Design of shallow foundations under tensile loading for transmission line towers: An overview

Tensioned foundations are common in civil engineering applications such as transmission towers, harbors, offshore structures, basement slabs under pressure, industrial equipment, etc. Procedures for the design of tensioned foundations are discussed in this paper, including specific recommendations for more common transmission tower foundations. Starting from a distinction between shallow and deep modes of failure, the paper presents the most common failure mechanisms for shallow failure in tension, including procedures for calculation of foundation tensile capacity under vertical and inclined loading. Emphasis is given to the influence of the strength of the compacted backfill compared to the strength of the natural soil, including presentation of results of full-scale loading tests.     

Discussion on “Experimental study on fracture toughness and tensile strength of a clay” [Engineering Geology 94 (2007) 64–75]

The paper [Wang, J.-J., Zhu, J.-G., Chiu, C.F., Zhang, H., 2007. Experimental study on fracture toughness and tensile strength of a clay. Engineering Geology 94, 64–75.] focuses on two important fracture parameters of soils: tensile strength and fracture toughness. These parameters control the behaviour of soils in a wide range of situations, from the design of a simple footing to much complicated fracture behaviour of clay liners or covers. The authors have done extensive laboratory work to determine these two parameters and their laborious and complicated experimental program needs praise. However, some of the points raised in their conclusions, based on the analysis and comparison with the data from the literature, need to be discussed.     

Uniaxial compression and tension tests of anthracite and loading rate dependence of peak strength

The mechanical characteristics of coal under uniaxial compressive stress and uniaxial tensile stress are key factors in investigations of the stability of galleries and coal faces, and are vital considerations for the efficient design of coalmines, disaster prevention, and environmental preservation. These mechanical characteristics have long been a topic of research, but remain insufficiently understood. In this study we performed uniaxial compression tests and uniaxial tension tests on coal, with particular attention to two concerns. The first was to measure the loading rate dependence of the peak strength of coal. Coal shows high sample-to-sample scatter in strength; test methods that are successful in comparatively homogeneous rock types cannot be used for coal. We therefore used an alternative test method that was recently developed by the authors. Anthracite samples were subjected to alternating slow and fast strain rates. Measured variations in stress during this process were used to estimate the loading rate dependence of peak strength. The second objective was to obtain complete stress–strain curves for coal under uniaxial tensile stress. It is difficult to hold samples secure during a tensile test; consequently, such curves have yet to be obtained. This study presents a successful application of the authors' method to the analysis of coal samples, yielding a complete stress–strain curve under tensile stress. The two methods presented here hold promise for application not only to anthracite but also to a wide variety of coals. It is possible to derive the values of the constants used in constitutive equations from the obtained experimental results. Once these equations are determined, they can be incorporated into finite-element software to investigate various time-dependent behaviors of coal and aid in the efficient design of coalmines and the prevention of subsidence and mine disasters.     

The role of the 1999 Chamoli earthquake in the formation of ground cracks

The moderate magnitude Chamoli earthquake that occurred in the Garhwal Higher Himalaya, in the early hours of March 29, 1999, caused intense damage to the ground and mountain slopes of the Alaknanda–Mandakini river valley and adjoining region. A systematic survey of this induced damage was conducted immediately after the earthquake occurred. Prominent shallow cracks of significant length, negligible width and indeterminate vertical extent, conspicuously tensile in nature, with little or no slip across the crack planes, were observed in the ground at several places along the surveyed route. These cracks had formed in the dynamic phase of the Chamoli earthquake process that is in the period of time during which the earthquake-generated seismic waves were passing through the geographic region of interest. However, we use the theory of earthquake-induced static (or long time) stress changes to visualize such cracks at some selected sites where ground damage was relatively more intense and varied to suggest lower bound estimates of the dynamic stress contributions of the main shock for their formation.Based on the results of our analysis we conclude that, just prior to the earthquake occurrence, under the influence of the local ambient stress field, the ground at these sites was already near failure in tension. To this, in its dynamic phase, the Chamoli earthquake induced stress perturbations, having, across the planes of the cracks, (i) shear components which were nearly equal and opposite to similar components of the ambient stress field and (ii) normal (tensile) components, necessary for triggering tensile failure of the ground. The σ₃ (or minimum principal stress) component of the resultant perturbed failure stress field thus became sufficiently tensile while the transverse stresses became sufficiently insignificant. This facilitated formation of major tensile cracks in the ground there. Our static estimates of the tensile stress changes at the different sites are, in essence, estimates of the minimal triggering stress perturbations that was provided by the Chamoli earthquake in the dynamic state for the formation of the tensile cracks there.     

