Reef exploration in the East Sengkang Basin,Sulawesi, Indonesia

Reconnaissance seismic shot in 1971/72 showed a number of well defined seismic anomalies within the East Sengkang Basin which were interpreted as buried reefs. Subsequent fieldwork revealed that Upper Miocene reefs outcropped along the southern margin of the basin. A drilling programme in 1975 and 1976 proved the presence of shallow, gas-bearing, Upper Miocene reefs in the northern part of the basin. Seismic acquisition and drilling during 1981 confirmed the economic significance of these discoveries, with four separate accumulations containing about 750 × 10⁹ cubic feet of dry gas in place at an average depth of 700 m. Kampung Baru is the largest field and contains over half the total, both reservoir quality and gas deliverability are excellent. Deposition in the East Sengkang Basin probably started during the Early Miocene. A sequence of Lower Miocene mudstones and limestones unconformably overlies acoustic basement which consists of Eocene volcanics. During the tectonically active Middle Miocene, deposition was interrupted by two periods of deformation and erosion. Carbonate deposition became established in the Late Miocene with widespread development of platform limestones throughout the East Sengkang Basin. Thick pinnacle reef complexes developed in the areas where reef growth could keep pace with the relative rise in sea level. Most reef growth ceased at the end of the Miocene and subsequent renewed clastic sedimentation covered the irregular limestone surface. Late Pliocene regression culminated in the Holocene with erosion. The Walanae fault zone, part of a major regional sinistral strike-slip system, separates the East and West Sengkang Basins. Both normal and reverse faulting are inferred from seismic data and post Late Pliocene reverse faulting is seen in outcrop.     

Petroleum exploration potential of Tamtsag Basin

The Tamtsag Basin is located in the extreme eastern portion of the Mongolia. The Basin and its counterpart in China (the Hailar Basin) are united a whole basin on the structural setting. In recent years, the Tamtsag Basin attracts more and more attention with the important exploration discovered in the 19th block by SOCO and in Hailar Basin of China. This paper discusses the exploration potential of Tamtsag Basin from the viewpoint of petroleum geology.     

Geological environment conflicts of Kunming Basin and its urban sustainable development

Kunming Basin locates middle of Yunnan altiplano and has a particularity in geography,topographic and geological environment.With the urban dilation quickly,add the reason of the unreasonable city layout,conflicts between environment and urban resources consumption become shrill increasingly.It is human being activities that lead to vulnerability and depravation of geological environment in local.Take a few examples on geological environment to expatiate relationship between urban construction and geological environment carrying capacity,and find a way how to make a better plan for urban sustainable development to achieve new balance between man and nature in local.     

柴达木盆地东北缘古元古代变质镁铁—超镁铁质岩的地质特征及成因探讨

1:5万区域地质调查工作中,在柴达木陆块北缘首次发现古元古代变质镁铁—超镁铁质岩,获得成岩年龄为1952±15Ma,其岩石化学、地球化学特征反映出岩浆来源于亏损地幔,反映出该地区克拉通在古元古代(19亿年)发生了一次强烈的裂解(洋)事件,对于研究柴达木盆地北缘元古代结晶基底地质构造演化及进一步探讨柴达木盆地的起源及构造演化过程提供了重要地质线索。     

断层相关褶皱理论在准噶尔盆地南缘山前带构造研究的应用

利用断层相关褶皱的构造几何分析方法，对准噶尔盆地南缘山前复杂构造带内基于地震剖面进行了构造解析，搭建了中、东段的构造轮廓和构造组合样式，认为东段阜康断裂带主要表现为至地表的推覆逆掩。由于位移量大部分转移至地表，阜康断裂带的前陆部分无喜山期构造带；西段造山带内的挤压往前陆方向传递过程中以前列式不断释放其位移量，造成在纵向上呈现三排主要的断层相关褶皱带。根据正演平衡地质剖面制作技术对山前复杂构造区地震剖面反射波的构造识别进行了模拟与探讨。     

Sedimentary characteristics of tide-dominated estuary in Donghetang Formation（Upper Devonian）, central Tarim Basin

The Donghetang Formation （Upper Devonian） in central Tarim Basin has been thought an important oil and gas reservoir since the abundant oil and gas resources were found in the wells W16, W20, W34, and other fields. However, the sedimentary environment of the Donghetang Formation has been disputed because it suffered from both tidal and fluvial actions and there were not rich fossils in the sandstone. After the authors analyzed sedimentary features by means of drill cores, well logging data, paleosols, and with SEM obseruations, three kinds of sedimentary environments were distinguished： alluvial fan, tide-dominated estuary, and shelf. Particularly, the sedimentary features of tide-dominated estuary were studied in detail. Besides, the authors discussed sedimentary characteristics of the Donghetang Formation which was divided into two fourth-order sequences and five system tracts. At the same time, according to the forming process of five system tracts, the whole vertical evolution and lateral transition of tide-dominated estuary were illustrated clearly. Finally, the reservoir quality was evaluated based on porosity and permeability.     

