Effects of the geometry of two‐dimensional fractures on their hydraulic aperture and on the validity of the local cubic law

Flow through rough fractures is investigated numerically in order to assess the validity of the local cubic law for different fracture geometries. Two‐dimensional channels with sinusoidal walls having different geometrical properties defined by the aperture, the amplitude, and the wavelength of the walls' corrugations, the corrugations asymmetry, and the phase shift between the two walls are considered to represent different fracture geometries. First, it is analytically shown that the hydraulic aperture clearly deviates from the mean aperture when the walls' roughness, the phase shift, and/or the asymmetry between the fracture walls are relatively high. The continuity and the Navier–Stokes equations are then solved by means of the finite element method and the numerical solutions compared to the theoretical predictions of the local cubic law. Reynolds numbers ranging from 0.066 to 66.66 are investigated so as to focus more particularly on the effect of flow inertial effects on the validity of the local cubic law. For low Reynolds number, typically less than 15, the local cubic law properly describes the fracture flow, especially when the fracture walls have small corrugation amplitudes. For Reynolds numbers higher than 15, the local cubic law is valid under the conditions that the fracture presents a low aspect ratio, small corrugation amplitudes, and a moderate phase lag between its walls.     

Multiple longshore sand bars in the upper Chesapeake Bay

In the upper Chesapeake Bay (Maryland, U.S.A.) field surveys were conducted at 18 multiple longshore sand bar sites. The multiple bar systems were found in water depths less than approximately 2 m (mean sea level), and exhibited mild bottom slopes of 0·0052 or less. The number of bars composing each system ranged from four to 17 and the spacing between the crests typically increased in the offshore direction, ranging from 12 to 70 m. Bar height also typically increased with distance offshore and ranged from 0·03 to 0·61 m. A grain size analysis of crest and trough sediment did not reveal any significant differences and the sediment was categorized as ‘fine sand’. A review of the literature data indicated that the Chesapeake Bay multiple bars possessed similar characteristics to those found in Gelding Bay (Baltic Sea); similarities in fetch, wave height and tidal range between the two bays may account for this finding. The surf-scaling parameter indicated that the multiple bar systems were extremely dissipative with regard to wave energy, and wave height appeared to be an important factor in controlling bar spacing and bar height. A multiple wave break point hypothesis was discussed as a possible mechanism for the formation of Chesapeake Bay multiple longshore bars, and limited observational evidence appeared to support such a mechanism.     

Strain localization in sand: an overview of the experimental results obtained in Grenoble using stereophotogrammetry

Experimental results are presented from the extensive program of drained plane strain compression tests on sand carried out in Grenoble over the last two decades. Systematic analysis of photographs of the deforming specimen allowed for measuring deformations and determining strain fields throughout the test, that is: prior to, at, and after the onset of strain localization. The principles, details and accuracy of the procedure are described, as well as its suitability to properly depict the patterns of deformation. Findings concerning the occurrence and progression of strain localization are discussed. The issues of shear band orientation and thickness are addressed, as well as temporary and persistent complex localization patterns, and the volumetric behaviour inside a band after its formation. The influence of such variables as initial state of the sand (effective stress and relative density), specimen size and slenderness, as well as grain size, is discussed. Copyright © 2004 John Wiley & Sons, Ltd     

Alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands)

Ancient fluvial successions often act as hydrocarbon reservoirs. Sub‐surface data on the alluvial architecture of fluvial successions are often incomplete and modelling is performed to reconstruct the stratigraphy. However, all alluvial architecture models suffer from the scarcity of field data to test and calibrate them. The purposes of this study were to quantify the alluvial architecture of the Holocene Rhine–Meuse delta (the Netherlands) and to determine spatio‐temporal trends in the architecture. Five north–south orientated cross‐sections, perpendicular to the general flow direction, were compiled for the fluvial‐dominated part of the delta. These sections were used to calculate the width/thickness ratios of fluvial sandbodies (SBW/SBT) and the proportions of channel‐belt deposits (CDP), clastic overbank deposits (ODP) and organic material (OP) in the succession. Furthermore, the connectedness ratio (CR) between channel belts was calculated for each cross‐section. Distinct spatial and temporal trends in the alluvial architecture were found. SBW/SBT ratios decrease by a factor of ca 4 in a downstream direction. CDP decreases from ca 0·7 (upstream) to ca 0·3 (downstream). OP increases from less than 0·05 in the upstream part of the delta to more than 0·25 in the downstream delta. ODP is approximately constant (0·4). CR is ca 0·25 upstream, which is approximately two times larger than in the downstream part of the delta. Furthermore, CDP in the downstream Rhine–Meuse delta increases after 3000 cal yr BP. These trends are attributed to variations in available accommodation space, floodplain geometry and channel‐belt size. For instance, channel belts tend to narrow in a downstream direction, which reduces SBW/SBT, CDP and CR. Tectonics cause local deviations in the general architectural trends. In addition, the positive correlation between avulsion frequency and the ratio of local to regional aggradation rate probably influenced alluvial architecture in the Rhine–Meuse delta. The Rhine–Meuse data set can be a great resource when developing more sophisticated models for alluvial architecture simulation, which eventually could lead to better characterizations of hydrocarbon reservoirs. To aid such usage of the Rhine–Meuse data set, constraints for relevant parameters are provided at the end of the paper.     