基于吸力量测确定膨胀土活动带和裂隙深度

采用M itchell公式和裂隙扩展深度方程两种吸力法确定安康地区膨胀土大气影响深度和裂隙开展深度。其一通过对安康地区两处天然边坡开挖观测井,利用张力计进行不同深度处吸力值的现场量测,根据M itchell提出公式计算大气影响深度;其二根据非饱和土抗拉强度公式,建立膨胀土裂隙扩展深度方程,利用基质吸力量测结果求其理论解。结果表明,安康地区膨胀土吸力变化曲线随深度增加变幅减小,呈波浪式推移。M itchell公式确定安康地区膨胀土的大气影响深度为3.35m以内,裂隙深度方程确定裂隙开展深度为3.063.14m。利用M itchell公式计算大气影响深度与膨胀土断裂理论公式确定的裂隙开展深度结果接近。     

The rate of bedrock weathering by frost action: Field measurements and a predictive model

Shattering rate, surface temperature, moisture content, and the physical and strength properties of bedrock were measured in four rockwall sites of the Japanese Alps. Five-year observations revealed that the bedrock shattering rate was usually much higher in the freeze-thaw period from October to next May than in the frost-free period from June to September. This indicates that frost action is the most important shattering process, although unusual heavy rainstorms in summer are also responsible for the shattering. A combination of some empirical relationships derived from recent laboratory experiments leads to a predictive model of the frost shattering rate. This model shows that the annual shattering rate is dependent on the annual freeze-thaw frequency on the rock surface, and the degree of saturation and tensile strength of the rock masses. The coefficients involved in the model were determined using the field data.     

Icequakes and glacier motion: The hans glacier,spitsbergen

The recording of glacier icequakes has been carried out on the Hans glacier, Spitsbergen. The icequakes have been connected with the formation of open cracks. The energy of the main group of icequakes has ranged from 0.01 J to 6 J, their seismic moment being from 0.5 · 10¹⁴ dyne · cm to 26 · 10¹⁴ dyne · cm. The nonelastic volume increase corresponding to each crack has ranged from 0.2 · 10⁻² m³ to 8.8 · 10⁻² m³. The stresses released due to extensional faulting ranged from 25N/m² to 500 N/m²; these values are so small that they suggest an incomplete release of the medium. The contribution into the glacier flow rate of the deformation in the surface glacier layer due to extensional faulting is lower by 2 to 3 orders of magnitude than the total plastic deformation associated with the ice creeping.     

Collapse of caves at shallow depth in Gaziantep city center,Turkey: a case study

This paper focuses on an investigation of the possible causes for the collapse of limestone caves in Gaziantep, Turkey. The city contains a lot of man-made caves, at a shallow depth, of various width and length. These caves were mainly excavated to provide work or storage space. As the city has been growing fast with increased population, many structures were constructed over these caves. Recently, two caves collapsed and five houses were damaged. These caves are all made of limestone and it was observed after the collapse that the limestone was saturated with water due to sewer pipe leakage and surface water. Tests were carried out on the limestone and it was determined that the compressive strength of limestone decreases by about 50% and the tensile strength decreased by about 80% when saturated with water. It was concluded that the reduced strength of the limestone combined with additional loads due to the factors mentioned above seem to be the main reason for these collapses.     

论中国东部大型盆地区及邻区地质-地球物理复合尺度解析

作为对中国东部陆缘地带大型盆地区及邻区地质－地球物理综合研究的部分结果,本文的基本认识：（1）穿过松辽盆地的1孙吴－双辽断裂可能是东倾伯低角度壳内断裂;（2）松辽盆地和渤海湾盆地可能属于“混合型裂谷盆地”;（3）东海盆地台北坳陷处在多期次张性应力场环境中,使在其西部附近产生张性正断层系;（4）欧亚大陆东部新生代区域构造运动总体处于右旋走滑拉张环境,其动力因素包括板块运动和地幔物质运动;（5）研究区莫霍面具有较为复杂的变化;（6）复合尺度研究方法是地质－地球物理综合分析的必要手段。     

Dynamics of ocean cables with local low-tension regions

A general set of 3-D dynamic field equations for a cable segment is derived based on the classical Euler-Kirchhoff theory of an elastica. The model includes flexural stiffness to remove the potential singularity when cable tension vanishes and can be reduced to the equations for a perfectly flexible cable. A hybrid model and a solution scheme by direct integration are then proposed to solve the oceanic cable/body system with a localized low-tension region. Numerical examples demonstrate the capability and validity of the formulation and the numerical algorithm.