青海省沙柳河南区有色金属矿成矿物质来源及矿床成矿模式探讨

本文简述了沙柳河南区有色金属矿床的基本特征。通过对成矿热液及成矿物质的来源与性质的研究,认为该矿床的成因类型为火山沉积—接触交代改造叠加型,进而探讨了该矿床的成矿模式。     

渤海湾盆地新生界生油岩系底界面温度分布

依据渤海湾盆地2000余口测温井的地温梯度数据、地层岩性描述、分层数据以及钻井资料,计算了该盆地各生油岩系底界面的温度。统计结果表明:渤海湾盆地沙河街组大部分凹陷区地层底界面温度介于90℃至150℃,目前仍具有大量生油的温度条件,而在隆起或一些凸起地区,该地层组段温度普遍小于90℃,未能达到生油的温度指标。东营组和孔店组地层也仍具有一定的生油温度条件。研究还表明:地层温度与地层界面埋深密切相关,温度随界面埋深的增大而升高,沉积厚度大的凹陷区地层界面温度大于沉积厚度小的凸起区或斜坡地带,说明地层界面埋深是决定地温高低的主要控制因素,而地温梯度对地层界面温度的影响相对较小。     

Ground motion estimation during the Kashmir earthquake of 8th October 2005

In this article, analytical methods have been used to estimate ground motion during the 8 October 2005, Kashmir earthquake. Peak ground acceleration (PGA) values at several stations in the epicentral region have been estimated by empirical analytical source mechanism models. As an alternate analysis, PGA estimates have also been obtained using the stochastic finite fault seismological model. The estimated PGAs are compared with that obtained from damage values. A PGA contour map in the near-source region is provided. It is found that very near to the epicenter, PGA would have reached more than 1 g. It is demonstrated that empirical analytical models can be effectively used to estimate ground motion due to rupture of active faults.     

冈底斯新近纪钾质火山作用:消减沉积物折返的地球化学与Sr-Nd-Pb同位素证据

在冈底斯岩浆岩带的羊八井地区,林子宗火山岩系上部出现小规模的粗面质火山岩.岩石学与地球化学研究表明粗面岩与时空密切相关的大体积安山质-英安质-流纹质火山岩属于不同的火山岩系:碱性钾质系列与钙碱性系列.详细的地球化学研究证明林子宗晚期小体积钾质岩具有独立的岩浆源区,而非早期钙碱性系统低压岩浆过程演化的产物.粗面质熔岩SiO2含量为62.91%～64.63%,具有高K2O(7.52%～8.05%)、Al2O3(16.64%-17.35%)、低TiO2(0.59%～0.68%)与MsO(0.15%～0.77%).钾质熔岩富集LILE与LREE,亏损HFSE,具有高Rb/Sr(1.1～2.3)、Th/La(0.59～0.80)、Th/U(6.3～10.9)和低Ce/Pb(4.1～6.2)与Ba/Th(4.3～14.5)比值,其同位素组成变化范围分别是87Sr/86Sr(I)=0.7068～0.7075、143Nd/144Nd(I)=0.51241～0.51252、206Pb/204Pb=18.87～18.95、207Pb/204Pb=15.63～15.70和208Pb/204Pb=39.24～39.68.粗面岩的地球化学与同位素特征表明冈底斯新近纪钾质火山岩来源于角闪岩相的消减沉积物熔融.因此,羊八井新近纪钾质火山熔岩提供了印度-亚洲大陆碰撞早期消减沉积物折返的证据.     

地震折射波的虚拟射线理论及其应用

本文提出了一种地震折射液的虚拟射线理论,根据该理论,只要已知地表层的速度,即可直接由折射波信息提取地震参数,从而可实现折射界面的反演。 文中通过实际介质模型的计算机实验结果,验证了该理论的正确性。     

Internal generation of waves: Delta source function method and source term addition method

In this study, we investigate two internal wave generation methods in numerical modeling of time-dependent equations for water wave propagation, i.e., delta source function method and source term addition method, the latter of which has been called the line source method in literatures. We derive delta source functions for the Boussinesq-type equations and extended mild-slope equations. By applying the fractional step splitting method, we show that the delta source function method is equivalent to the source term addition method employing the energy velocity. This suggests that the energy velocity should be used rather than the phase velocity for the transport of incident wave energy in the source term addition method. Finally, the performance of the delta source function method is verified by accurately generating nonlinear cnoidal waves as well as linear waves for horizontally one-dimensional cases.     

Generation of random waves in time-dependent extended mild-slope equations using a source function method

We develop techniques of numerical wave generation in the time-dependent extended mild-slope equations of Suh et al. [1997. Time-dependent equations for wave propagation on rapidly varying topography. Coastal Engineering 32, 91–117] and Lee et al. [2003. Extended mild-slope equation for random waves. Coastal Engineering 48, 277–287] for random waves using a source function method. Numerical results for both regular and irregular waves in one and two horizontal dimensions show that the wave heights and the frequency spectra are properly reproduced. The waves that pass through the wave generation region do not cause any numerical disturbances, showing usefulness of the source function method in avoiding re-reflection problems at the offshore boundary.     

High parallelization efficiency in barotropic-mode computation of ocean models based on multi-grid boundary ghost area

In general, barotropic-mode computation requires the largest communication time in ocean models because of its iterative nature, when parallel computation is performed based on regional partitioning. In this study, reduction in the overhead time included in the communication in the parallel computation of the barotropic mode is considered to achieve a high parallelization efficiency of ocean models. We verify that the reduction in the communication frequency based on the multi-grid boundary ghost area reduces the total communication time. We find that this is because the sum of several kinds of overhead time for communication occupies a fairly large part of the total communication time. We discuss the trade-off between the decrease in communication time and the increase in computation time due to increased boundary area in such cases, leading to a determination of a suitable width of the multi-grid boundary that minimizes the total required time. We also discuss the efficiencies of the one- and two-dimensional partitioning of the model domain, when a multi-grid boundary is used. In general, two-dimensional partitioning is more efficient than one-dimensional for large partitioning numbers.     

提高管线探测水平分辨率的技术方法

在平顶山矿工路路面改造工程中,使用GX-2型及RD-4000型地下管线探测仪探测地下管网布设情况。根据地下管线种类、管线布设方位、埋置深度、探测难度大小进行了多次试验,在此基础上确定了电磁探测技术与方法：利用直连法提高被测管线中的交变电流,压制邻近平行管线和地下介质中的异常反映;在多管并存、且间距较小的情况下,应选择“梯度法”对磁场水平分量垂直梯度ΔHx进行观测,以得到最大清晰异常;另外,还应根据具体情况,合理选择诸如压制旁侧管线法、选择发射法、偏移感应法、动源发射法等发射方式,保证目标管线中有较强异常呈现。在管线密集区,应尽可能地降低工作频率,以减小旁侧管线中产生的二次电流及二次磁场;为防止信噪比下降,可适当减小收发距,以提高接收机的灵敏度。