Sonar acoustic facies and sediment distribution on an area of the deep ocean floor

Long-range sidescan sonar can be used to map sediment distributions over wide expanses of deep ocean floor. Seven acoustic facies that arise from differing sediment or rock types have been mapped over the low-relief Saharan continental rise and Madeira abyssal plain. These have been calibrated with sampling, profiling and camera studies and the facies can be traced confidently on a regional scale using the sidescan data. The mapping of the sediment distribution shows that a complex interplay of turbidity current and debris flow processes can occur at a continental rise/abysaal plain transition over 1000 km from the nearest continental slope.     

Computerized streamflow measurement using slug injection

Using current meters to estimate flows in fast mountain streams is difficult and inaccurate. The salt dilution method offers an easier and more accurate alternative. The method has been used for many years but is time consuming and messy because of the need to mix chemical solutions and measure chemical concentrations in the field. A computer program has been developed which uses a laptop computer to calculate the mixing length and the mass of salt needed. The program controls the conductivity measurements and calculates the streamflow directly in the field. The development of this program is described and examples are presented of the application of the method in the Rocky Mountains of Alberta and British Columbia.     

In situ strength measurements on natural upper-mantle minerals

Using in situ strength measurements at pressures up to 10 GPa and at room temperature, 400, 600, and 700°C, we examined rheological properties of olivine, orthopyroxene, and chromian-spinel contained in a mantle-derived xenolith. Mineral strengths were estimated using widths of X-ray diffraction peaks as a function of pressure, temperature, and time. Differential stresses of all minerals increase with increasing pressure, but they decrease with increasing temperature because of elastic strain on compression and stress relaxation during heating. During compression at room temperature, all minerals deform plastically at differential stress of 4–6 GPa. During subsequent heating, thermally induced yielding is observed in olivine at 600°C. Neither orthopyroxene nor spinel shows complete stress relaxation, but both retain some stress even at 700°C. The strength of the minerals decreases in the order of chromian-spinel ≈ orthopyroxene > olivine for these conditions. This order of strength is consistent with the residual pressure of fluid inclusions in mantle xenoliths.     

On the recovery of surface wave by pressure transfer function

Except the commonly selected pressure transfer function derived from the linear wave theory, a previous study on the pressure transfer function for recovering surface wave from underwater pressure transducer suggested that the pressure transfer function is a function of frequency parameter only. With careful analysis, this study showed that the pressure transfer function should include a transducer submergence parameter as that given by the linear theory. It was found that the previously suggested empirical formula should be restricted to measurements with the pressure transducer close to the surface; otherwise overestimation of wave height would result. Field measurements were carried out with an acoustic wave gauge and a synchronized pressure transducer located at various depths with submergence parameter close to 1 (near the sea floor). It was shown that the previous one-parameter empirical formula might overestimate the significant wave height by more than 30%. This study found that with deep-water wave bursts excluded, the transfer function based on the linear wave theory provided a fairly good estimation on the significant wave heights, with an average deviation of 3.6%.     

GPS在计算导弹脱靶量中的应用研究

将GPS技术应用于导弹靶试脱靶量测量,并对计算过程作了较为详细的分析和探讨。试验证明：利用GPS测定脱靶量,测量精度高,简单易行,可以在靶场逐步试验推广。     

A comparative error analysis of manual versus automated methods of data acquisition for algebraic strain estimation

This paper presents a statistical analysis of the algebraic strain estimation algorithm of Shimamoto and Ikeda [Shimamoto, T., Ikeda, Y., 1976. A simple algebraic method for strain estimation from deformed eillipsoidal objects: 1. Basic theory. Tectonophysics 36, 315–337]. It is argued that the error in their strain estimation procedure can be quantified using an expected discrepancy measure. An analysis of this measure demonstrates that the error is inversely proportional to the number of clasts used. The paper also examines the role of measurement error, in particular that incurred under (i) a moment based and (ii) manual data acquisition methods. Detailed analysis of these two acquisition methods shows that in both cases, the effect of measurement error on the expected discrepancy is small relative to the effect of the sample size (number of objects). Given their relative speed advantage, this result favours the use of automated measurement methods even if they incur more measurement error on individual objects. Validation of these results is carried out by means of a simulation study, as well as by reference to studies appearing in previous literature. The results are also applied to obtain an upper bound on the error of strain estimation for various studies published in the literature on strain analysis.     

等距等高电磁波测距三角高程测量及精度分析

介绍了等距等高电磁波测距三角高程测量的原理，详细深入地分析了这种高程测量方法的精度，通过计算和作图表示，可直观地反映在不同条件下的精度变化情况，讨论了代替国家等级水准测量的范围和条件，可供生产实际和进一步研究参考。     

川滇菱形块体边界的现今地壳形变

依据川滇菱形块体边界带上所有跨断层测量资料，分析了各场地所处断裂的近期形变特征，结果表明；川滇菱形块体北段形变活动逐渐减弱，南段逐渐加强，各条断裂分别显示出不同的变形特征；菱形块体的现今水平形变以左旋走滑运动为主，垂直形变速度较低，且呈上盘抬升与下降交替出现的运动特征，部分场地的形变异常变化与其邻近的地震活动密切相关。     

TDP-0844地震前兆数据综合采集器的研制

介绍了TDP—0844型地震前兆数据综合采集器采用的设计方案及工作原理，及各个功能模块的设计准则，并列出了采集器实现的功能。文章还给出了采集器的部分应用图例，证明该采集器能够满足地震前兆观测需要。     

现代通讯技术在自动化测量系统中的应用

介绍了基于现代通讯技术ADSL及GPRS的两种远程监控方式在自动化测量系统工程中的应用。获得的结论对于相关技术及专业的应用研究具有一定的借鉴作用。