Time–space fractional governing equations of transient groundwater flow in confined aquifers: Numerical investigation

In order to model non‐Fickian transport behaviour in groundwater aquifers, various forms of the time–space fractional advection–dispersion equation have been developed and used by several researchers in the last decade. The solute transport in groundwater aquifers in fractional time–space takes place by means of an underlying groundwater flow field. However, the governing equations for such groundwater flow in fractional time–space are yet to be developed in a comprehensive framework. In this study, a finite difference numerical scheme based on Caputo fractional derivative is proposed to investigate the properties of a newly developed time–space fractional governing equations of transient groundwater flow in confined aquifers in terms of the time–space fractional mass conservation equation and the time–space fractional water flux equation. Here, we apply these time–space fractional governing equations numerically to transient groundwater flow in a confined aquifer for different boundary conditions to explore their behaviour in modelling groundwater flow in fractional time–space. The numerical results demonstrate that the proposed time–space fractional governing equation for groundwater flow in confined aquifers may provide a new perspective on modelling groundwater flow and on interpreting the dynamics of groundwater level fluctuations. Additionally, the numerical results may imply that the newly derived fractional groundwater governing equation may help explain the observed heavy‐tailed solute transport behaviour in groundwater flow by incorporating nonlocal or long‐range dependence of the underlying groundwater flow field.     

高温高压岩石流变仪的围压标定方法

高温高压岩石流变仪围压标定的主要方法为氯化盐类的部分熔融法和矿物相变法。利用氯化盐类进行压力标定时,不仅可以利用单一盐类,也可以使用多种盐类的混合物;常用的压力标定矿物相变及其适用温压范围如下:石英-柯石英,500~1200℃、2.5~3.2GPa;钠长石-硬玉+石英,600~1200℃、1.6~3.2GPa;铁橄榄石+石英-铁辉石,600~1200℃、1~1.7GPa;磷镁石-Mg3(PO4)2-Ⅱ,565~825℃、0.6~0.9GPa;方解石-文石,600~1200℃、0.5~2.5GPa。不同的标定方法具有不同的特征,文中将进行详细介绍。     

大开间小型混凝土砌块10层模型房屋抗震性能试验研究(Ⅰ)

我国抗震设计规范（GB50011－2001）规定在6、7、8度区，混凝土小砌块结构分别可以建七、六、五层。由于混凝土小砌块结构的最大优势在于10－20层（与混凝土框架或框架剪力墙结构比）。本文按1／4比例制作了10层混凝土小砌块结构模型，按7度设防要求实施构造措施，通过振动台试验研究模型结构的抗震性能。结果表明，模型结构完全能够满足在7度区“小震不坏，大震不倒”的要求。圈梁、构造柱以及水平拉结筋构成的约束体系抗震作用是明显的。试验利用砌块的非注芯孔灌注铁砂来模拟墙体出平面动力效应。在本模型的构造措施下，平出面反应不对结构破坏起控制作用。     

含裂隙煤层底板突水规律的数值模拟与工程应用

本文结合淮北杨庄矿某工作面实际工程情况, 利用NCAP-2D-W对煤层底板突水进行多方案的数值模拟试验研究。主要内容包括:(1) 考虑在承压水不变的条件下,设计不同裂隙分布状态,探讨单裂隙、多裂隙、不同长度裂隙对煤层底板破坏的影响及开采矿压对裂隙顶部破坏的影响;(2) 考虑承压水的变化,分别考虑单裂隙和多裂隙两种分布状态,探讨裂隙对煤层底板破坏的影响及开采矿压对裂隙底部破坏的影响。通过分析受采动荷载、岩层结构变化、煤层底板中裂隙分布状态及承压水变化等因素影响的数值试验,获得了随开采工作面不断推进煤层底板破坏区的发展、突水导升高度的递增、突水通道的形成等相关规律。     

Confined aquifer as wave-guide and its responses to geo-acoustic waves

ＣｏｎｆｉｎｅｄａｑｕｉｆｅｒａｓｗａｖｅｇｕｉｄｅａｎｄｉｔｓｒｅｓｐｏｎｓｅｓｔｏｇｅｏａｃｏｕｓｔｉｃｗａｖｅｓＷＥＮＢＩＮＪＩＡＮ１）（简文彬）ＢＡＯＲＥＮＣＨＥＮ２）（陈葆仁）ＨＵＡＦＵＬＵ２）（卢华复）１）Ｄｅｐａｒｔｍｅｎｔ...     

