基于旋翼无人机观测的雾天和霾天VOCs垂直分布特征研究

为研究雾和霾天气下VOCs时空变化特征,于2020年11月19日—2021年1月15日在江苏省东海国家气象观测站进行为期58 d的外场观测试验。利用自主研发的多旋翼无人机捕获2次辐射雾和2次霾天气过程,获得气温、气压、相对湿度、风向、风速、VOCs、O₃等7种要素100多条垂直廓线。结果表明：时间上,霾过程夜间VOCs体积浓度(0.225～0.253 ppm(parts per million, 1 ppm=10^-6))明显高于白天(0.191～0.205 ppm),雾形成前体积浓度(0.121～0.239 ppm)显著高于雾过程(0.056～0.209 ppm)。雾过程中VOCs体积浓度与雾强度变化相反,雾层高度与VOCs体积浓度剧烈变化高度一致,雾层(<200 m)中VOCs体积浓度(0.172～0.178 ppm)明显减小,显著低于雾形成前(0.195～0.240 ppm),雾层以上浓度变化大,雾结束后1 h内保持雾过程中分布特点。雾对逆温层中的水溶性污染物有清除作用,VOCs体积浓度和O₃质量浓度均下降。     

Effect of system variables and particle size on physical characteristics of air sparging plumes

Air was injected through a well in a thin transparent tank filled with saturated glass beads to study how the size and air saturation of air sparging plumes are affected by particle size and gradation; operational parameters such as injection pressure, well depth, injection pressure pulsing; and well outlet configuration. V-shaped air plumes with an apex between 40° and 60° were obtained for all tests. The air pressure required to initiate sparging agreed closely with the sum of the air entry pressure and the hydrostatic pressure, with higher initiation pressures required in the fine and well-graded beads. Higher air flow rates and air saturations were obtained in coarser beads at a given pressure, and the variation in flow rate was consistent with estimated air permeabilities. Peak average air saturations were 28–56% for the coarse-medium beads, 10% for the well-graded beads, and 8% for the fine beads. Air saturation and the radius of influence increased modestly (<40%) as the normalized injection pressure exceeded 0.1. Radius of influence increased by approximately a factor of two as the well depth increased, but leveled off once the ratio of radius of influence to well depth reached 0.60–1.05. Pulsing of injection pressure had no effect on the initiation pressure, air flow rate, or air saturation, but increased the size of the air plume and the radius of influence slightly (<15%). Well outlet configuration had only a slight affect the radius of influence (<10%), air saturation (<10%), or air flow rate (<12%). Dye testing showed that water surrounding the air plume circulated during continuous and pulsed sparging. However, pulsed sparging resulted in greater and more defined circulation of water within and adjacent to the air plume, which should reduce mass transfer limitations during sparging.     

Identification and Apportionment of Sources of Ozone‐forming Potential for Proper Reduction Strategies

In this study, results of source identification and apportionment for ambient volatile organic compounds (VOCs) from a previous work were used to estimate ozone‐forming potentials (OFPs) of effective sources for developing proper strategies for reduction of tropospheric ozone pollution. The source identification and apportionment of ambient VOC pollution within Yildiz Technical University's Davutpasa Campus (Istanbul, Turkey) was done by positive matrix factorization (PMF). The results suggested five effective source groups with the emissions related with paint use and solvent use having the highest contributions (36.8 and 28.2%). The results from PMF were used along with maximum incremental reactivities to estimate potentials of individual sources for ozone formation. It was found that biogenic emissions (3.78) and traffic related emissions (gasoline and diesel vehicle exhaust) (3.83 and 3.15, respectively) have the highest potential for ozone formation in terms of grams O₃/g VOC emitted. The results were used to suggest proper source‐based reduction strategies for OFP.     

地下水VOCs污染修复技术探讨

污染物事故性排放、工矿企业搬迁后遗留的污染场地修复面临各种问题,给地下水资源的使用带来严重威胁。地下水VOCs污染,具有易扩散迁移、毒性高、风险大的特点,修复难度较高。本文结合典型深层地下水修复案例,充分分析场地地质背景、水文地质条件等,根据污染物的特性、污染范围和分布特征,探讨各种修复技术的修复机理、修复对象和技术特点,针对VOCs污染修复进行性能比较及适用性分析。同时通过两个阶段的试验综合研究,原位和异位技术相结合,为开展类似地下水VOCs污染修复实践和管理提供了依据和思路。     

山东地区典型金属罐喷涂企业VOCs排放特征研究

了解涂装行业挥发性有机物（VOCs）的排放特征是制定山东地区臭氧（O₃）和PM_2.5防控策略的重要环节.本研究在山东地区测定了两家典型食品金属包装企业喷涂过程中VOCs的排放组成,企业产品以饮料罐和罐头为主.结果表明：两家企业排放的总VOCs质量浓度水平相当,质量浓度变化范围在50~1 500 μg/m³;但两家企业喷涂过程中VOCs的排放组成具有一定的差异,以生产铝罐和马口铁罐为主的企业中的含氧挥发性有机物（OVOCs）含量最多,占比89.71%（质量分数,下同）;而生产铝罐的企业芳香烃（56.15%）是首要的排放种类,其次是OVOCs （32.32%）.通过分析两家企业内外喷涂工艺的VOCs源成分谱,发现同一企业不同工艺之间有一定差异,多种罐生产企业的内、外喷涂中乙醇占比最高,分别为94.28%、84.46%;单铝罐生产企业的内喷涂2-丁酮（24.33%）是重要组分,外喷涂中甲苯（36.40%）含量较高.     

