激光拉曼光谱法分析多种显微组分荧光变化及其应用

利用激发488 nm激光的氩离子激光器作为RENISHAW inVia型激光拉曼光谱仪的光源,建立了多种显微组分荧光变化(FAMM)分析方法,并对镜质体反射率明显抑制的东营凹陷有效烃源岩进行了测定。结果表明,东营凹陷有效烃源岩的有机质类型越好,镜质体反射率抑制程度越高,有效烃源岩的真实成熟度应主要处于0.64%~1.30%,而不是实测镜质体反射率所反映的0.37%~1.10%。     

The petroleum evaluation of a tectonically complex area: The western margin of the Southeast Basin (France)

The Southeast Basin of France is the thickest onshore French sedimentary basin which contains locally as much as 10 km of Mesozoic-Cenozoic sediment. Basin development occurred in several stages between late Carboniferous and late Cretaceous times. Partial tectonic inversion took place during two compressive events, the so-called ‘Pyrenean’ and ‘Alpine’ phases of late Cretaceous-early Tertiary and late Tertiary ages respectively. They are separated by an intervening stretching event of Oligocene age, which further south resulted in the opening of the western Mediterranean oceanic basin. As a result of this complex tectonic history, structural traps were difficult to image on the seismic data shot during the first phase of exploration prior to 1980. Oil and gas natural seeps, and shows in several wells, indicate that some petroleum systems are, or have been active, at least in some places.The present erosional western margin of the basin is more or less superimposed on the initial Triassic-Jurassic margin. Margin subsidence and Tertiary inversion are discussed using regional sections on which the polyphase history of the entire basin is well shown. These sections are located on three major segments where the Mesozoic margin is either partly preserved (Ardèche), or has been partly inverted in late Tertiary times (Vercors-Chartreuse), or has been completely inverted in early Tertiary times (Corbières-eastern Pyrenees). 1-D ‘Genex’ basin modelling on the Ardèche segment, and 2-D ‘Thrustpack’ structural-maturity modelling in the Vercors-Chartreuse segment are used to further assess the remaining petroleum plays.     

长竹蛏人工育苗技术的初步研究

本文对长竹蛏繁殖习性、胚胎发育和人工育苗技术关键进行研究．结果表明亲贝经暂养可促进性成熟；幼虫对温、盐度的适应较广；变态附着采用缩光培育,未经缩光的附着时间延长,存活率降低;幼虫长至约240μm变态附着,附着量在(0.6～10)×106个/m     

加水热模拟中深湖与煤系泥岩地化特征比较

通过深湖泥岩和煤系泥岩的加水热模拟研究认为,在热模拟实验过程中,深湖泥岩和煤系泥岩显示不同特征,并且其演化有差别。深湖泥岩利于液态原油的生成,并且转化率高于煤系泥岩。深湖泥岩残余可溶有机质饱和烃含量高于煤系泥岩,非烃含量则低于煤系泥岩。深湖泥岩胶质 /沥青质和饱芳比均随温度升高而降低,而煤系泥岩的胶质 /沥青质随温度升高有增加趋势,其饱芳比的变化则不大或有降低趋势。深湖泥岩的T_max难以指示演化阶段,其干酪根碳同位素值明显轻于煤系泥岩,它们的值均随温度的升高而变重。     

伊通地堑下第三系原油和生油岩中芳构化五环三萜及其地球化学意义

详细研究了吉林伊通地堑下第三系生油岩和原油中的芳烃生物标志物，包括常规的多环芳烃，以及丰富的来源于高等植物的芳香二萜和芳构化的五环三萜。目前，原油中芳构化五环三萜类生物类生物标志物国内外均尚报道极少。还详细讨论了利用原油中最新发现的芳构化五环三萜在解决本区生物输入，油源对比以及石油成因等方面的重要意义。     

Thermal evolution of an extensional detachment as constrained by organic metamorphic data and thermal modeling: Graz Paleozoic Nappe Complex (Eastern Alps)

Following Early Cretaceous nappe stacking, the Eastern Alps were affected by late-orogenic extension during the Late Cretaceous. In the eastern segment of this range, a Late Cretaceous detachment separates a very low- to low-grade metamorphic cover (Graz Paleozoic Nappe Complex, GPNC) above a low- to high-grade metamorphic basement. Synchronously, the Kainach Gosau Basin (KGB) collapsed and subsided on top of the section.Metamorphism of organic material within this section has been investigated using vitrinite reflectance data and Raman spectra of extracted carbonaceous material. In the southern part of the GPNC, vitrinite reflectance indicates a decrease in organic maturity towards the stratigraphic youngest unit. The remaining part of the GPNC is characterized by an aureole of elevated vitrinite reflectance values and Raman R2 ratios that parallels the margins of the GPNC. Vitrinite reflectance in the KGB shows a steep coalification gradient and increases significantly towards the western basin margin. The observed stratigraphic trend in the southern GPNC is a result of deep Paleozoic to Early Cretaceous burial. This maturity pattern was overprinted along the margins by advective heat and convective fluids during Late Cretaceous to Paleogene exhumation of basement rocks.During shearing, the fault zone was heated up to ca. 500 °C. This overprint is explained by a two-dimensional thermal model with a ramp-flat fault geometry and a slip rate of 1 to 1.5 cm/year during 5 Ma fault movement. The collapse basin above the detachment subsided in a thermal regime which was characterized by relaxing isotherms.