A synthesis map of the sky at 34.5 MHz

This paper describes a wide-field survey made at 34.5 MHz using GEETEE,1 the low frequency telescope at Gauribidanur (latitude 13°36′12′′N). This telescope was used in the transit mode and by per forming 1-D synthesis along the north-south direction the entire observable sky was mapped in a single day. This minimized the problems that hinder wide-field low-frequency mapping. This survey covers the declination range of-50° to + 70° (- 33° to +61° without aliasing) and the complete 24 hours of right ascension. The synthesized beam has a resolution of 26′ x 42′ sec (δ- 14°. 1). The sensitivity of the survey is 5 Jy/beam (1σ). Special care has been taken to ensure that the antenna responds to all angular scale structures and is suitable for studies of both point sources and extended objects This telescope is jointly operated by the Indian Institute of Astrophysics, Bangalore and the Roman Research Institute, Bangalore.     

应用GPS观测青藏高原东北缘应力场变化

采用各向同性弹性地球模型推导了地面位移场速率与地壳内任意点应力场变化的边界积分关系,同时利用青藏高原东北缘1999～2001年观测的GPS资料对观测区地壳深度为5 km和25 km的主应力和最大剪应力进行了计算分析.结果表明,青藏高原东北缘的主应力变化主要集中在祁连山断裂、海原断裂等,在1920～1954年间历史上发生过多次震级为7.0～8.5级强震的断裂附近,并具有主应力变化沿断层走向分布、最大剪应力沿断层走向交替变化等特征.     

Influence of soft clays on the response spectra for structures in eastern Canada

The 1990 edition of the National Building Code of Canada (Associate Committee of the National Building Code, National Research Council, Ottawa, 1990) makes a clear distinction between eastern and western Canada in terms of seismic acceleration and velocity zones. While it is well established that ground motions can be amplified significantly through loose clay deposits, no results are available that take into consideration the typical high frequency content of ground motions in eastern Canada. This paper develops ground amplification curves for clays having depths between 10 and 70 m excited by typical eastern Canadian ground motions scaled to two different values of peak horizontal accelerations. Simplified free-field spectral design curves, which could be used by structural designers, are proposed. The curves show that maximum spectral accelerations occur for structural periods between 0.2 and 0.5 s. In addition, soil depth does not appear to be an important parameter controlling the response of typical clay deposits in eastern Canada.     

The Statistical Analysis of Migration of Strong Earthquakes-Taking the North China Region as an Example

The migration of strong earthquakes is an important research topic because the migration phenomena reflect partly the seismic mechanism and involve the prediction of tendency of seismic activity. Research on migration of strong earthquakes has mostly focused on finding the phenomena. Some attempts on getting regularity were comparatively subjective. This paper suggests that there should be indices of migration in earthquake dataset and the indexes should have statistical meaning if there is regularity in the migration of strong earthquakes. In this study, three derivative attributes of migration, i.e., migration orientation, migration distance and migration time interval, were statistically analyzed. Results in the North China region show that the migration of strong earthquakes has statistical meaning. There is a dominant migration orientation (W by S to E by N), a dominant distance (≤100km and on the confines of 300～700km), and a dominant time interval (≤1a and on the confines of 3～4a). The results also show that the migration will differ slightly with different magnitude range or earthquake activity phase.     

Low-frequency damping of a moored semisubmersible obtained from simulated extinction tests and mean wave drift forces

Low-frequency damping of a moored semisubmersible drilling platform was obtained from numerical extinction tests simulated in still water and in regular waves and from mean wave drift forces calculated at zero forward speed. The influence of drag forces was represented by the modified Morison equation. The platform as used for the 18th ITTC Comparative Mooring Study was analyzed in irregular beam waves. The computed time series of sway as well as the corresponding sway response spectrum compared favourably with model test measurements, demonstrating that this procedure to determine low-frequency damping can be effective.     

