基于噪声谱比法的内蒙古西部地区台站场地响应研究

利用内蒙古西部12个台站的地脉动噪声数据，采用噪声谱比法研究台站的场地响应情况。分析表明，台站场地响应按曲线形态可分为3类，且可能受地形地貌、局部构造和台基状况等条件影响。对比分析噪声谱比法与Moya方法的场地响应结果发现，场地响应曲线形态基本一致，只有极少数台站存在明显差异。结果表明，内蒙古西部区域大部分台站的台基状况总体较好，场地响应曲线较为平坦，无明显频率放大点。     

Chemical alteration of tephra in the depositional environment: theoretical stability modelling

The study of the chemical stability of vitreous material in aqueous media is well‐established. There has to date been little consideration of the implications of variations in the chemical durability of tephra in Quaternary tephrochronology. Chemical alteration can take the form of cationic leaching from the matrix, or complete destruction of the silica network, either of which could constrain the ability to chemically identify distal tephra. Here we apply established models of vitreous durability to the published chemical analyses of a large number of Icelandic tephras in order to predict their relative durabilities under equivalent conditions. This suggests that some important tephras have relatively poor chemical stability, and that rhyolitic tephras are, in general, more stable than basaltic. We conclude that tephras should be expected to show predictable differential chemical stability in the post‐depositional environment. Copyright © 2003 John Wiley & Sons, Ltd.     

伪随机码调制的CW半导体激光雷达试制报告

本文报告一种用半导体激光器作光源,用子脉冲宽度100ns,长度为511的周期伪随机码对半导体激光器的输出作幅度调制;APD作光电检测器,高速数字信号处理器TMS320C25作信号处理的激光雷达组成方案和试作样机的实验结果。     

塔中4号油藏渗透率分布的非均质性及渗流方向研究

研究油藏内部油水渗流方向时,主要考虑渗透率影响,引入两个水平方向渗透率比、水平与垂向渗透率比参数来分析。前者反映样品所在储层平面上两个水平方向渗流能力的差异,后者反映样品所在储层水平与垂向渗流能力的差异,并经小柱样测试和全岩心测试两种方法确定两个参数。通过对塔中4号油藏CⅠ油组9口井2306个样品两种渗透率比值分布直方图分析,研究了CⅠ油组渗透率的非均质性及其渗流方向:CI油组储层在水平方向的渗流能力有很大差异,具有明显的方向性。储层垂向渗流能力明显小于水平方向的渗流能力。     

用PCI中断实现射电望远镜跟踪的方法

讨论运用PCI 9054(美国PLX公司生产的接口芯片)作为接口芯片的PCI(Peripheral Component Interconnect)板卡的软硬件设计,以实现天线跟踪的两个时间同步中断。利用标准秒信号中断作为系统时钟同步信号,并同步产生时间间隔为20ms(或40、50ms,可选)的中断信号,来处理天线跟踪指令输出。中断信号通过PCI中断口INTA#接入计算机,在驱动中识别不同的中断信号,并在应用程序响应中断处理后,命令ACU(Antenna Control Unit)机,实现射电天文望远镜的同步跟踪。其控制过程分3部分阐述:硬件设计、驱动程序设计、安装及应用;着重讨论了前两者的设计方法及思路。     

Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)

Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.     

Electromagnetic signals associated with stick–slip of quartz-free rocks

We recorded clear transients in the electric and magnetic fields upon sudden slip in stick–slip experiments on dry, cylindrically shaped, quartz-free rock specimens of basalt and peridotite with a 30° saw-cut (representing a fault) at confining pressures of up to 120 MPa. The amplitudes of the measured electric field signals were always higher at the electrode pair oriented parallel to the strike of the fault than at the pair oriented perpendicular. This anisotropy suggests a preferred electric polarization normal to the slip surface. The transients in the electric and magnetic fields were observed only when the fault slip occurred by stick–slip mode, not by a stable mode of the sliding, and the amplitudes of the electric field signals increased with increasing stress drop. It is suggested that the generation process of the electromagnetic signals is closely related to the characteristic behavior of the fault at the time of the initiation of slip during stick–slip events, probably with respect to the intensity of the signals. We propose that one or both of the following two processes characteristic of the fault at the time of the initiation of slip during stick–slip events are essential for the generation of detectable electromagnetic signals: rapid slip along the simulated fault and separation of the rock masses across the fault.     

Landslide susceptibility mapping for a landslide-prone area (Findikli,NE of Turkey) by likelihood-frequency ratio and weighted linear combination models

Landslides are very common natural problems in the Black Sea Region of Turkey due to the steep topography, improper use of land cover and adverse climatic conditions for landslides. In the western part of region, many studies have been carried out especially in the last decade for landslide susceptibility mapping using different evaluation methods such as deterministic approach, landslide distribution, qualitative, statistical and distribution-free analyses. The purpose of this study is to produce landslide susceptibility maps of a landslide-prone area (Findikli district, Rize) located at the eastern part of the Black Sea Region of Turkey by likelihood frequency ratio (LRM) model and weighted linear combination (WLC) model and to compare the results obtained. For this purpose, landslide inventory map of the area were prepared for the years of 1983 and 1995 by detailed field surveys and aerial-photography studies. Slope angle, slope aspect, lithology, distance from drainage lines, distance from roads and the land-cover of the study area are considered as the landslide-conditioning parameters. The differences between the susceptibility maps derived by the LRM and the WLC models are relatively minor when broad-based classifications are taken into account. However, the WLC map showed more details but the other map produced by LRM model produced weak results. The reason for this result is considered to be the fact that the majority of pixels in the LRM map have high values than the WLC-derived susceptibility map. In order to validate the two susceptibility maps, both of them were compared with the landslide inventory map. Although the landslides do not exist in the very high susceptibility class of the both maps, 79% of the landslides fall into the high and very high susceptibility zones of the WLC map while this is 49% for the LRM map. This shows that the WLC model exhibited higher performance than the LRM model.     

Estimating potential landslide sites of an upland sub-watershed in Western Ghat’s of Kerala (India) through frequency ratio and GIS

The purpose of this study is to assess the susceptibility of landslides in parts of Western Ghats, Kerala, India, using a geographical information system (GIS). Landslide inventory of the area was made by detailed field surveys and the analysis of the topographical maps. The landslide triggering factors are considered to be slope angle, slope aspect, slope curvature, slope length, distance from drainage, distance from lineaments, lithology, land use and geomorphology. ArcGIS version 8.3 was used to manipulate and analyse all the collected data. Probabilistic-likelihood ratio was used to create a landslide susceptibility map for the study area. The result was validated using the Area under Curve (AUC) method and temporal data of landslide occurrences. The validation results showed satisfactory agreement between the susceptibility map and the existing data on landslide locations. As the result, the success rate of the model was (84.46%) and the prediction rate of the model was (82.38%) shows high prediction accuracy. In the reclassified final landslide susceptibility zone map, 5.68% of the total area is classified as critical in nature. The landslide susceptibility map thus produced can be used to reduce hazards associated with landslides and to land cover planning.     

饱和粉砂不稳定性的试验研究

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。