Three-dimensional finite element simulation of fracture propagation in rock specimens with pre-existing fissure(s) under compression and their strength analysis

A FORTRAN program, consistent with the commercially available finite element (FE) code ABAQUS, is developed based on a three-dimensional (3D) linear elastic brittle damage constitutive model with two damage criteria. To consider the heterogeneity of rock, the developed FORTRAN program is used to set the stiffness and strength properties of each element of the FE model following a Weibull distribution function. The reliability of the program is assessed against available experimental results for granite cylindrical specimens with a throughgoing, flat and inclined fissure. The calibration procedure of the material parameters is explained in detail, and it is shown that the compressive to tensile strength ratio can have a substantial influence on the failure response of the specimens. Numerical simulations are conducted for models with different levels of heterogeneity. The results show a smaller load bearing capacity for models with less homogeneity, representing gradual coalescence of fully damaged elements forming throughout the models during loading. The maximum load bearing capacity is studied for various combinations of inclination angles of two centrally aligned, throughgoing and flat fissures of equal length embedded in cylindrical models under uniaxial and multiaxial loading conditions. The key role of the compressive to tensile strength ratio is highlighted by repeating certain simulations with a lower compressive to tensile strength ratio. It is proven that the peak loads of the rock models with sufficiently small compressive to tensile strength ratios containing two throughgoing fissures of equal length are similar, provided that the minimum inclination angles of the models are the same. The results are presented and discussed with respect to the existing experimental findings in the literature, suggesting that the numerical model applied in this study can provide useful insight into the failure behaviour of rock-like materials.     

基于GPIB接口的计数器数据采集与控制软件

在Windows平台上 ,使用VC 6 .0开发了一套基于GPIB接口的计数器数据采集与控制软件 ,其特点是采用了多线程机制 ,可实现对计数器的控制 ,以及数据的采集与实时显示。     

Optimal Filtering Algorithm for Stochastic 2-D FMM Ⅱ with Multiplicative Noise

1　Introduction　Inrecentyearstherehasbeengrowingresearchin terestinthetwo dimensional (2 D )systemtheory .The 2 Dsystemsmayfindapplicationsinareassuchasmarineseismicdataprocessingandimageprocessing .Althoughmoreandmorevaluableresultshavebeengained ,mos…     

单片机控制的电子显示屏

本文介绍了由８０３１单片机控制的ＬＥＤ发光二极管阵列构成的电子显示屏显示原理、显示屏数据锁存、驱动接口电路、键盘接口电路、字模存放电路及软件框图。     

居民收入与通信网络市场经济效益研究--以河北省通信网络为实例

利用Logisitic曲线模型和扩展支撑模型对居民可支配收入预测和单项消费预测，以河北省居民的收入及其消费支出为实例，研究了城镇居民和农民的可支配收入分配和单项边际消费倾向，合理建立了预测模型，并理论计算了1999～2003年的通信消费方面的边际消费倾向、预测了2004～2008年通信消费情况。最后，根据预测结果对通信网络建设提出了一些有价值的建议。     

Biological and granulometric controls on sedimentary organic matter of an intertidal mudflat

A variety of measures of organic matter concentration and quality were made on samples collected from the top few mm of intertidal mudflat sediment over the course of a year, in order to assess the relative importance of biological and sedimentological influences on sedimentary organic matter. Winter and summer were times of relatively fine-grained sediment accumulation, caused by biological deposition or stabilization processes and resulting in higher organic matter concentrations. Stable carbon isotope and Br:C ratios indicated a planktonic source of bulk organic matter. Ratios of organic carbon to specific surface area of the sediments were consistent with an organic monolayer coverage of sediment grains. Correction for changing grain size during the year showed no change in the organic concentration per unit surface area, in spite of organic matter inputs by in situ primary production, buildup of heterotroph biomass and mucus coatings, and biodeposition of organic-rich seston. There were also no indications of changes in bulk organic quality, measured as hydrolyzable carbohydrates and amino acids, in response to these biological processes. It is concluded that biological processes on a seasonal time scale affect the bulk organic matter of these sediments via a modulation of grain size rather than creation or decay of organic matter.     

A high resolution,multiproxy Late‐glacial record of climate change and intrasystem responses in northwest England

A lacustrine carbonate sequence from Hawes Water, Lancashire, UK, has been studied using stable isotopic, lithological, pollen and mineral magnetic analysis. The data reveal four abrupt climatic oscillations in the Late‐glacial Interstadial leading up to the onset of the Loch Lomond Stadial. The data also point to climatic warming relatively early within the stadial, ca. 12 500 GRIP yr, prior to the onset of the Holocene. The oxygen isotope record is taken as a signature of climate forcing against which the response of the lake‐system can be monitored. By adopting this approach it is revealed that the response of the biological system to the rapid climatic oscillations is non‐linear and primarily a function of the antecedent conditions. A significant end‐Devensian isotopic excursion (A) is matched by only minor changes in the cold‐adapted floras and faunas. During the warmer interstadial, the response of the biological ecosystem (events B–D) is clearly influenced by thresholds: major changes in the catchment vegetation associated with relatively minor oscillations in the isotopic signature. The stratigraphical patterns reveal significant lag effects between the onset of climate deterioration and resulting changes in vegetation. Copyright © 2002 John Wiley & Sons, Ltd.     

复杂模型重力位场快速正反演方法及应用

提要 本文详细讨论了一种三维重力位场快速正反演方法。作者在前人工作的基础上,对算法作了行之有效的改进,通过对反演中的不稳定因素进行各种理论模型试算,得出保证迭代反演稳定收敛的准则,编制出可在微型机IBM—PC上运行的人机对话式自动正反演程序。本文还对各种不均质模型进行了模似计算并将该方法应用于某含油气沉积盆地的双层界面构造研究,揭示出了储油有利地段。     

利用高光谱数据进行植被生化成分反演方法研究

高光谱数据包含着丰富光谱信息,能够定量地分析物质成分^[1]。由高光谱数据,可以运用多元逐步线性回归方法反演植被生化组分含量,从而达到监测植被生长状况的目的^[2]。本文具体介绍了多元逐步线性回归方法,及其在氮、木质素和纤维素含量估算中的应用。