山东地区三类典型制药企业的VOCs源成分谱及排放特征研究

制药行业因在提取等过程中使用有机溶剂排放大量挥发性有机物（VOCs）而备受关注.本研究在山东省选择化学合成、生物发酵、中药共三家制药企业开展了107种VOCs组分的监测和分析,并建立制药企业的VOCs源成分谱.研究结果表明：化学合成类和生物发酵类制药企业排放总质量浓度均超过20 mg/m³,中药制药企业的样品的平均质量浓度相对较小,为902.66 μg/m³.本研究所分析的107种组分中,以含氧挥发性有机物（OVOCs）为主,三家企业均超过75%,其中,化学合成制药类卤代烃物种的占比较高.企业类型、生产环节、收集排放措施等是影响VOCs成分的重要因素.     

德州市冬季大气挥发性有机物污染特征及其对臭氧和二次有机气溶胶生成的贡献

利用气相色谱-质谱仪/火焰离子检测器（Online-GC-MS/FID）对2017年冬季山东德州大气中99种挥发性有机物（VOCs）进行连续测量,研究了VOCs浓度和组分特征、日变化趋势、来源及其对臭氧（O₃）、二次有机气溶胶（SOA）生成的贡献.结果表明,德州大气VOCs平均体积分数为（47.74±33.11）×10^-9,烷烃占比最大,为40.66%.总VOCs及其组分表现出早晚体积分数高、中午体积分数低的日变化规律.德州大气中丙烷、丙烯、苯及甲苯和二氯甲烷分别受到液化石油气挥发、生物质燃烧、机动车排放和溶剂使用等人为源的影响.反向轨迹模型分析发现,北方内陆气团对德州VOCs体积分数具有一定贡献.烷烃、烯烃、芳香烃的臭氧生成潜势分别为（34.87±33.60）、（120.48±118.76）和（59.77±94.14）μg/m³,乙烯、丙烯、甲苯和间/对二甲苯的贡献较大.芳香烃氧化主导了SOA生成,其贡献率为93.7%,甲苯、间/对二甲苯、苯对SOA生成的贡献最大.为解决大气复合污染问题、实现臭氧和PM_2.5协同控制,德州应重点控制甲苯、间/对二甲苯等芳香烃的排放.     

Biodegradation of CO2, CH4 and volatile organic compounds (VOCs) in soil gas from the Vicano–Cimino hydrothermal system (central Italy)

We investigated the effect of microbial activity on the chemistry of hydrothermal fluids related to the Vicano–Cimino system, central Italy. The database included the composition and δ¹³C CO₂ and δ¹³C CH₄ values for soil gas from an area characterized by intense degassing of fluids having a deep origin. The δ¹³C CH₄ values along vertical profiles in the soil indicated that CH₄ was controlled by microbial oxidation occurring at shallow (< 50 cm) depth, where free O₂ was available. This was consistent with the vertical gradients of CH₄, H₂S and O₂ concentrations. The δ¹³C CO₂ values in soil gas, characterized by a composition similar to that of the hydrothermal fluids, were not significantly influenced by biodegradation. On the contrary, gas strongly affected by air contamination showed a significant δ¹³C CO₂ fractionation. Microbial activity caused strong consumption of hydrothermal alkanes, alkenes, cyclics and hydrogenated halocarbons, whereas benzene was recalcitrant. Oxygenated compounds from hydrocarbon degradation consisted of alcohols, with minor aldehydes, ketones and carboxylic acids. A predominance of alcohols at a high rate of degassing flux, corresponding to a short residence time of hydrothermal gas within the soil, indicated incomplete oxidation. N-bearing compounds were likely produced by humic substances in the soil and/or related to contamination by pesticides, whereas α-pinene traced air entering the soil. The study demonstrates that microbial communities in the soil play an important role for mitigating the release to the atmosphere of C-bearing gases, especially CH₄, through diffuse soil degassing, a mechanism that in central Italy significantly contributes to the discharge of CO₂-rich gas from deep sources.     

挥发性有机污染物标准物质使用的短期稳定性评价

为对挥发性有机物标准物质的短期稳定性进行评价,选取美国ChemService公司生产的LVOC-1RPM(甲醇中54种挥发性有机污染物混合标准物质)和SS-524RPM(甲醇中4-溴氟苯和1,2-二氯苯-d4混合标准物质),将其开封后转移至2 mL带聚四氟乙烯衬盖的棕色螺口样品瓶中再密封,于-18℃避光贮存,采用气相色谱-质谱法测试各组分量值随贮存时间的变化。结果表明,在65 d内,两种标准物质各组分量值测量的标准偏差在12～60 mg/L范围内,最大相对标准偏差为2.97%(n=5),测量结果的相对不确定度小于5.39%。在置信度为95%时,χ2-检验和不确定度评定结果表明,评价方法满足标准物质稳定性检验的精密度和准确度要求;标准物质各组分量值在(2000±128)mg/L范围内时,测量的偏差不显著。在不超过标准物质的有效期内,开封后再密封的LVOC-1RPM标准物质至多可保存65 d,而SS-524RPM标准物质至少可保存65 d。