潮滩的现场观测资料,详细分析了悬沙级配的时空分布特征、影响因素及其对再悬浮、沉降和流速的响应.研究结果表明,悬沙颗粒较细,以粉砂为主,悬沙级配在潮周期内的变化模式有两种类型:一是稳定型,悬沙级配的时空(垂向和平面)变化很小;二是双峰型,悬沙级配的时空变化显著,粗细峰高度不断变化.再悬浮、沉降、涨潮时输入潮滩的悬沙和底质级配是影响悬沙级配的重要因子.再悬浮使粗颗粒悬沙的含量增加,悬沙与底质级配不断接近,沉降对悬沙级配的影响与再悬浮相反.再悬浮发生时悬沙级配对流速有明显响应.在没有再悬浮和沉降影响的情况下,潮滩不同部位、不同时间的悬沙级配趋于稳定和相同,对这种状态下的悬沙级配可称为背景悬沙级配,大丰潮滩背景悬沙级配的平均粒径为7μm.     

Numerical modeling of hyperpycnal flows in an idealized river mouth

Numerical experiments in an idealized river mouth are conducted using a three-dimensional hydrodynamics model (EFDC model) to examine the impacts of suspended sediment concentration (SSC), settling velocity of sediment and tidal mixing on the formation and maintenance of estuarine hyperpycnal flows. The standard experiment presents an illustrative view of hyperpycnal flows that carry high-concentrated sediment and low-salinity water in the bottom layer (>1.0 m in thickness) along the subaqueous slope. The structure and intra-tidal variation of the simulated hyperpycnal flows are quite similar to those previously observed off the Huanghe (Yellow River) mouth. Results from the three control experiments show that SSC of river effluents is the most important parameter to the formation of hyperpycnal flows. High SSC will increase the bulk density of river effluents and thus offset the density difference between freshwater and seawater. Low SSC of river effluents will produce a surface river plume, as commonly observed in most large estuaries. Both the settling velocity of sediment particles and the tidal mixing play an important role in maintaining the hyperpycnal flows. Increasing settling velocity enhances the deposition of sediment from the hyperpycnal layer and thus accelerates the attenuation of hyperpycnal flows, whereas increasing tidal mixing destroys the stratification of water column and therefore makes the hyperpycnal flows less evident. Our results from numerical experiments are of importance to understand the initiation and maintenance of hyperpycnal flows in estuaries and provide a reference to the rapidly decaying hyperpycnal flows off the Huanghe river mouth due to climatic and anthropogenic forcing over the past several decades.