某中学教学楼的抗震鉴定与加固设计

按老规范设计的砌体结构未考虑抗震，使用年代过长会出现承载力不足的问题，需对原结构按新规范进行全面检测和抗震鉴定，若鉴定结果表明该结构不符合抗震要求，则需进行加固，结合一实际工程对检测程序和加固方法做一全面论述，供工程实际中参考。     

苏州城市规划区Ⅱ承压水开采与地面沉降预防控制研究

在孔隙承压水开采与地面沉降的关系上存在2种观点。水、土应力平衡理论认为：只要开采承压水，就会引发应力失衡并导致地面沉降；而水、土动态平衡理论则认为：除非开采水压力至水、土应力平衡面以下，否则不会引发地面沉降。苏州城市规划区第Ⅱ承压水开采水位与地面沉降动态观测表明，在-33m处存在一个天然动态水、土应力平衡面。第Ⅱ承压含水层形成后，经上覆堆积物自重压力长期压缩作用，其水压力具较高的压强．这种天然状态下产生的弹性释放储存量可开采利用多少，取决于开采状态下水、土应力平衡时可消耗压力水柱高度中的水头值。因而地面沉降的根本原因是开采水位超过了-33m，突破了天然状态水、土应力平衡面水位。Ⅱ承压含水层在天然状态受上覆堆积物重力产生的高压强弹性释放储存量现象，可以帮助我们确立该地区孔隙Ⅱ承压水开采不产生地面沉降的临界水位(水、土应力平衡面)。这一点对承压水开采条件、可开采资源性质具有重大实际意义。同样可以应用于饱受地面沉降困扰的无锡、常州及周边地区，为地下水开发利用政策由单一的封井停采转为目标水位控制开采提供了科学依据。同时也为此政策在承压水动力学机制上找到了内在原因。     

承压水减压引起的沉降分析

由下卧承压水层减压引起的固结沉降计算与一般的由堆载或潜水位下降引起的固结沉降计算不同,本文着重研究了在深厚弱透水层下卧强透水承压层的复杂地质条件下,下卧承压水层减压引起的土中应力变化及周围地表沉降的计算方法;在假定一维竖向固结的条件下推导了减压引起的沉降固结度计算公式,该公式与常规的双向排水固结公式相同,表明排水减压固结与常规的双向排水固结有着相同的效果.最后,将此分析方法应用于潮州供水枢纽工程西溪水闸沉降分析中,实践的结果表明,该方法简单可行,能较好地满足工程要求.     

Pseudo‐dynamic seismic response of reinforced concrete frames infilled with non‐structural brick masonry

This paper presents pseudo‐dynamic test results on the in‐plane seismic behaviour of infilled frames. Thirteen single‐storey, single‐bay, half‐size‐scale, reinforced concrete‐frame specimens, most of which infilled with non‐structural masonry made of perforated bricks and cement mortar are tested. The infills are in contact with frames, without any connector; openings are not covered. The frames are different in their strength and details, reinforcement grade, and aspect ratio. Seismic input is the 1976 Tolmezzo (Friuli, Italy) ground acceleration, to which specimens are subjected two times: virgin and damaged by the previous test. The global seismic response of initially virgin infilled specimens considerably differs from that of bare specimens. This follows a dramatic change of properties: compared to a bare frame, the initial stiffness increases by one order of magnitude, and the peak strength more than doubles. The peak drift lessens; however, the displacement ductility demand does not. The energy demand is greater. Nevertheless, the influence of infill decreases as damage proceeds. Displacement time histories of damaged specimens are quite similar. At the local level, infill causes asymmetry and concentration of the frame deformation. Copyright © 2005 John Wiley & Sons, Ltd.     

锚杆支护及在高承压水土层基坑中的应用

在邻海地区富含高承压水的土层中施工预应力锚杆支护工程的难度很大.介绍了锚杆的构造、作用机理、施工工艺以及决定锚杆施工质量的关键技术.以深圳某商住楼基坑施工为例,探讨了在承压水土层中采用锚杆支护的方法,创造性地提出了"先堵水后注浆"的施工工艺,可供沿海、沿江地区的类似工程借鉴.