AREAL DIFFERENTIATION AND CONSTRUCTION OF OASIS AGRICULTURAL ECOSYSTEM IN THE SHIYANG RIVER BASIN

On the basis of the study on areal differentiation of the natural environment of oasis agriculture ecosystems in the Shiyang River Basin, this paper comparatively analyzes the natural productivities, water economic benefits, production efficiency, ecological stabilities and developmental conditions of the Wuwei Oasis agricultural ecosystem in the middle reaches of the river basin and the Minqin Oasis agricultural ecosystem in the lower reaches. Under a same management level and investment of . material and energy, primary productiveness and economic benefits of the former are higher than those of the latter. Construction directions of Wuwei and Minqin oases should be different in order to alleviate the water- use contradiction between the middle and lower reaches. The construction objective of Wuwei Oasis should be efficient irrigated farming production system and Minqin Oasis should become a mixed forestry-pastoral-farming ecosystem taking ecological protection as its major function.     

CHARACTERIZATION OF LACTATE DEHYDROGENASE ISOZYME PATTERN AND MORPHOLOGY OF THREE MARINE FISH CELL LINES

Three continuous marine fish cell lines of FG (i. e., Hounder Gill) from flounder (Paralichthys olivaceus) gill, SPH (i. e. , Sea Perch Heart) from sea perch (Lateolabrax japonicus) heart and RSBF (i.e., Red Sea Bream Fin) from red sea bream (Pagrosomus major) fin, were characterized by lactate dehydrogenase (LDH) isozyme and morphological analysis. The LDH isozyme patterns of these three cell lines and their corresponding tissues of origin were investigated and compared. The results showed: (1) No difference was found in the LDH isozyme patterns of FG and flounder gill tissue. However, the LDH isozyme patterns of SPH and RSBF were significantly different from their corresponding tissues of origin; (2) LDH isozyme patterns of FG, SPH and RSBF were markedly different from each other and could serve as genetic markers for species identification and detection of cross contamination. Morphological change analysis of these three cell lines in comparison to their original tissues indicated that FG cells still appeared epithelioid without morphological transformation. However, morphological changes were found in SPH and RSBF compared to their original tissues. Therefore, the cellular morphology was still plastic in the relatively stable culture conditions, and it was possible that change of LDH patterns wasrelated to morphological changes of fish cells in vitro.     

地形面方法在渭河盆地活断层研究中的应用

本文主要依据地形图和航空照片解译，并经已有地质、钻孔资料验证及野外实地考察的方法来研究地形面及其变形特征，由此确定渭河盆地活断层的分布、最新活动特征及活动规律，为地震预报及地震危险性分析提供依据。     

Discriminating between pore‐filling load and bed‐structure load: a new porosity‐based method,exemplified for the river Rhine

Sediments contained in the river bed do not necessarily contribute to morphological change. The finest part of the sediment mixture often fills the pores between the larger grains and can be removed without causing a drop in bed level. The discrimination between pore‐filling load and bed‐structure load, therefore, is of practical importance for morphological predictions. In this study, a new method is proposed to estimate the cut‐off grain size that forms the boundary between pore‐filling load and bed‐structure load. The method evaluates the pore structure of the river bed geometrically. Only detailed grain‐size distributions of the river bed are required as input to the method. A preliminary validation shows that the calculated porosity and cut‐off size values agree well with experimental data. Application of the new cut‐off size method to the river Rhine demonstrates that the estimated cut‐off size decreases in a downstream direction from about 2 to 0·05 mm, covariant with the downstream fining of bed sediments. Grain size fractions that are pore‐filling load in the upstream part of the river thus gradually become bed‐structure load in the downstream part. The estimated (mass) percentage of pore‐filling load in the river bed ranges from 0% in areas with a unimodal river bed, to about 22% in reaches with a bimodal sand‐gravel bed. The estimated bed porosity varies between 0·15 and 0·35, which is considerably less than the often‐used standard value of 0·40. The predicted cut‐off size between pore‐filling load and bed‐structure load (D_c,p) is fundamentally different from the cut‐off size between wash‐load and bed‐material load (D_c,w), irrespective of the method used to determine D_c,p or D_c,w. D_c,w values are in the order of 10^?1 mm and mainly dependent on the flow characteristics, whereas D_c,p values are generally much larger (about 10⁰ mm in gravel‐bed rivers) and dependent on the bed composition. Knowledge of D_c,w is important for the prediction of the total sediment transport in a river (including suspended fines that do not interact with the bed), whereas knowledge of D_c,p helps to improve morphological predictions, especially if spatial variations in D_c,p are taken into account. An alternative to using a spatially variable value of D_c,p in morphological models is to use a spatially variable bed porosity, which can also be predicted with the new method. In addition to the morphological benefits, the new method also has sedimentological applications. The possibility to determine quickly whether a sediment mixture is clast‐supported or matrix‐supported may help to better understand downstream fining trends, sediment entrainment thresholds and variations in hydraulic conductivity.