A novel coupled FDM-DEM modelling method for flexible membrane boundary in laboratory tests

Difficulties are involved in discrete element method (DEM) modelling of the flexible boundary, that is, the membranes covering the soil sample, which can be commonly found in contemporary laboratory soil tests. In this paper, a novel method is proposed wherein the finite difference method (FDM) and DEM are coupled to simulate the rubber membrane and soil body, respectively. Numerical plane strain and triaxial tests, served by the flexible membrane, are implemented and analysed later. The effect of the membrane modulus on the measurement accuracy is considered, with analytical formulae derived to judge the significance of this effect. Based on an analysis of stress-strain responses and the grain rotation field, the mechanical performances produced by the flexible and rigid lateral boundaries are compared for the plane strain test. The results show that (1) the effect of the membrane on the test result becomes more significant at larger strain level because the membrane applies additional lateral confining pressure to the soil body; (2) the tested models reproduce typical stress and volumetric paths for specimens with shear bands; (3) for the plane strain test, the rigid lateral boundary derives a much higher peak strength and larger bulk dilatation, but a similar residual strength, compared with the flexible boundary. The latter produces a more uniform (or ‘diffuse') rotation field and more mobilised local kinematics than does the former. All simulations show that the proposed FDM-DEM coupling method is able to simulate laboratory tests with a flexible boundary membrane.     

Geostatistical features of streambed vertical hydraulic conductivities in Frenchman Creek Watershed in Western Nebraska

This study evaluated the spatial variability of streambed vertical hydraulic conductivity (K_v) in different stream morphologies in the Frenchman Creek Watershed, Western Nebraska, using different variogram models. Streambed K_v values were determined in situ using permeameter tests at 10 sites in Frenchman, Stinking Water and Spring Creeks during the dry season at baseflow conditions. Measurements were taken both in straight and meandering stream channels during a 5 day period at similar flow conditions. Each test site comprised of at least three transects and each transect comprised of at least three K_v measurements. Linear, Gaussian, exponential and spherical variogram models were used with Kriging gridding method for the 10 sites. As a goodness-of-fit statistic for the variogram models, cross-validation results showed differences in the median absolute deviation and the standard deviation of the cross-validation residuals. Results show that using the geometric means of the 10 sites for gridding performs better than using either all the K_v values from the 93 permeameter tests or 10 K_v values from the middle transects and centre permeameters. Incorporating both the spatial variability and the uncertainty involved in the measurement at a reach segment can yield more accurate grid results that can be useful in calibrating K_v at watershed or sub-watershed scales in distributed hydrological models.     

抽油机悬点投影测量仪

油田抽油机的抽油杆幌动幅度过大，是引起抽油杆断裂的一个重要因素，检测这种幌动幅度是防止抽油杆断裂的一种有效手段。设计了一种基于面阵CCD和普通半导体激光器（LD）测量这种幌动的悬点投影测量方法，通过数字卷积滤波，达到了范围为0－40mm，误差＜0.2mm的技术检测指标。     

The Latest Research Progress on El Nino

Cold water in the deep Pacific can be drawn up to the surface (or west warm water drifts eastwards ) because strong tide increases the mixing of seawater both in vertical and horizontal. In this way greenhouse effect is decreased or increased by means of absorbing (or releasing) CO2. Therefore, La Nina cold event (or El Nino warm event) may occur,which is caused by wanning - up or cooling - down air above the ocean. Volcanic action at sea bottom is also controlled by strong tide.     

地下洞库勘察中的深斜孔钻探和压水试验技术

青岛市黄岛区拟建设海底地下油气储藏库,前期地质勘察工作要求施工倾角45°、深220m的取心钻孔4个,并在孔内分段进行压水试验.本文介绍了如何利用XY-4型金刚石小口径钻机施工基岩深斜孔及压水试验技术.     

变形分析的Bayes估计与检验

由于观测条件的变化，观测值方差将产生随机波动。本文根据Ｂａｙｅｓ估计理论，推导了线性模型待估参数的分布函数及观测值方差估计公式，并将其用于位移检验。计算结果表明，在同样的置信度下，本方法更符合实际。文中还对参数估值的统计性质进行了讨论。     

塔中4号油藏渗透率分布的非均质性及渗流方向研究

研究油藏内部油水渗流方向时,主要考虑渗透率影响,引入两个水平方向渗透率比、水平与垂向渗透率比参数来分析。前者反映样品所在储层平面上两个水平方向渗流能力的差异,后者反映样品所在储层水平与垂向渗流能力的差异,并经小柱样测试和全岩心测试两种方法确定两个参数。通过对塔中4号油藏CⅠ油组9口井2306个样品两种渗透率比值分布直方图分析,研究了CⅠ油组渗透率的非均质性及其渗流方向:CI油组储层在水平方向的渗流能力有很大差异,具有明显的方向性。储层垂向渗流能力明显小于水平方向的渗流能力。     

小杂鱼脱脂技术的研究

以小杂鱼或低值鱼为原料 ,采用常温溶剂萃取法进行脱脂 ,研究了不同溶剂、溶剂混合比、流速和萃取时间对鱼类脱脂的影响。结果表明 ,在常温下用等体积的异丙醇和乙酸乙酯混合溶剂 ,以流速 4～ 8mL/min连续萃取 4～ 6h ,脱脂鱼肉的脂肪平均含量w为 0 .19%,脱脂率高达96 .2 6 %。该方法的溶剂损耗量为加热溶剂萃取法的 1/3倍。     

Predicting ground-motion variations at the Turkey-flat test site,California

Results of a single group participating in an international experiment are analyzed. The experiment served to verify computational predictions of the ground-motion variations due to near-surface geological effects at a site established for that purpose by the California Department of Conservation. Based on an acceleration record at a rock location, and geotechnical model of medium, records at the other locations of a nearby sedimentary deposit were predicted. A 2-D finite-difference sensitivity analysis suggested that the lateral wave-propagation effects are negligibly small, and locally 1-D computations are sufficient for the present site. Those computations are compared with observations not available to the authors during the blind prediction. Peak accelerations, peak velocities and RMS accelerations were predicted with errors less than 159%, 114% and 62%, respectively. Maxima of the response spectra were fitted within a factor of 2. The predicted and observed Husid's plots (i.e., the normalized cumulative plots of the acceleration squared) have the correlation coefficients 0.98. The detected misfits do not show any simple relation to the instrument location, component, frequency, or time.     

Integrated approach for identification of potential groundwater zones in Seethanagaram Mandal of Vizianagaram District,Andhra Pradesh,India

Identifying a good site for groundwater exploration in hard rock terrain is a challenging task. In hard rocks, groundwater occurs in secondary porosity developed due to weathering, fracturing, faulting, etc., which is highly variable within short distance and contributing to near-surface inhomogeneity. In such situations topographic, hydrogeological and geomorphological features provide useful clues for the selection of suitable sites. Initially, based on satellite imagery, topographical, geomorphological and hydrogeological features, an area of about 149 km² was demarcated as a promising zone for groundwater exploration in the hard rock tract of Seethanagaram Mandal, Vizianagaram District, Andhra Pradesh, India. A total of 50 Vertical Electrical Soundings (VES) were carried out using Wenner electrode configuration. An interactive interpretation of the VES data sharpened the information inferred from geomorphological and hydrogeological reconnaissance. Ten sites were recommended for drilling. Drilling with Down-The-Hole Hammer (DTH) was carried out at the recommended sites down to 50 to 70 m depths. The interpreted VES results matched well with the drilled bore well lithologs. The yields of bore wells vary from 900 to 9000 liters per hour (lph).