Morphological analysis of the drainage system in the Eastern Alps

We study the morphology of the major rivers draining the Eastern Alps to test whether the active tectonics of this part of the orogen is reflected in the shape of channel profiles of the river network. In our approach we compare channel profiles measured from digital elevation models with numerically modelled channel profiles using a stream power approach. It is shown that regions of high stream power coincide largely with regions of highest topography and largest uplift rates, while the forelands and the Pannonian Basin are characterised by a significantly lower stream power. From stream power modelling we conclude that there is young uplift at the very east of the Eastern Alps, in the Bohemian Massif and in the Pohorje Range. The impact of the Pleistocene glaciations is explored by comparing properties of rivers that drain in proximal and distal positions relative to the ice sheet during the last glacial maximum. Our analysis shows that most knick points, wind gaps and other non-equilibrium features of catchments covered by ice during the last glaciations (Salzach, Enns) can be correlated with glacial processes. In contrast the ice free catchments of the Mur and Drava are characterized by channels in morphological equilibrium at the first approximation and are showing only weak evidence of the strong tectonic activity within these catchments. Finally, the channel profiles of the Adige and the divide between the upper Rhine and Danube catchments differ significantly from the other catchments. We relate this to the fact that the Adige and the Rhine respond to different base levels from the remainder of the Eastern Alps: The Adige may preserve a record from the Messininan base level change and the Rhine is subject to the base level lowering in the Rhine Graben.     

Migration of the Ganga river and its implication on hydro-geological potential of Varanasi area, U.P., India

Borehole data reveals that during Late Quaternary, the Ganga river was non-existent in its present location near Varanasi. Instead, it was flowing further south towards peripheral craton. Himalayan derived grey micaceous sands were being carried by southward flowing rivers beyond the present day water divide of Ganga and mixed with pink arkosic sand brought by northward flowing peninsular rivers. Subsequently, the Ganga shifted to its present position and got incised. Near Varanasi, the Ganga river is flowing along a NW-SE tectonic lineament. The migration of Ganga river is believed to have been in response to basin expansion caused due to Himalayan tectonics during Middle Pleistocene times. Multi-storied sand bodies generated as a result of channel migration provide excellent aquifers confined by a thick zone of muddy sediments near the surface. Good quality potable water is available at various levels below about 70 m depth in sandy aquifers. Craton derived gravelly coarse-to-medium grained sand forms the main aquifer zones of tens of meter thickness with enormous yield. In contrast, the shallow aquifers made up of recycled interfluve silt and sandy silt occur under unconfined conditions and show water-level fluctuation of a few meters during pre-and post-monsoon periods.     

饱和粉砂不稳定性的试验研究

通过对净砂和级配良好粉砂(含10 %粉土)进行一系列三轴固结不排水试验（CU）,研究了粉土、孔隙比和围压对饱和粉砂不稳定性的影响。试验结果表明,净砂与粉砂在不排水剪切条件下均会出现应变软化现象（即不稳定性）。同一围压下脆性指数(IB)随孔隙比增加,但不稳定线的应力比随孔隙比增加而减小。引用等效粒间孔隙比(ege)后,净砂和粉砂在ege-ln p?平面上拥有基本相同的临界状态线。在临界状态理论及等效粒间孔隙比的基础上,提出在同一修正状态参数(?ge)下净砂和级配良好粉砂有相似的不稳定性。     

滦河三角洲砂坝-潟湖海岸环境的遥感分析与区域开发潜力的评价

本文就不同类型淀湖在不同时相条件下,对卫星遥感谱段响应的分析结果,将研究区的信息进行了提取与复合.继之,解译了封闭与半封闭漏湖的发育进程和表观特征,并就七个潟湖区段环境乃至开发前景作了详细的阐述.     

Siltation Prediction for Navigation Channels and Harbour Basins on Muddy Beach

- This paper, after briefly reviewing the experimental research on sediment transport on muddy beach since the 1950s, improves and perfects the method for forecasting siltation in navigation channels and harbour basins which was first put forward in China by the authors. In consideration of silty sediment and sand, some factors in forecasting methods have been changed and modified. Consequently, the modified methods can be used either to compute siltation in navigation channels and harbour basins on muddy beach or to compute siltation and scouring in navigation channels and harbour basins on both silty beach and sandy beach. The verification of field data from eleven large, medium and small natural harbours shows a good agreement between the forecasting by the modified method and the natural conditions. Finally, the paper deals with the rational utilization of water area after the construction of the West Dyke in Lianyungang, the maintenance of water depth of the navigation channel at the entrance, siltation distribution, siltation in the navigation channel and harbour basin for ships of 100 thousand tonnnage. Results once again prove that the prospect of constructing Lianyungang Harbour into a deepwater harbour is bright.     

Stress Sharing Behavior and Its Mechanism during Consolidation Process in Composite Ground Improved by Sand Compaction Piles with Low Replacement Area Ratio

In order to accurately design a sand compaction pile (SCP) with low replacement area ratio, it is important to understand the mechanical interaction between the sand pile and clay ground and its mechanism during consolidation process in composite ground. In this article, therefore, a series of numerical analyses on composite ground improved by SCP with low replacement area ratio were carried out. The applicability of numerical analyses, in which an elasto-viscoplastic consolidation finite element method was applied, were confirmed by comparing the results obtained from a series of laboratory model tests with the composite ground improved by SCP. Through the results of the numerical analyses, mechanical behavior of the sand pile and clay in composite ground during consolidation is elucidated, together with a stress sharing mechanism between sand pile and clay.