Analysis of mapping coverage obtained from spacecraft

An exact analysis of the coverage obtained by spacecraft using cross-track scanning and nadir-centered conical imaging, under imposed viewing obliqueness and resolution requirements, is presented. In addition to exact expressions for the area acquired and the area acquisition rate, envelope theory is introduced to obtain the boundary of the imaged area. These expressions are relatively compact, allowing rapid machine computation. The effects of the sun phase angle, and of imaging system limitations are also examined. The Galileo mission encounter with Callisto is used as a numerical example, from which certain general conclusions are drawn regarding optimal imaging trajectories.     

Transforming observational data and theoretical isochrones into the ACS/WFC Vega-mag system

We propose a zero-point photometric calibration of the data from the Advanced Camera for Surveys (ACS) Wide Field Channel (WFC) on board the Hubble Space Telescope , based on a spectrum of Vega and the most up-to-date in-flight transmission curves of the camera. This calibration is accurate at the level of a few hundredths of a magnitude. The main purpose of this effort is to transform the entire set of evolutionary models into a simple observational photometric system for ACS/WFC data, and to make them available to the astronomical community. We provide the zero-points for the most used ACS/WFC bands, and give basic recipes for calibrating both the observed data and the models. We also present the colour–magnitude diagram from ACS data of five Galactic globular clusters, spanning the metallicity range  −2.2 <[Fe/H] < −0.04  , and we provide fiducial points representing their sequences from several magnitudes below the turn-off to the red giant branch tip. The observed sequences are compared with the models in the newly defined photometric system.     

Computerized streamflow measurement using slug injection

Using current meters to estimate flows in fast mountain streams is difficult and inaccurate. The salt dilution method offers an easier and more accurate alternative. The method has been used for many years but is time consuming and messy because of the need to mix chemical solutions and measure chemical concentrations in the field. A computer program has been developed which uses a laptop computer to calculate the mixing length and the mass of salt needed. The program controls the conductivity measurements and calculates the streamflow directly in the field. The development of this program is described and examples are presented of the application of the method in the Rocky Mountains of Alberta and British Columbia.     

4D seismic time-lapse monitoring of an active cold vent,northern Cascadia margin

Two single-channel seismic (SCS) data sets collected in 2000 and 2005 were used for a four-dimensional (4D) time-lapse analysis of an active cold vent (Bullseye Vent). The data set acquired in 2000 serves as a reference in the applied processing sequence. The 4D processing sequence utilizes time- and phase-matching, gain adjustments and shaping filters to transform the 2005 data set so that it is most comparable to the conditions under which the 2000 data were acquired. The cold vent is characterized by seismic blanking, which is a result of the presence of gas hydrate in the subsurface either within coarser-grained turbidite sands or in fractures, as well as free gas trapped in these fracture systems. The area of blanking was defined using the seismic attributes instantaneous amplitude and similarity. Several areas were identified where blanking was reduced in 2005 relative to 2000. But most of the centre of Bullseye Vent and the area around it were seen to be characterized by intensified blanking in 2005. Tracing these areas of intensified blanking through the three-dimensional (3D) seismic volume defined several apparent new flow pathways that were not seen in the 2000 data, which are interpreted as newly generated fractures/faults for upward fluid migration. Intensified blanking is interpreted as a result of new formation of gas hydrate in the subsurface along new fracture pathways. Areas with reduced blanking may be zones where formerly plugged fractures that had trapped some free gas may have been opened and free gas was liberated.     

Optical interferometric observations of a transient event of 1986 March 13 in the coma of Comet Halley

During the recent apparition of Comet Halley in 1985-86 a transient ionic event in the form of a blob of H₂ O⁺ emission was recorded in thecoma at ～ 0^h UT on 1986 March 13. Observations were carried out using a special IHW filter for H₂ O⁺ emission at 7000 å/175 å, a 35 cm telescope, a Fabry-Perot interferometer and an image intensifier camera from Gurushikhar, Mt Abu. (24?39’N,72? 47’E). A Fabry-Perot inter-ferogram in Ha taken a few minutes later at the same location reveals strong hydrogen emission (Hα) associated with the blob. The velocity field in the blob is structured with relative velocities upto ～ 35km s^?1. The event is interpreted as arising due to the sector boundary crossing of the interplanetary magnetic field by the comet     

基于DEM的SAR图像模拟

首先阐述了研究基于数字高程模型(DEM)的SAR图像模拟的重要性。然后针对SAR图像的几何特点,并顾及地面坡度、成像距离等因素对雷达波后向散射强度的影响,设计了基于强度积分的SAR图像模拟方案。根据Leberl构像模型计算SAR图像的像点坐标,采用强度积分策略对各点处的强度进行模拟,并进行归一化处理。通过仿真实验得到了满意的SAR模拟图像,验证了该模拟方案的正确性和有效性。     

成像光谱矿物填图精度兼与矿物丰度关系初探

成像光谱遥感技术在岩石矿物识别和矿物填图方面发挥着越来越大作用,而成像光谱矿物填图的精度问题一直是研究的焦点。文章利用高光谱数据HyMap对新疆东天山地区的矿物填图结果,通过引入矿物填绘分布强度的概念,探索性的分析了成像光谱矿物填图与填绘矿物丰度的关系。