Modelling the effect of changing precipitation inputs on deep soil water utilization

Forests in the Southeastern United States are predicted to experience future changes in seasonal patterns of precipitation inputs as well as more variable precipitation events. These climate change‐induced alterations could increase drought and lower soil water availability. Drought could alter rooting patterns and increase the importance of deep roots that access subsurface water resources. To address plant response to drought in both deep rooting and soil water utilization as well as soil drainage, we utilize a throughfall reduction experiment in a loblolly pine plantation of the Southeastern United States to calibrate and validate a hydrological model. The model was accurately calibrated against field measured soil moisture data under ambient rainfall and validated using 30% throughfall reduction data. Using this model, we then tested these scenarios: (a) evenly reduced precipitation; (b) less precipitation in summer, more in winter; (c) same total amount of precipitation with less frequent but heavier storms; and (d) shallower rooting depth under the above 3 scenarios. When less precipitation was received, drainage decreased proportionally much faster than evapotranspiration implying plants will acquire water first to the detriment of drainage. When precipitation was reduced by more than 30%, plants relied on stored soil water to satisfy evapotranspiration suggesting 30% may be a threshold that if sustained over the long term would deplete plant available soil water. Under the third scenario, evapotranspiration and drainage decreased, whereas surface run‐off increased. Changes in root biomass measured before and 4 years after the throughfall reduction experiment were not detected among treatments. Model simulations, however, indicated gains in evapotranspiration with deeper roots under evenly reduced precipitation and seasonal precipitation redistribution scenarios but not when precipitation frequency was adjusted. Deep soil and deep rooting can provide an important buffer capacity when precipitation alone cannot satisfy the evapotranspirational demand of forests. How this buffering capacity will persist in the face of changing precipitation inputs, however, will depend less on seasonal redistribution than on the magnitude of reductions and changes in rainfall frequency.     

Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.     

Implementation of a coupled plastic damage distinct lattice spring model for dynamic crack propagation in geomaterials

This paper studies dynamic crack propagation by employing the distinct lattice spring model (DLSM) and 3‐dimensional (3D) printing technique. A damage‐plasticity model was developed and implemented in a 2D DLSM. Applicability of the damage‐plasticity DLSM was verified against analytical elastic solutions and experimental results for crack propagation. As a physical analogy, dynamic fracturing tests were conducted on 3D printed specimens using the split Hopkinson pressure bar. The dynamic stress intensity factors were recorded, and crack paths were captured by a high‐speed camera. A parametric study was conducted to find the influences of the parameters on cracking behaviors, including initial and peak fracture toughness, crack speed, and crack patterns. Finally, selection of parameters for the damage‐plasticity model was determined through the comparison of numerical predictions and the experimentally observed cracking features.     

Bacterial productivity in the Prydz Bay and its adjacent waters,Antarctic

1　IntroductionBacteriaandtheiractivitiesplayanimportantroleintheelementalbiogeochemicalcyclesandenergytransformingintheocean (Zhenetal.1 997) .DortchandPackard(1 989) proposedthatfoodwebsintheeutrophicwatersaredominatedbythebiomassofprimaryproducerswhilefoodwebsintheoligotrophicwatersaredominatedbythebiomassofmicrobes.Heterotrophicbacteriahadbeenshowntoplayanimportantroleinthedecompositionoflarge ,rapidlysinkingorganicparticleswithinandbelowtheeuphot iczone ,andfurthertoaffecttheelementaldyn…     

双极化天气雷达方程

在回转椭球状降水粒子的假设下求出了降水粒子的散射截面，并且考虑了粒子轴线铅垂和随机取向两种重要的典型情况；推导了双极化雷达的回波方程以及降雨量公式。该方程除包含降水粒子的信息外，关于雷达与降水粒子间的几何关系都以雷达天线仰角及雷达与降水粒子间的距离表示，同时还考虑了地球的球面效应和大气折射效应。由于采用了并矢方法，使推导简捷明了     

地壳对海洋潮汐的响应

应用三维动态有限元方法研究了中国北部地区的地壳对邻近的渤海与黄海海平面变化的响应。虽然此应力场过于微弱不足以引发地震，但发现应力集中的位置及应力场变化较大的位置恰好与某些现代地震的震中一致。这一结果表明研究地壳对广泛分布的载荷的响应对研究区域地震构造是有帮助的。     

层序-岩相古地理图及其编制

在中国岩相古地理研究历史简要回顾基础上,以层序地层学理论为指导,就如何编制层序-岩相古地理图进行了讨论,首先是编图单元的选择,一是以层序内的体系域为成图单元,二是以相关界面为成图单元.具体方法是在对所研究的层位进行精细的层序地层分析的基础上,进行层序对比,建立等时地层格架.在上述基础上系统编制不同层序内的各体系域或有关界面沉积时的古地理图.以此方法所编制的层序-岩相古地理图具有重要的理论和现实意义,主要表现为更具有等时性、成因连续性和实用性,能更好地反映一个地区在统一地质作用场中的各种地质信息和综合效应;可以揭示出一些新的地质现象,对于覆盖区相带展布及变化具更合理的预测性.进而以中国南方二叠纪为例,在层序划分、对比的基础上,系统编制了一个完整的海平面变化旋回条件下的层序-岩相古地理图,并描述了其平面展布特点.     

Periodical light variations of t tauri stars as a result of disk accretion

I argue that temperatures of spots, responsible for observed periodical light variations of T Tauri stars (TTS), are not known with reliable accuracy to discriminate between chromospheric and accretion theories of TTS 's phenomenon. The hypothesis is set up that spots on classical TTS (CTTS) are due to heating of stellar surface by radiation from a collisional accretion shock, whereas spots on weak line TTS (WTTS), at least in some cases, are connected with a collisionless accretion shock rather than chromospheric activity. Possible scenarios of WTTS interaction with circumstellar matter are discussed.     

Virtual Huanghe River System： Framework and Technology

1 Introduction Huanghe (Yellow) River basin is located in 32°–42°N, 96°–119°E. The area of the catchment is more than 752,000km2. The river is 5464km long with a drop in elevation of 4830m. Among the whole area, the moun- tainous and stone area accounts for 29%, loess and hills area 46%, sandy area 11% and plain area 14%, respec- tively. Different natural landscapes exist in this area. The Huanghe River flows through the Loess Plateau, where the soil is eroded seriously (Wang, 2002;…     

分组密码的安全性与强化设计

分组密码是数据通讯中最常用的数据加密方式，以DES为例分析现有分组加密算法的安全隐患，并提出了可变密钥加密和变长密文输出两个新思路，可应用于所有现有分组加密算法以提高安全性，并就该方法的安全性、效率、具体应用做出了分析。