Bayesian estimation of seismic hazard for two sites in Switzerland

Seismic hazard analysis is based on data and models, which both are imprecise and uncertain. Especially the interpretation of historical information into earthquake parameters, e.g. earthquake size and location, yields ambiguous and imprecise data. Models based on probability distributions have been developed in order to quantify and represent these uncertainties. Nevertheless, the majority of the procedures applied in seismic hazard assessment do not take into account these uncertainties, nor do they show the variance of the results. Therefore, a procedure based on Bayesian statistics was developed to estimate return periods for different ground motion intensities (MSK scale).Bayesian techniques provide a mathematical model to estimate the distribution of random variables in presence of uncertainties. The developed method estimates the probability distribution of the number of occurrences in a Poisson process described by the parameter . The input data are the historical occurrences of intensities for a particular site, represented by a discrete probability distribution for each earthquake. The calculation of these historical occurrences requires a careful preparation of all input parameters, i.e. a modelling of their uncertainties. The obtained results show that the variance of the recurrence rate is smaller in regions with higher seismic activity than in less active regions. It can also be demonstrated that long return periods cannot be estimated with confidence, because the time period of observation is too short. This indicates that the long return periods obtained by seismic source methods only reflects the delineated seismic sources and the chosen earthquake size distribution law.     

Some comparisons between mining-induced and laboratory earthquakes

Although laboratory stick-slip friction experiments have long been regarded as analogs to natural crustal earthquakes, the potential use of laboratory results for understanding the earthquake source mechanism has not been fully exploited because of essential difficulties in relating seismographic data to measurements made in the controlled laboratory environment. Mining-induced earthquakes, however, provide a means of calibrating the seismic data in terms of laboratory results because, in contrast to natural earthquakes, the causative forces as well as the hypocentral conditions are known. A comparison of stick-slip friction events in a large granite sample with mining-induced earthquakes in South Africa and Canada indicates both similarities and differences between the two phenomena. The physics of unstable fault slip appears to be largely the same for both types of events. For example, both laboratory and mining-induced earthquakes have very low seismic efficiencies where _a is the apparent stress and is the average stress acting on the fault plane to cause slip; nearly all of the energy released by faulting is consumed in overcoming friction. In more detail, the mining-induced earthquakes differ from the laboratory events in the behavior of as a function of seismic momentM ₀. Whereas for the laboratory events 0.06 independent ofM ₀, depends quite strongly onM ₀ for each set of induced earthquakes, with 0.06 serving, apparently, as an upper bound. It seems most likely that this observed scaling difference is due to variations in slip distribution over the fault plane. In the laboratory, a stick-slip event entails homogeneous slip over a fault of fixed area. For each set of induced earthquakes, the fault area appears to be approximately fixed but the slip is inhomogeneous due presumably to barriers (zones of no slip) distributed over the fault plane; at constant , larger events correspond to larger _a as a consequence of fewer barriers to slip. If the inequality _a / 0.06 has general validity, then measurements of _a =µE _a /M ₀, where is the modulus of rigidity andE _a is the seismically-radiated energy, can be used to infer the absolute level of deviatoric stress at the hypocenter.     

Micromechanics of the velocity and normal stress dependence of rock friction

Among the second-order effects on friction the most important are those of variable normal stress and of slip velocity. Velocity weakening, which is usually considered the source of the stick-slip instability in rock friction, has been observed in velocity stepping experiments with Westerly granite. The friction change, , was –0.01 to –0.008 for a tenfold velocity increase. Using normal closure measurements, we observed dilation upon each increase in sliding rate. We also observed, for the first time, time-dependent closure between surfaces during static loading. The dilation that occurred during the velocity stepping experiment was found to be that expected from the static time-dependent closure phenomenon. This change in closure was used to predict friction change with an elastic contact model. The calculated friction change which results from a change in contact area and asperity interlocking, is in good agreement with the observed velocity dependence of steady-state friction. Variable normal stress during sliding has two effects, first in creating new partial slip contacts and locking some existing fully sliding contacts and second in increasing interlocking, for instance when normal load is suddenly increased. As a result, a transient change in friction occurs upon a sudden change in normal load.     

Probabilistic seismic hazard zonation of Syria

Earthquake hazard maps for Syria are presented in this paper. The Peak Ground Acceleration (PGA) and the Modified Mercalli Intensity (MMI) on bedrock, both with 90% probability of not being exceeded during a life time of 50, 100 and 200 years, respectively are developed. The probabilistic PGA and MMI values are evaluated assuming linear sources (faults) as potential sources of future earthquakes. A new attenuation relationship for this region is developed. Ten distinctive faults of potential earthquakes are identified in and around Syria. The pertinent parameters of each fault, such as theb-parameter in the Gutenberg-Richter formula, the annual rate ₄ and the upper bound magnitudem ₁ are determined from two sets of seismic data: the historical earthquakes and the instrumentally recorded earthquake data (AD 1900–1992). The seismic hazard maps developed are intended for preliminary analysis of new designs and seismic check of existing civil engineering structures.